NACOL 12 - 99

Remove from exposure, lie down. If breathing is irregular or stopped, administer artificial respiration. Monitor breathing, give oxygen if necessary. Consult a physician.

Wash off with plenty of water.

Rinse thoroughly with plenty of water for at least 15 minutes and consult a physician.

Consult a physician. Do not induce vomiting without medical advice. Never give anything by mouth to an unconscious person.

Water spray, Dry powder, Foam, Carbon dioxide (CO2)

Dangerous gases or fumes may occur in case of fire.

In the event of transport accidents, request support from the nearest TUIS centre.

Avoid subsoil penetration. Do not flush into surface water or sanitary sewer system.

Soak up with inert absorbent material

Materials: inert absorbent material (e.g. sand, silica gel, acid binder, universal binder, sawdust)

Wear personal protective equipment.

No special storage conditions required. Protect from frost, heat and sunlight.

No special protective measures against fire required.

Provide sufficient air exchange and/or exhaust in work rooms.

The choice of an appropriate glove does not only depend on its material but also on other quality features and is different from one producer to the other., Please observe the instructions regarding permeability and breakthrough time which are provided by the supplier of the gloves. Also take into consideration the specific local conditions under which the product is used, such as the danger of cuts, abrasion, and the contact time., Be aware that in daily use the durability of a chemical resistant protective glove can be notably shorter than the break through time measured according to EN 374, due to the numerous outside influences (e.g. temperature). gloves suitable for permanent contact: Material: Nitrile rubber/nitrile latex, Break through time: >= 480 min, Layer thickness: 0.35 mm Material: butyl-rubber, Break through time: >= 480 min, Layer thickness: 0.5 mm unsuitable gloves Material: Natural rubber/natural latex

Tightly fitting safety goggles

No personal respiratory protective equipment normally required. In inadequately ventilated areas, where workplace limits are exceeded, where unpleasant odours exist or where aerosols are in use, or smoke and mist occur, use self-contained breathing apparatus or breathing apparatus with a type A filter or appropriate combined filter (e.g. where aerosols are in use, or smoke and mist occur, A-P2 or ABEK-P2), in compliance with EN 141.

Protective suit

Avoid subsoil penetration. Do not flush into surface water or sanitary sewer system.

No decomposition if stored and applied as directed.

Stable at normal ambient temperature and pressure.

Hazardous decomposition products formed under fire conditions.

Direct heating, dirt, chemical contamination, sunlight, UV or ionising radiation.

No data available;

No decomposition if stored and applied as directed.