ANEX WF 5095

Whilst protecting yourself remove the casualty from the hazardous area and take him to fresh air and keep at rest. If the person is unconscious, place him/her in side position suitable for transportation. If breathing is interrupted, give artificial respiration. Appropriate precautions must be taken for the person who helps

Whilst protecting yourself, relocate the casualty away from the source of danger. Remove contaminated clothing. Immediately clean the affected skin areas under running water. Arrange medical treatment.

Remove lense sif present, Wash, eyelids, open thoroughly and immediately with plenty of water for at least 20 minutes, Consult a doctor immediately

Gargle with warm water and drink as much water as possible. Consult a doctor immediately. Do not induce vomiting if it is not clearly allowed by the doctor.

Foam, CO2, dry chemicals

Never use a direct water jet on burning material

Possible increase in pressure in closed cups due to heat, Heating may cause explosion, The fire produces intense black smoke.

If exposed to fire keep the vessel cool by spraying water.

Empty the area upon accidental release of this material.

Avoid media discharge. Stop the leak as soon as possible. Clean the spill immediately.

Collect in closed containers to dispose of

Comply with health and safety precautions as prescribed by work practices. Keep the vessel tightly closed. Keep away from heat, sparks and sources of open flame. Always keep in containers made from the same material as the original material. Do not eat, drink or smoke in the application area. Avoid eye and skin contact. Avoid breathing spray particles from the application.

Observe the precautions in the label. Block unauthorized access. The opened containers must be carefully closed again and held upright to prevent leakage. Only use containers, pipes, gaskets, etc. made of materials suitable for use with organic solvents. Store in a well-ventilated place. Do not expose yourself to direct sunlight. Keep away from heat sources, prevent static buildup, ground. Do not smoke. Keep away from sources of ignition.

Do not eat, drink or smoke in the application area.

Keep away from heat, sparks and sources of open flame. Keep away from heat sources, prevent static buildup, ground. Do not smoke. Keep away from sources of ignition.

Use suitable protective gloves. Additional notes: Properties are based on tests, literature data and glove manufacturers' information, or are obtained from analogous substances by comparison. Due to many conditions (eg temperature) chemical substances it should be noted that the penetration time of the protective glove may be much shorter than the penetration time determined by practical use tests.

Wear chemical safety goggles.

Install a gas mask when the concentration in the air exceeds the standard level.

Wear suitable protective clothing to prevent skin exposure.

Review the Community Environmental Protection Legislation.

Polymerization will not come into play.

Avoid electrostatic charge buildup. Avoid any ignition source.

None.

Carbon monoxide, carbon dioxide, nitrogen oxides