Identification
Product identifiers, regulatory numbers, and supplier information
Product Information
- Product Name
- Aerosol SM 1K Unifill neu S7 schwarz
- Product Form
- Aerosol
- Product Code
- REZ732
Regulatory Identifiers
- CAS Number
- N/A
Identified Uses
painting
Manufacturers & Suppliers
Peter Kwasny GmbH
manufacturer
Heilbronner Str. 96, D-74831 Gundelsheim
0049-(0)6269-95-20
Emergency Contacts
Emergency Contact
+49 6269 95 20
National Poisons Information Service, Birmingham
(0) 12 15 07 55 88/9
Hazard Identification
GHS classification, signal word, pictograms, and hazard statements
Hazard Classifications
GHS Pictograms
GHS02
GHS07
Hazard Statements
Precautionary Statements
Get a free compliance audit
Upload your SDS inventory and get a detailed compliance report
Composition / Information on Ingredients
Chemical components, concentration ranges, and hazardous substance identification
First Aid Measures
Emergency procedures for chemical exposure incidents
Supply fresh air; consult doctor in case of complaints.
Immediately wash with water and soap and rinse thoroughly.
Rinse opened eye for several minutes under running water. If symptoms persist, consult a doctor.
If symptoms persist consult doctor.
Firefighting Measures
Extinguishing media, specific hazards, and firefighter protection
CO2, powder or water spray. Fight larger fires with water spray or alcohol resistant foam. Cool container whit water
Water with full jet
Can form explosive gas-air mixtures.
Firefighter Protection
Mouth respiratory protective device.
Accidental Release Measures
Spill cleanup procedures, containment, and environmental protection
Wear protective equipment. Keep unprotected persons away.
Do not allow product to reach sewage system or any water course. Do not allow to enter sewers/ surface or ground water.
Do not flush with water or aqueous cleansing agents
Related Products
Similar products with comparable safety profiles
Aerosol 1K Fill in
---
Aerosol 2K Fill In + 100ml Lack 2K BHS CAT BLACK
---
Aerosol 1K Fill-in befüllt mit 200 ml Imron Fleet Line Industry NC Topcoat
---
Aerosol 2K Fill in Serie N
---
Aerosol 2K Fill In + 100ml Lack 2K Epoxy Primer black (SPR64607)
---
Aerosol 2K Fill In for 100ml
---
Aerosol 2K Fill In for 100ml
---
Aerosol 1K Fill-in befüllt mit 200 ml Lack Govaere Brugge
---
Handling and Storage
Safe handling precautions, storage conditions, and workplace requirements
Keep away from heat and direct sunlight. Ensure good ventilation/exhaustion at the workplace. Take note of emission threshold. Use only in well ventilated areas. Ensure good interior ventilation, especially at floor level. (Fumes are heavier than air).
Store in a cool location. Observe official regulations on storing packagings with pressurised containers. Protect from heat and direct sunlight.
Do not spray onto a naked flame or any incandescent material. Keep ignition sources away - Do not smoke. Protect from heat.
Exposure Controls / PPE
Occupational exposure limits, engineering controls, and protective equipment
The glove material has to be impermeable and resistant to the product/ the substance/ the preparation. Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation. Material of gloves: Nitrile rubber, NBR. Penetration time of glove material: Gloves must be changed after every contamination. The exact break trough time has to be found out by the manufacturer of the protective gloves and has to be observed. For the permanent contact of a maximum of 15 minutes gloves made of the following materials are suitable: butyl rubber, 0,7mm
Tightly sealed goggles
When workers are facing concentrations above the exposure limit they must use appropriate certified respirators. Half mask with combination filter, class A1P2 minimum, or breathing mask with outer air supply.
Physical and Chemical Properties
Appearance, physical state, melting point, boiling point, and material characteristics
Stability and Reactivity
Chemical stability, hazardous reactions, and incompatible materials
Reacts with acids, alkalis and oxidising agents.
No further relevant information available.
No further relevant information available.
Possible in traces.
Ecological Information
Environmental toxicity, biodegradation, and bioaccumulation data
The data for this section has not been processed yet.
Disposal Considerations
Waste treatment methods, disposal recommendations, and waste codes
The data for this section has not been processed yet.
Transport Information
UN numbers, shipping names, transport classes, and regulatory requirements
- UN Number
- 1950
- Shipping Name
- AEROSOLS
- Transport Class
- 2.1
Regulatory Information
Chemical regulations, safety assessments, and compliance status
The data for this section has not been processed yet.
Frequently Asked Questions
Common questions about safety, handling, and properties
What is the hazard signal word for Aerosol SM 1K Unifill neu S7 schwarz?
The signal word is danger.
What is the physical form of Aerosol SM 1K Unifill neu S7 schwarz?
Aerosol SM 1K Unifill neu S7 schwarz is a aerosol with according to product specification color. It has characteristic odor.
What is Aerosol SM 1K Unifill neu S7 schwarz used for?
painting
What are the hazard statements for Aerosol SM 1K Unifill neu S7 schwarz?
This substance has 2 hazard statements:
- H222: Extremely flammable aerosol. Pressurised container: May burst if heated.
- H319: Causes serious eye irritation.
What is the melting point of Aerosol SM 1K Unifill neu S7 schwarz?
The melting point is Undetermined. and the boiling point is Not applicable, as aerosol..