BSE 32 OIL

Remove from further exposure and remove the source of contamination. Move the victim to fresh air and ensure airways are clear. If oil mist is inhaled, remove to fresh air and seek medical attention.

Symptoms: respiratory irritation, nausea, or unconsciousness

Remove any contaminated clothing. Wash exposed skin and contact areas with soap and water gently. If product gets under the skin seek immediate medical attention from a physician.

Symptoms: Prolonged exposure may irritate the skin.

Wash thoroughly with clean water if contact with the eye occurs.

Symptoms: irritation and soreness

Immediately wash out mouth with clean water. Do not induce vomiting.

carbon dioxide, foam, or dry chemical to extinguish flames. Water fog may be used to cool exposed containers.

DO NOT use water jet.

Burning product or fluid may evolve irritating/noxious fumes.

Evacuate area as soon as possible. Water spray may be used to cool fire exposed surfaces and protect personnel.

Stop source of leak or spill if you can do so without risk.

use inert absorbent material (eg. sand, sawdust or diatomaceous earth) to soak up the spilled product.

dike the spill area for containment and recovery if possible. Place inert absorbent material onto the spillage.

Prevent spill entering drains, waterways, sewers, rivers, basements etc.

Place inert absorbent material onto the spillage.

Materials: inert absorbent material (eg. sand, sawdust or diatomaceous earth)

Do not take internally. Avoid contact with skin, eyes and clothing. Upon contact with skin, wash with sufficient amounts of water and soap. Flush eyes with water for 15 minutes and seek medical attention. Wash contaminated clothing or dispose appropriately. Repeated or prolonged contact with this material should be avoided in order to reduce the possibility of skin disorders. Misuse of empty containers can be hazardous. Do not cut, weld, heat or drill containers. Residue in the container may ignite if exposed to heat. Do not expose container to open flame or excess heat. Always keep container closed and caps in place.

This product is hydrosopic and storage under dry nitrogen is recommended. Keep container tightly sealed when not in use. Store in a cool, dry, well-ventilated area, out of direct sunlight. Keep away from open flames and other ignition sources.

Observe good personal hygiene.

Keep away from open flames and other ignition sources. Residue in the container may ignite if exposed to heat. Do not expose container to open flame or excess heat.

Use in a well ventilated area. Where vapours or oil mists are generated and exposure standards are exceeded, the use of personal respiratory protection equipment or an adequate exhaust ventilation system is recommended.

Protective gloves is normally not required, but impervious gloves such as nitrile, viton or neoprene is recommended if required. Contact the glove manufacturer for specific advice on glove selection. Inspect and replace worn or damaged gloves.

Goggles or safety glasses with side shields are recommended.

If engineering controls are still inadequate, the use of an approved respirator with organic vapour / particulate filter complying with AS/NZS 1715 (Selection, Use and Maintenance of Respiratory Protective Devises) and AS/NZS 1716 (Respiratory Protective Devices) is recommended. The selection of type of breathing protection should be based on expert advice. Reference should be made to the relevant Australian Standards. In the case of high airborne concentrations, use an approved supplied-air respirator, operated in positive pressure mode.

No skin protection is ordinarily required under normal conditions of use. In accordance with good industrial hygiene practices, precautions should be taken to avoid skin contact. If required, use a chemical resistance apron to avoid contact of material with skin.

Stable under normal conditions of storage and handling

Will not occur

Excessive heat or sources of ignition

oxidizing materials

Material does not decompose at ambient temperatures. Analogous compounds evolve carbon monoxide, carbon dioxide, and other unidentified products and fragments when burned.