3M Graphic Remover System

Remove person to fresh air. If you feel unwell, get medical attention.

Immediately flush skin with large amounts of cold water for at least 15 minutes. DO NOT ATTEMPT TO REMOVE MOLTEN MATERIAL. Cover affected area with a clean dressing. Get immediate medical attention.

Immediately flush eyes with large amounts of water for at least 15 minutes. DO NOT ATTEMPT TO REMOVE MOLTEN MATERIAL. Get immediate medical attention.

Symptoms: Serious irritation to the eyes (significant redness, swelling, pain, tearing, and impaired vision).

Rinse mouth. If you feel unwell, get medical attention.

Use a fire fighting agent suitable for the surrounding fire.

None inherent in this product.

No special protective actions for fire-fighters are anticipated.

Evacuate area. Ventilate the area with fresh air.

For larger spills, cover drains and build dykes to prevent entry into sewer systems or bodies of water. For large spill, or spills in confined spaces, provide mechanical ventilation to disperse or exhaust vapours

Avoid release to the environment.

Collect as much of the spilled material as possible. Place in a closed container approved for transportation by appropriate authorities. Clean up residue with an appropriate solvent selected by a qualified and authorised person.

Materials: bentonite, vermiculite, or commercially available inorganic absorbent material

Avoid skin contact with hot material. For industrial/occupational use only. Not for consumer sale or use. Do not handle until all safety precautions have been read and understood. Avoid breathing dust/fume/gas/mist/vapours/spray. Do not get in eyes, on skin, or on clothing. Do not eat, drink or smoke when using this product. Wash thoroughly after handling. Avoid release to the environment. Avoid contact with oxidising agents (eg. chlorine, chromic acid etc.) Use personal protective equipment (eg. gloves, respirators...) as required.

Store away from acids. Store away from strong bases. Store away from oxidising agents.

Do not eat, drink or smoke when using this product. Wash thoroughly after handling.

No engineering controls required.

Select and use gloves and/or protective clothing approved to relevant local standards to prevent skin contact based on the results of an exposure assessment. Selection should be based on use factors such as exposure levels, concentration of the substance or mixture, frequency and duration, physical challenges such as temperature extremes, and other use conditions. Consult with your glove and/or protective clothing manufacturer for selection of appropriate compatible gloves/protective clothing. No chemical protective gloves are required. Note: Nitrile gloves may be worn over polymer laminate gloves to improve dexterity. Gloves made from the following material(s) are recommended: Butyl rubber (0.5 mm thickness, =>8 hours breakthrough time), Polymer laminate (>0.30 mm thickness, =>8 hours breakthrough time). Use gloves tested to EN 374

Select and use eye/face protection to prevent contact based on the results of an exposure assessment. The following eye/face protection(s) are recommended: Indirect vented goggles. Use eye protection conforming to EN 166

An exposure assessment may be needed to decide if a respirator is required. If a respirator is needed, use respirators as part of a full respiratory protection program. Based on the results of the exposure assessment, select from the following respirator type(s) to reduce inhalation exposure: Half facepiece or full facepiece supplied-air respirator. For questions about suitability for a specific application, consult with your respirator manufacturer. Use a respirator conforming to EN 140 or EN 136

Select and use gloves and/or protective clothing approved to relevant local standards to prevent skin contact based on the results of an exposure assessment.

Stable.

This material may be reactive with certain agents under certain conditions - see the remaining headings in this section

Hazardous polymerisation will not occur.

None known.

Strong acids. Strong bases. Strong oxidising agents.

None known.