3M Surface Preparation System

Remove person to fresh air. If you feel unwell, get medical attention.

Immediately flush skin with large amounts of cold water for at least 15 minutes. DO NOT ATTEMPT TO REMOVE MOLTEN MATERIAL. Cover affected area with a clean dressing. Get immediate medical attention.

Immediately flush eyes with large amounts of water for at least 15 minutes. DO NOT ATTEMPT TO REMOVE MOLTEN MATERIAL. Get immediate medical attention.

Do not induce vomiting. Get immediate medical attention.

Use a fire fighting agent suitable for flammable liquids such as dry chemical or carbon dioxide to extinguish.

Water may not effectively extinguish fire

Closed containers exposed to heat from fire may build pressure and explode.

Water should be used to keep fire-exposed containers and surfaces cool and prevent explosive rupture.

Evacuate area. Eliminate all ignition sources if safe to do so. Keep away from heat/sparks/open flames/hot surfaces. - No smoking.

For large spill, or spills in confined spaces, provide mechanical ventilation to disperse or exhaust vapours, in accordance with good industrial hygiene practice.

Avoid release to the environment.

Collect as much of the spilled material as possible using non-sparking tools. Place in a metal container approved for transportation by appropriate authorities. Clean up residue with an appropriate solvent selected by a qualified and authorised person. Ventilate the area with fresh air. Seal the container.

Materials: non-sparking tools, metal container, appropriate solvent

Avoid skin contact with hot material. For industrial/occupational use only. Not for consumer sale or use. Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Use only non-sparking tools. Take precautionary measures against static discharge. Avoid breathing dust/fume/gas/mist/vapours/spray. Do not get in eyes, on skin, or on clothing. Do not eat, drink or smoke when using this product. Wash thoroughly after handling. Avoid release to the environment. Avoid contact with oxidising agents (eg. chlorine, chromic acid etc.) Wear low static or properly grounded shoes.

Store in a well-ventilated place. Keep cool. Keep container tightly closed. Store away from heat.

Do not eat, drink or smoke when using this product. Wash thoroughly after handling.

Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Use only non-sparking tools. Take precautionary measures against static discharge. Ground/bond container and receiving equipment if there is potential for static electricity accumulation during transfer.

Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below relevant Exposure Limits and/or control dust/fume/gas/mist/vapours/spray. If ventilation is not adequate, use respiratory protection equipment. Use explosion-proof ventilation equipment.

Select and use gloves and/or protective clothing approved to relevant local standards to prevent skin contact based on the results of an exposure assessment. Selection should be based on use factors such as exposure levels, concentration of the substance or mixture, frequency and duration, physical challenges such as temperature extremes, and other use conditions. Consult with your glove and/or protective clothing manufacturer for selection of appropriate compatible gloves/protective clothing. Note: Nitrile gloves may be worn over polymer laminate gloves to improve dexterity. Gloves made from the following material(s) are recommended: Polymer laminate. Use gloves tested to EN 374.

Full face shield. Indirect vented goggles. Use eye protection conforming to EN 166

Half facepiece or full facepiece air-purifying respirator suitable for organic vapours. Use a respirator conforming to EN 140 or EN 136: filter type A

Select and use gloves and/or protective clothing approved to relevant local standards to prevent skin contact based on the results of an exposure assessment.

Stable.

This material is considered to be non reactive under normal use conditions

Hazardous polymerisation will not occur.

Sparks and/or flames. Heat.

Strong oxidising agents.

None known. Refer to section 5.2 for hazardous decomposition products during combustion.