Silicone Sealant – Acetoxy Cure – Clear, White & Colors

If symptoms are experienced remove source of contamination or move victim to fresh air. If irritation persists, obtain medical advice.

Symptoms: May cause nose, throat & respiratory tract irritation.

No health effects expected. If irritation does occur, flush with lukewarm, gently flowing water for 5 minutes. If irritation persists, obtain medical advice.

Symptoms: Causes skin irritation.

Immediately flush the contaminated eye(s) with lukewarm, gently flowing water for 5 minutes while holding the eyelid(s) open. Obtain medical attention.

Symptoms: Direct contact with eyes may cause temporary irritation.

Rinse mouth thoroughly with water. If irritation or discomfort occurs, obtain medical advice.

Use extinguishing measures that are appropriate to local circumstances and the surrounding environment. Small Fire: Use carbon dioxide (CO2), dry chemical or water spray. Large Fire: Use dry chemical, foam or water spray.

Not determined.

Not determined.

Determine the need to evacuate or isolate the area according to your local emergency plan. Use water spray to keep fire exposed containers cool.

Observe all personal protection equipment recommendations described in Sections 5 & 8.

See Section 12 for additional ecological information.

Wipe up or scrape up & contain for salvage or disposal. Clean area as appropriate since spilled materials, even in small quantities, may present a slip hazard. Final cleaning may require use of steam, solvents or detergents.

Handle in accordance with good industrial hygiene and safety practice. Wash face, hands, and any exposed skin thoroughly after handling. Use personal protection recommended in Section 8. Use only in well-ventilated areas. Avoid contact with skin and eyes. Product evolves acetic acid (HOAc) when exposed to water or humid air.

Keep container closed & store away from water or moisture.

Wash face, hands, and any exposed skin thoroughly after handling.

Ventilation must be adequate to maintain the ambient workplace atmosphere below the exposure limit(s) outlined in the SDS. Good general ventilation should be sufficient.

Safety glasses as a minimum for protection.

No special equipment needed.

Wear suitable protective clothing.

Stable under recommended storage conditions.

Not reactive under normal conditions

None under normal processing. Hazardous polymerization does not occur.

Incompatible Materials.

Oxidizing material can cause a reaction. Water, moisture or humid air can cause hazardous vapors to form as described in Section 8.

Thermal breakdown of this product during fire or very high heat conditions may evolve the following decomposition products: Carbon oxides & traces of incompletely burned carbon compounds. Silicon dioxide. Formaldehyde, Nitrogen oxides & metal oxides.