Calibrators

If product is inhaled, move exposed individual to fresh air. If individual is not breathing, begin artificial respiration immediately and obtain medical attention.

In case of skin contact, remove any contaminated clothing. Wash affected area with plenty of soap and water for at least 15 minutes. If pain or irritation occur, obtain medical attention.

If product enters eyes, wash eyes gently under running water for 15 minutes or longer, making sure that the eyelids are held open. If pain or irritation occur, obtain medical attention.

If ingested, wash mouth out with water. If irritation or discomfort occurs, seek medical attention.

In case of fire use carbon dioxide (CO2), dry chemical, water spray or foam. For large fires use extinguishing media suitable for surrounding fire.

No special hazards determined.

Observe general safety guidelines for protection during clean up procedures.

Contain spill to prevent migration.

treat spilled material with a 1:10 bleach/water solution. Absorb liquid and place in container suitable for disposal. Avoid generation of aerosols during clean up.

Materials: 1:10 bleach/water solution

This product should be handled as though capable of transmitting infectious diseases. Universal precautions should be followed when using this product.

Store at 2 to 8°C, as directed on the product label. To maintain product quality, store according to the instructions in the product labeling.

No special engineering controls are required. Use with good general ventilation.

Impervious gloves, such as Nitrile or equivalent, should be worn to prevent skin contact. Refer U.S. OSHA 29 CFR 1910.138, European Standard EN374 or appropriate government standards.

Safety glasses or chemical goggles should be worn to prevent eye contact. Refer U.S. OSHA 29 CFR 1910.133, European Standard EN166 or appropriate government standards.

Under normal conditions, the use of this product should not require respiratory protection.

The product is stable in accordance with recommended storage conditions.

No further relevant information available.

Sodium azide forms explosive compounds with heavy metals. Repeated contact of low concentrations of azide with lead and copper commonly found in plumbing drains may result in the build up of shock sensitive compounds.

Avoid contact with incompatible materials. Avoid exposure to heat and direct sunlight.

Metals and metallic compounds

No decomposition products posing significant hazards would be expected from this product (an aqueous solution).