LOCTITE SI 5399 RD

Move to fresh air. If symptoms persist, seek medical advice.

Rinse with running water and soap. Obtain medical attention if irritation persists.

Symptoms: Redness, inflammation.

Rinse immediately with plenty of running water (for 10 minutes), seek medical attention from a specialist.

Symptoms: Irritation, conjunctivitis.

Rinse mouth, drink 1-2 glasses of water, do not induce vomiting, consult a doctor.

Carbon dioxide, foam, powder

High pressure waterjet

In the event of a fire, carbon monoxide (CO), carbon dioxide (CO2) and nitrogen oxides (NOx) can be released.

In case of fire, keep containers cool with water spray.

Avoid contact with skin and eyes.

wipe up with paper towel and place in container for disposal.

absorb onto inert absorbent material and place in sealed container for disposal.

Do not empty into drains / surface water / ground water.

wipe up with paper towel (small spills); absorb onto inert absorbent material (large spills)

Vapours should be extracted to avoid inhalation. Ensure that workrooms are adequately ventilated. Avoid skin and eye contact. See advice in section 8

Store in a cool, well-ventilated place. Keep container tightly sealed.

Good industrial hygiene practices should be observed. Do not eat, drink or smoke while working. Wash hands before work breaks and after finishing work.

Ensure good ventilation/extraction.

Chemical-resistant protective gloves (EN 374). Suitable materials for short-term contact or splashes (recommended: at least protection index 2, corresponding to > 30 minutes permeation time as per EN 374): nitrile rubber (NBR; >= 0.4 mm thickness) Suitable materials for longer, direct contact (recommended: protection index 6, corresponding to > 480 minutes permeation time as per EN 374): nitrile rubber (NBR; >= 0.4 mm thickness) This information is based on literature references and on information provided by glove manufacturers, or is derived by analogy with similar substances. Please note that in practice the working life of chemical-resistant protective gloves may be considerably shorter than the permeation time determined in accordance with EN 374 as a result of the many influencing factors (e.g. temperature). If signs of wear and tear are noticed then the gloves should be replaced.

Safety glasses with sideshields or chemical safety goggles should be worn if there is a risk of splashing. Protective eye equipment should conform to EN166.

Ensure adequate ventilation. An approved mask or respirator fitted with an organic vapour cartridge should be worn if the product is used in a poorly ventilated area Filter type: A (EN 14387)

Wear suitable protective clothing. Protective clothing should conform to EN 14605 for liquid splashes or to EN 13982 for dusts.

Stable under recommended storage conditions.

Strong oxidizing agents.

Polymerises in presence of water.

Stable under normal conditions of storage and use.

Strong oxidizing agents.

Evolves acetic acid during cure. At higher temperatures (>150C) may release formaldehyde (traces).