NextSDS Logo
Safety Data Sheet EN

Divinol Entschaumer OL

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report.

Get Free Audit
01

Identification

Product identifiers, regulatory numbers, and supplier information

Product Information

Product Name
Divinol Entschaumer OL
Product Code
79060

Regulatory Identifiers

CAS Number
N/A

Identified Uses

Defoamer

Manufacturers & Suppliers

Zeller+Gmelin GmbH & Co. KG logo

Zeller+Gmelin GmbH & Co. KG

manufacturer

Schlossstr. 20, D-73054 Eislingen

+49 (0) 7161 / 802-0

http://www.zeller-gmelin.de

Emergency Contacts

GBK/Infotrac

(001) 352 323 3500

02

Hazard Identification

GHS classification, signal word, pictograms, and hazard statements

Classified warning

Hazard Classifications

Skin Sens. Cat. 1 H317

GHS Pictograms

GHS07 - Health hazard

GHS07

Hazard Statements

H317 May cause an allergic skin reaction.

Precautionary Statements

P261 Avoid breathing mist/vapours/spray.
P280 Wear protective gloves and eye protection/face protection.
P302 + P352 IF ON SKIN: Wash with plenty of water.
P333 + P313 If skin irritation or rash occurs: Get medical advice/attention.
P362 + P364 Take off contaminated clothing and wash it before reuse.

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report

Free Audit
03

Composition / Information on Ingredients

Chemical components, concentration ranges, and hazardous substance identification

Type mixture

Mineral oil-based mixture. Mineral oil with DMSO extract < 3 % as measured by IP 346.

Chemical Name CAS Number Concentration Hazardous
distillates (petroleum), hydrotreated light naphthenic EC: 265-156-6 64742-53-6 10 - 20% Yes
distillates (petroleum), hydrotreated heavy paraffinic EC: 265-157-1 64742-54-7 10 - 20% Yes
white mineral oil (petroleum) EC: 232-455-8 8042-47-5 10 - 20% Yes
octene, hydroformylation products, high-boiling EC: 271-237-7 68526-89-6 5 - 10% Yes
distillation residues, by-products from the production of 2-ethyl-1-hexanol EC: 271-832-1 68609-68-7 2.5 - 5% Yes
04

First Aid Measures

Emergency procedures for chemical exposure incidents

Inhalation

Remove casualty to fresh air and keep warm and at rest.

Skin contact

After contact with skin, wash immediately with plenty of water and soap.

Eye contact

After contact with the eyes, rinse with water with the eyelids open for a sufficient length of time, then consult an ophthalmologist immediately.

Ingestion

If swallowed, rinse mouth with water (only if the person is conscious). Let water be drunken in little sips (dilution effect). Call a physician immediately. Do NOT induce vomiting.

05

Firefighting Measures

Extinguishing media, specific hazards, and firefighter protection

Suitable media

alcohol resistant foam, Extinguishing powder, Carbon dioxide (CO2).

Unsuitable media

Full water jet.

Specific hazards

Do not inhale explosion and combustion gases.

Instructions

In case of fire: Wear self-contained breathing apparatus.

Firefighter Protection

Wear self-contained breathing apparatus.

06

Accidental Release Measures

Spill cleanup procedures, containment, and environmental protection

Emergency procedures

Protective measures: see section 7 + 8.

Environmental

Do not allow to enter into surface water or drains. Do not allow to enter into soil/subsoil. Clean contaminated articles and floor according to the environmental legislation.

Cleanup methods

Clean contaminated articles and floor according to the environmental legislation.

Materials: sand, diatomaceous earth, acid- or universal binding agents

Related Products

Similar products with comparable safety profiles

07

Handling and Storage

Safe handling precautions, storage conditions, and workplace requirements

Handling

Use personal protection equipment. Do not eat, drink or smoke when using this product. Provide fresh air. Handle and open container with care. Conditions to avoid: generation/formation of aerosols.

Storage

Keep container tightly closed in a cool, well-ventilated place. Protect against: Frost. Keep away from heat. Protect from direct sunlight.

Hygiene

When using do not eat, drink, smoke, sniff.

Fire prevention

No special measures are necessary.

08

Exposure Controls / PPE

Occupational exposure limits, engineering controls, and protective equipment

Engineering

See section 7. No additional measures necessary.

Hands

Wear suitable gloves. Recommended glove articles: EN ISO 374. Suitable material: NBR (Nitrile rubber). Breakthrough time: > 480 min (Thickness of the glove material: 0.4 mm). Breakthrough times and swelling properties of the material must be taken into consideration. For special purposes, it is recommended to check the resistance to chemicals of the protective gloves mentioned above together with the supplier of these gloves. Barrier creams can help protecting exposed skin areas. In no case should they be used after contact.

Eyes

Eye glasses with side protection (EN ISO 16321).

Respiratory

With correct and proper use, and under normal conditions, breathing protection is not required. When splashes or fine mist form, a permitted breathing apparatus suitable for these purposes must be used. Suitable respiratory protection apparatus: Filtering Half-face mask (EN 149), e.g. FFA P / FFP3.

Skin/Body

Protective clothing.

Environmental

Do not allow to enter into surface water or drains.

09

Physical and Chemical Properties

Appearance, physical state, melting point, boiling point, and material characteristics

Physical State
Liquid
Physical State Data
liquid
State Under Standard Conditions
---
Appearance
---
Colour
yellow
Colour Intensity
---
Form
---
Odor
characteristic
Odor Threshold
---
Ph
not applicable
Melting Point
not determined
Boiling Point
220-350 °C ASTM D 1078
Flash Point
> 100 °C
Freezing Point
---
Softening Point
---
Solidification Point
---
Cloud Point
---
Crystallisation Point
---
Relative Evaporation Rate
---
Evaporation Rate
---
Vapor Pressure
< 0,1 hPa
Vapor Density
---
Relative Density
---
Bulk Density
---
Density
0,89 g/cm³ DIN EN ISO 12185 (at 20 °C)
Flammability
Non-flammable.
Upper Explosive Limit
not determined
Lower Explosive Limit
not determined
Explosive Limits
---
Auto Ignition Temperature
not determined
Decomposition Temperature
not determined
Solubility
---
Partition Coefficient
not determined
Solubility In Water
emulsifiable
Solubility In Fat
---
Molecular Weight
---
Voc Content
---
Metal Corrosion
---
Dynamic Viscosity
90 mPa·s (at 20 °C)
Kinematic Viscosity
> 20,5 mm²/s (at 40 °C)
Properties Status
---
10

Stability and Reactivity

Chemical stability, hazardous reactions, and incompatible materials

Stability

No information available.

Reactivity

No information available.

Hazardous reactions

No hazardous reaction when handled and stored according to provisions.

Avoid

Heat.

Incompatible

No information available.

Decomposition

No information available.

12

Ecological Information

Environmental toxicity, biodegradation, and bioaccumulation data

The data for this section has not been processed yet.

13

Disposal Considerations

Waste treatment methods, disposal recommendations, and waste codes

The data for this section has not been processed yet.

14

Transport Information

UN numbers, shipping names, transport classes, and regulatory requirements

15

Regulatory Information

Chemical regulations, safety assessments, and compliance status

The data for this section has not been processed yet.

?

Frequently Asked Questions

Common questions about safety, handling, and properties

What is the hazard signal word for Divinol Entschaumer OL?

The signal word is warning.

What is the physical form of Divinol Entschaumer OL?

Divinol Entschaumer OL is a liquid with yellow color. It has characteristic odor.

What is Divinol Entschaumer OL used for?

Defoamer

What are the hazard statements for Divinol Entschaumer OL?

This substance has 1 hazard statement:

  • H317: May cause an allergic skin reaction.

What is the melting point of Divinol Entschaumer OL?

The melting point is not determined and the boiling point is 220-350 °C ASTM D 1078.