Peran/Flowshield SL Part A

Remove person to fresh air. If signs/symptoms continue, get medical attention.

Use a mild soap if available. Do not use solvent or thinners to clean skin. Wash off immediately with soap and plenty of water while removing all contaminated clothes and shoes. If skin irritation persists, call a physician.

Symptoms: May cause sensitization by skin contact. Irritating to skin.

Rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes. Remove contact lenses. If eye irritation persists, consult a specialist.

Symptoms: Irritating to eyes.

Consult a physician. Gently wipe or rinse the inside of the mouth with water. Give small amounts of water to drink. Never give anything by mouth to an unconscious person. If swallowed, DO NOT induce vomiting unless directed to do so by medical personnel.

Carbon Dioxide, Dry Chemical, Foam, Water Fog

Do not use a solid water stream as it may scatter and spread fire. Alcohol, Alcohol based solutions, any other media not listed above.

In case of fire hazardous decomposition products may be produced such as: Carbon monoxide, carbon dioxide and unburned hydrocarbons (smoke).

Keep containers and surroundings cool with water spray.

Avoid contact with skin, eyes and clothing. For personal protection see section 8.2. Ensure adequate ventilation. Keep people away from and upwind of spill/leak.

Discharge into the environment must be avoided. May cause long-term adverse effects in the aquatic environment.

soak up with non-combustible absorbent material and transfer to a container for disposal

Materials: non-combustible absorbent material, (e.g. sand, earth, diatomaceous earth, vermiculite)

Wear personal protective equipment. Avoid contact with skin and eyes. Repeated or prolonged skin contact may cause skin irritation and/or dermatitis and sensitization of susceptible persons. In the case of sensitisation to any of the ingredients, it is inadvisable to work with the product.

Keep at temperatures between 10 and 25 °C. Store in original container. Keep container tightly closed in a dry and well-ventilated place.

Handle in accordance with good industrial hygiene and safety practice. Keep working clothes separately. Keep away from food, drink and animal feedingstuffs. Wash hands before breaks and at the end of workday. When using, do not eat, drink or smoke.

Avoid contact with sources of heat.

Ensure adequate ventilation, especially in confined areas.

Use chemical resistant gloves (EN 374): Butyl rubber; thickness >= 0,5 mm; breakthrough time >= 60 min. Use chemical resistant gloves (EN 374): Nitrile rubber; thickness >= 0,5 mm; breakthrough time >= 480 min. Gloves should be discarded and replaced if there is any indication of degradation or chemical breakthrough. Take note of the information given by the producer concerning permeability and break through times, and of special workplace conditions (mechanical strain, duration of contact). Be aware that in daily use the durability of a chemical resistant protective glove can be notably shorter than the break through time measured according to EN 374, due to the numerous outside influences (e.g. temperature).

Eye wash bottle with pure water. Safety glasses with side-shields conforming to EN 166.

No personal respiratory protective equipment normally required. In case of insufficient ventilation wear suitable respiratory equipment, filter ABEK-P2.

Long sleeved clothing. Remove and wash contaminated clothing before re-use.

No decomposition if stored and applied as directed.

No reactivity hazards known under recommended storage and use conditions.

Amines cause exothermic reactions.

Avoid temperatures above 40 °C, direct sunlight and contact with sources of heat. Do not freeze.

Oxidizing agents. Acids and bases.

Carbon monoxide, carbon dioxide and unburned hydrocarbons (smoke).