BRIGHT ZINC 400 ml AMBRO-SOL

Remove to open air. If the subject stops breathing, administer artificial respiration. Get medical advice/attention immediately.

Remove contaminated clothing. Rinse skin with a shower immediately. Get medical advice/attention immediately. Wash contaminated clothing before using it again.

Remove contact lenses, if present. Wash immediately with plenty of water for at least 15 minutes, opening the eyelids fully. If problem persists, seek medical advice.

Get medical advice/attention immediately. Do not induce vomiting. Do not administer anything not explicitly authorised by a doctor.

carbon dioxide, foam, powder and water spray. Dry sand; Special powder against metal combustion.

None in particular. water, foam ABC powder, carbon dioxide (CO2).

If overheated, aerosol cans can deform, explode and be propelled considerable distances.

Put a protective helmet on before approaching the fire.

Eliminate all sources of ignition (cigarettes, flames, sparks, etc.) from the leakage site. Send away individuals who are not suitably equipped.

Do not disperse in the environment.

Use inert absorbent material to soak up leaked product.

Materials: inert absorbent material

Avoid bunching of electrostatic charges. Do not spray on flames or incandescent bodies. Vapours may catch fire and an explosion may occur; vapour accumulation is therefore to be avoided by leaving windows and doors open and ensuring good cross ventilation. Do not eat, drink or smoke during use. Do not breathe spray.

Store in a place where adequate ventilation is ensured, away from direct sunlight at a temperature below 50°C / 122°F, away from any combustion sources.

Do not eat, drink or smoke during use.

Avoid bunching of electrostatic charges. Do not spray on flames or incandescent bodies.

As the use of adequate technical equipment must always take priority over personal protective equipment, make sure that the workplace is well aired through effective local aspiration.

None required.

Wear airtight protective goggles (see standard EN 166).

If the threshold value (e.g. TLV-TWA) is exceeded for the substance or one of the substances present in the product, a mask with a type AX filter combined with a type P filter should be worn (see standard EN 14387). Respiratory protection devices must be used if the technical measures adopted are not suitable for restricting the worker's exposure to the threshold values considered. The protection provided by masks is in any case limited.

Wear category II professional long-sleeved overalls and safety footwear (see Regulation 2016/425 and standard EN ISO 20344). Wash body with soap and water after removing protective clothing.

The emissions generated by manufacturing processes, including those generated by ventilation equipment, should be checked to ensure compliance with environmental standards. Product residues must not be indiscriminately disposed of with waste water or by dumping in waterways.

The product is stable in normal conditions of use and storage.

There are no particular risks of reaction with other substances in normal conditions of use. Isobutyl acetate. Decomposes under the effect of heat. Attacks various types of plastic materials.

No hazardous reactions are foreseeable in normal conditions of use and storage.

Avoid overheating. Avoid exposure to: sources of heat, naked flames.

strong oxidants, strong acids, nitric acid, perchlorates, water, acids, alkalis, halogens, oxidising agents, alkaline hydroxides, potassium tert-butoxide

Information not available