LOCTITE 403 LOW ODOR/BLOOM known as 403 PRISM 20 G

Move to fresh air. If symptoms persist, seek medical advice. If not breathing, give artificial respiration. If breathing is difficult, oxygen should be administered by qualified personnel.

Rinse with running water and soap. Do not pull bonded skin apart. It may be gently peeled apart using a blunt object such as a spoon, preferably after soaking in warm soapy water. If lips are accidentally stuck together apply warm water to the lips and encourage maximum wetting and pressure from saliva inside the mouth. Peel or roll lips apart. Do not try to pull the lips apart with direct opposing action. If symptoms develop and persist, get medical attention.

Rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes. Seek medical attention immediately. Do not force eye open. Medical advice should be sought in case solid particles of cyanoacrylate trapped behind the eyelid cause any abrasive damage.

Seek immediate medical attention. Do not induce vomiting. Never give anything by mouth to an unconscious person. Ensure breathing passages are not obstructed. The product will polymerize rapidly and bond to the mouth making it almost impossible to swallow. Saliva will separate any solidified product in several hours. Prevent the patient from swallowing any separated mass.

Water spray (fog), foam, dry chemical or carbon dioxide. Use extinguishing measures appropriate to local circumstances and the surrounding environment.

Not available.

Not available.

Wear self-contained breathing apparatus and full protective clothing, such as turn-out gear. Keep unnecessary personnel away. In case of fire, keep containers cool with water spray.

isolate the hazard area and deny entry to unnecessary and unprotected personnel.

Do not allow product to enter sewer or waterways. Prevent further leakage or spillage if safe to do so.

Ensure adequate ventilation. Wear appropriate personal protective equipment. Do not use cloths for mopping up. Flood with water to complete polymerization and scrape off the floor.

Materials: water

Prevent contact with eyes, skin and clothing. Do not breathe vapor and mist. Wash thoroughly after handling. Use only with adequate ventilation. Keep container closed. See Section 8 of the SDS for Personal Protective Equipment. Avoid contact with fabric or paper goods. Contact with these materials may cause rapid polymerization which can generate smoke and strong irritating vapors, and cause thermal burns.

Keep in a cool, well ventilated area away from heat, sparks and open flame. Keep container tightly closed until ready for use.

Wash thoroughly after handling. When using, do not eat, drink or smoke.

Keep in a cool, well ventilated area away from heat, sparks and open flame.

Provide adequate local exhaust ventilation to maintain worker exposure below exposure limits.

Use nitrile gloves and aprons as necessary to prevent contact. Do not use PVC, nylon or cotton.

Wear safety glasses with side shields. Full face protection should be used if the potential for splashing or spraying of product exists.

Use NIOSH approved respirator if there is potential to exceed exposure limit(s).

Use chemical resistant, impermeable clothing including gloves and either an apron or body suit to prevent skin contact. The information provided on personal protective equipment is for guidance purposes only. A full risk assessment should be conducted prior to using this product to determine the appropriate personal protective equipment to suit local conditions. Personal protective equipment should conform to the relevant EN standard.

Stable under recommended storage conditions.

Not available.

Rapid exothermic polymerization will occur in the presence of water, amines, alkalis and alcohols.

Keep away from heat, ignition sources and incompatible materials. Protect from direct sunlight. Store away from incompatible materials.

Water. Alcohols. Amines. Bases.

None if used for intended purpose.