NextSDS Logo
Safety Data Sheet EN

LOCTITE FREKOTE RS100 known as FREKOTE® RS-100™ Aqualine Seal

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report.

Get Free Audit
01

Identification

Product identifiers, regulatory numbers, and supplier information

Product Information

Product Name
LOCTITE FREKOTE RS100 known as FREKOTE® RS-100™ Aqualine Seal
Product Code
1301928

Regulatory Identifiers

CAS Number
N/A

Identified Uses

Release agent

Uses advised against

None identified

Manufacturers & Suppliers

Henkel Corporation logo

Henkel Corporation

manufacturer

One Henkel Way, Rocky Hill, Connecticut 06067

+1 (860) 571-5100

www.henkelna.com

Emergency Contacts

Poison Control Center

1-877-671-4608

Poison Control Center

1-303-592-1711

CHEMTREC

1-800-424-9300

CHEMTREC

1-703-527-3887

02

Hazard Identification

GHS classification, signal word, pictograms, and hazard statements

Classified warning

Hazard Classifications

Skin Sens. Cat. 1 H317

GHS Pictograms

GHS07 - Health hazard

GHS07

Hazard Statements

H317 MAY CAUSE AN ALLERGIC SKIN REACTION.

Precautionary Statements

P261 Avoid breathing mist/vapours.
P272 Contaminated work clothing should not be allowed out of the workplace.
P280 Wear protective gloves.
P302 + P352 IF ON SKIN: Wash with plenty of water.
P333 + P313 If skin irritation or rash occurs: Get medical attention.
P362 + P364 Take off contaminated clothing and wash it before reuse.
P501 Dispose of contents and/or container according to Federal, State/Provincial and local governmental regulations.

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report

Free Audit
03

Composition / Information on Ingredients

Chemical components, concentration ranges, and hazardous substance identification

Type mixture

3-aminopropyltriethoxysilane | 919-30-2 | 0.1 - 1

Chemical Name CAS Number Concentration Hazardous
3-aminopropyltriethoxysilane 919-30-2 0.1 - 1% Yes
04

First Aid Measures

Emergency procedures for chemical exposure incidents

Inhalation

Move to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get medical attention.

Skin contact

Wash with soap and water. Remove contaminated clothing and footwear. Wash clothing before reuse. If symptoms develop and persist, get medical attention.

Eye contact

Rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes. Get immediate medical attention.

Ingestion

Do not induce vomiting. Never give anything by mouth to an unconscious person. Seek medical advice.

Immediate Medical Attention

Not available.

05

Firefighting Measures

Extinguishing media, specific hazards, and firefighter protection

Suitable media

Not applicable. Product is an aqueous dispersion. Use media appropriate for surrounding material.

Unsuitable media

Not available.

06

Accidental Release Measures

Spill cleanup procedures, containment, and environmental protection

Emergency procedures

Use personal protection recommended in Section 8, isolate the hazard area and deny entry to unnecessary and unprotected personnel. Evacuate and ventilate spill area; dike spill to prevent entry into water system.

Environmental

Do not allow product to enter sewer or waterways. Prevent further leakage or spillage if safe to do so.

Cleanup methods

Soak up with inert absorbent material (e.g. sand, silica gel, acid binder, universal binder, sawdust). Keep in suitable and closed containers for disposal.

Materials: inert absorbent material (e.g. sand, silica gel, acid binder, universal binder, sawdust)

Related Products

Similar products with comparable safety profiles

07

Handling and Storage

Safe handling precautions, storage conditions, and workplace requirements

Handling

Prevent contact with eyes, skin and clothing. Do not breathe vapor and mist. Do not taste or swallow. Do not wear contact lenses.

Storage

Keep in a cool, well ventilated area. Keep container closed. Store in original container until ready to use.

Hygiene

Wash thoroughly after handling.

08

Exposure Controls / PPE

Occupational exposure limits, engineering controls, and protective equipment

Engineering

Ensure adequate ventilation, especially in confined areas.

Hands

Chemical resistant, impermeable gloves.

Eyes

Safety goggles or safety glasses with side shields. Full face protection should be used if the potential for splashing or spraying of product exists.

Respiratory

Not normally required.

Skin/Body

Chemical resistant, impermeable gloves.

09

Physical and Chemical Properties

Appearance, physical state, melting point, boiling point, and material characteristics

Colour Intensity
---
Partition Coefficient
Not available.
Density
---
Melting Point
Not available.
Solidification Point
---
Relative Density
1 Approximately
Auto Ignition Temperature
Not available.
Molecular Weight
---
Odor
Mild
Flash Point
Aqueous solution
Softening Point
---
Form
---
State Under Standard Conditions
---
Odor Threshold
Not available.
Vapor Pressure
Not available.
Solubility
Soluble Water
Bulk Density
---
Explosive Limits
---
Flammability
Not applicable
Solubility In Water
---
Kinematic Viscosity
Not available.
Relative Evaporation Rate
---
Properties Status
---
Ph
Not available.
Physical State Data
liquid
Cloud Point
---
Freezing Point
---
Dynamic Viscosity
Not available.
Evaporation Rate
Not available.
Physical State
Liquid
Lower Explosive Limit
Not available.
Upper Explosive Limit
Not available.
Voc Content
0.6 %; 6 g/l (calculated)
Solubility In Fat
---
Boiling Point
100 °C (212°F) 1,013 hPa
Vapor Density
---
Appearance
---
Crystallisation Point
---
Decomposition Temperature
Not available.
Colour
Colourless / Colorless
Metal Corrosion
---
10

Stability and Reactivity

Chemical stability, hazardous reactions, and incompatible materials

Stability

Stable under normal conditions of storage and use.

Reactivity

Not available.

Hazardous reactions

None under normal processing.

Avoid

Store away from incompatible materials.

Incompatible

Avoid contact with materials sensitive to water.

Decomposition

None reasonably foreseeable.

12

Ecological Information

Environmental toxicity, biodegradation, and bioaccumulation data

The data for this section has not been processed yet.

13

Disposal Considerations

Waste treatment methods, disposal recommendations, and waste codes

The data for this section has not been processed yet.

14

Transport Information

UN numbers, shipping names, transport classes, and regulatory requirements

15

Regulatory Information

Chemical regulations, safety assessments, and compliance status

The data for this section has not been processed yet.

?

Frequently Asked Questions

Common questions about safety, handling, and properties

What is the hazard signal word for LOCTITE FREKOTE RS100 known as FREKOTE® RS-100™ Aqualine Seal?

The signal word is warning.

What is the physical form of LOCTITE FREKOTE RS100 known as FREKOTE® RS-100™ Aqualine Seal?

LOCTITE FREKOTE RS100 known as FREKOTE® RS-100™ Aqualine Seal is a liquid with colourless / colorless color. It has mild odor.

What is the solubility of LOCTITE FREKOTE RS100 known as FREKOTE® RS-100™ Aqualine Seal?

Soluble Water

What is LOCTITE FREKOTE RS100 known as FREKOTE® RS-100™ Aqualine Seal used for?

Release agent

What are the hazard statements for LOCTITE FREKOTE RS100 known as FREKOTE® RS-100™ Aqualine Seal?

This substance has 1 hazard statement:

  • H317: MAY CAUSE AN ALLERGIC SKIN REACTION.

What is the melting point of LOCTITE FREKOTE RS100 known as FREKOTE® RS-100™ Aqualine Seal?

The melting point is Not available. and the boiling point is 100 °C (212°F) 1,013 hPa.