TECHNOMELT PA 682 known as MACROMELT 682 VZHHD001

If not breathing, give artificial respiration. If breathing is difficult, oxygen should be administered by qualified personnel. Move to fresh air. If symptoms persist, seek medical advice.

Cool skin rapidly with cold water after contact with molten material. Cover affected areas with clean sheeting or gauze and seek immediate medical attention. No attempt should be made to remove material from skin or to remove contaminated clothing as damaged skin can be easily torn.

Symptoms: Molten adhesive may cause severe burns.

If eye contact occurs with molten material immediately cool with water. Do not remove adhesive. Seek medical attention.

Ingestion of solid adhesive is not expected to be hazardous. If symptoms develop and persist, get medical attention.

Use extinguishing measures appropriate to local circumstances and the surrounding environment. Dry chemical. Carbon dioxide.

Not available.

Fire fighters should wear positive pressure self-contained breathing apparatus (SCBA). Wear full protective clothing.

Use personal protection recommended in Section 8, isolate the hazard area and deny entry to unnecessary and unprotected personnel.

Do not allow material to contaminate ground water system.

Spilled material will solidify. Scrape up spilled material and place in a closed container for disposal.

Always be careful around molten material. Avoid skin contact with molten resins. Follow suggested application temperature. Do not wear contact lenses. At elevated temperatures, irritating fumes may be emitted. Wash hands before breaks and immediately after handling the product.

Keep cool in accordance with information on label and in Technical Data Sheets.

Wash hands before breaks and immediately after handling the product.

Use adequate ventilation to remove molten vapors or fumes.

Safety goggles or safety glasses with side shields. Full face protection should be used if the potential for splashing or spraying of product exists. Do not wear contact lenses.

Solid Resin: Dust safety masks are recommended when the potential for dust inhalation exists. Molten Resin: Use a NIOSH approved air-purifying respirator with an organic vapor cartridge.

Insulated gloves and long sleeved clothing are strongly recommended when working with molten adhesive.

Stable

Not available.

Will not occur.

Excessive heat.

Acids. Bases. Oxidizing agents.

Carbon dioxide, carbon monoxide and irritating and/or toxic gases and particulate may be generated by thermal decomposition or combustion.