TECHNOMELT PA 652 N known as MACROMELT OM 652 KG20

Move to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. If symptoms develop and persist, get medical attention.

Cool melted product on skin with plenty of water. Do not remove solidified product. Cover affected areas with clean sheeting or gauze and seek immediate medical attention. No attempt should be made to remove material from skin or to remove contaminated clothing as damaged skin can be easily torn.

Symptoms: Molten adhesive may cause severe burns.

If eye contact occurs with molten material immediately cool with water. Do not remove adhesive. Seek medical attention.

Ingestion of solid adhesive is not expected to be hazardous. If symptoms develop and persist, get medical attention.

Water spray (fog), foam, dry chemical or carbon dioxide. Use extinguishing measures appropriate to local circumstances and the surrounding environment.

In case of fire, keep containers cool with water spray.

Wear self-contained breathing apparatus and full protective clothing, such as turn-out gear.

Isolate the hazard area and deny entry to unnecessary and unprotected personnel.

Do not allow material to contaminate ground water system.

Sweep up spilled material. Avoid creating dust. Keep in suitable and closed containers for disposal.

Materials: suitable and closed containers

Do not place wet or damp solid into melt tank. Follow suggested application temperature. Always be careful around molten material. Avoid skin contact with molten resins. Do not wear contact lenses. Avoid dust formation.

Keep cool in accordance with information on label and in Technical Data Sheets.

Do not wear contact lenses.

Ventilation hoods and fans required when working with organic solvents or in hot melt applications. Heat only in areas with appropriate exhaust ventilation.

Safety goggles or safety glasses with side shields. Full face protection should be used if the potential for splashing or spraying of product exists. Do not wear contact lenses.

Solid Resin: Dust safety masks are recommended when the potential for dust inhalation exists. Molten Resin: Use a NIOSH approved air-purifying respirator with an organic vapor cartridge.

Insulated gloves and long sleeved clothing are strongly recommended when working with molten adhesive.

Stable

Not available.

Will not occur.

Excessive heat.

Acids. Bases. Oxidizing agents.

Carbon dioxide, carbon monoxide and irritating and/or toxic gases and particulate may be generated by thermal decomposition or combustion.