NextSDS Logo
Safety Data Sheet EN

LOCTITE SF 7649 ACTIVATOR known as 7649 100ML BTL X 12 EN/CH/JP

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report.

Get Free Audit
01

Identification

Product identifiers, regulatory numbers, and supplier information

Product Information

Product Name
LOCTITE SF 7649 ACTIVATOR known as 7649 100ML BTL X 12 EN/CH/JP
Product Code
38496

Regulatory Identifiers

CAS Number
N/A

Identified Uses

activation

Uses advised against

None identified

Manufacturers & Suppliers

Henkel Corporation logo

Henkel Corporation

manufacturer

One Henkel Way, Rocky Hill, Connecticut 06067

+1 (860) 571-5100

www.henkelina.com

Emergency Contacts

Poison Control Center

1-877-671-4608

Poison Control Center

1-303-592-1711

CHEMTREC

1-800-424-9300

CHEMTREC

1-703-527-3887

02

Hazard Identification

GHS classification, signal word, pictograms, and hazard statements

Classified danger

Hazard Classifications

Flam. Liq. Cat. 2
Eye Irrit. Cat. 2A
Repr. Cat. 2
STOT SE Cat. 3

GHS Pictograms

GHS02 - Flammable

GHS02

GHS07 - Health hazard

GHS07

GHS08 - Serious health hazard

GHS08

Hazard Statements

H225 HIGHLY FLAMMABLE LIQUID AND VAPOUR.
H319 CAUSES SERIOUS EYE IRRITATION.
H336 MAY CAUSE DROWSINESS OR DIZZINESS.
H361 SUSPECTED OF DAMAGING FERTILITY OR THE UNBORN CHILD.

Precautionary Statements

P201 Obtain special instructions before use.
P202 Do not handle until all safety precautions have been read and understood.
P210 Keep away from heat, sparks, open flames, hot surfaces - no smoking.
P233 Keep container tightly closed.
P240 Ground and bond container and receiving equipment.
P241 Use explosion-proof equipment.
P242 Use non-sparking tools.
P243 Take action to prevent static discharges.
P261 Avoid breathing mist/vapours.
P264 Wash affected area thoroughly after handling.
P271 Use only outdoors or in a well-ventilated area.
P280 Wear protective gloves, clothing, eye and face protection.
P303 + P361 + P353 If on skin (or hair): Take off immediately all contaminated clothing.
P305 + P351 + P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
P308 + P313 IF exposed or concerned: Get medical attention.
P337 + P313 If eye irritation persists: Get medical attention.
P370 + P378 In case of fire: Use foam, dry chemical or carbon dioxide to extinguish.
P403 + P233 Store in a well-ventilated place. Keep container tightly closed.
P403 + P235 Store in a well-ventilated place. Keep cool.
P405 Store locked up.
P501 Dispose of contents and/or container according to Federal, State/Provincial and local governmental regulations.
IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing. Call a POISON CENTER or physician if you feel unwell.

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report

Free Audit
03

Composition / Information on Ingredients

Chemical components, concentration ranges, and hazardous substance identification

Type mixture

* Exact percentages may vary or are trade secret. Concentration range is provided to assist users in providing appropriate protections.

Chemical Name CAS Number Concentration Hazardous
acetone 67-64-1 80 - 100% Yes
2-Ethylhexanoic acid 149-57-5 0.1 - 1% Yes
04

First Aid Measures

Emergency procedures for chemical exposure incidents

Inhalation

Move to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get medical attention.

Skin contact

Immediately flush skin with plenty of water (using soap, if available). Remove contaminated clothing and footwear. Wash clothing before reuse. Get medical attention.

Eye contact

Rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes. Get medical attention.

Ingestion

DO NOT induce vomiting unless directed to do so by medical personnel. Never give anything by mouth to an unconscious person. Get medical attention.

05

Firefighting Measures

Extinguishing media, specific hazards, and firefighter protection

Suitable media

Water spray (fog), foam, dry chemical or carbon dioxide.

Specific hazards

Vapors may accumulate in low or confined areas, travel considerable distance to source of ignition, and flash back. Uncontrolled polymerization may occur at high temperatures resulting in explosions or rupture of storage containers.

Instructions

Wear self-contained breathing apparatus and full protective clothing, such as turn-out gear. In case of fire, keep containers cool with water spray.

Firefighter Protection

Wear self-contained breathing apparatus and full protective clothing, such as turn-out gear.

06

Accidental Release Measures

Spill cleanup procedures, containment, and environmental protection

Emergency procedures

Isolate the hazard area and deny entry to unnecessary and unprotected personnel. Evacuate and ventilate spill area; dike spill to prevent entry into water system; wear full protective equipment during clean-up.

Environmental

Do not allow product to enter sewer or waterways.

Cleanup methods

Soak up with inert absorbent material (e.g. sand, silica gel, acid binder, universal binder, sawdust). Scrape up as much material as possible. Store in a partly filled, closed container until disposal.

Materials: inert absorbent material (e.g. sand, silica gel, acid binder, universal binder, sawdust)

Related Products

Similar products with comparable safety profiles

07

Handling and Storage

Safe handling precautions, storage conditions, and workplace requirements

Handling

Use only with adequate ventilation. Prevent contact with eyes, skin and clothing. Do not breathe vapor and mist. Wash thoroughly after handling. Keep container closed. Refer to Section 8.

Storage

For safe storage, store at or below 49 °C (120.2 °F). Keep in a cool, well ventilated area away from heat, sparks and open flame. Keep container tightly closed until ready for use.

Hygiene

Wash thoroughly after handling.

Fire prevention

Keep in a cool, well ventilated area away from heat, sparks and open flame.

08

Exposure Controls / PPE

Occupational exposure limits, engineering controls, and protective equipment

09

Physical and Chemical Properties

Appearance, physical state, melting point, boiling point, and material characteristics

Solubility In Fat
---
Partition Coefficient
Not available.
Density
0.7936
Colour
Green
Voc Content
1.48 %; 11.7 g/l EPA Method 24
State Under Standard Conditions
---
Decomposition Temperature
Not available.
Appearance
---
Kinematic Viscosity
> 20.5 mm2/s
Bulk Density
---
Flash Point
-19 °C (-2.2 °F); Estimated
Boiling Point
56 °C (132.8 °F)
Lower Explosive Limit
2.6 %
Solubility In Water
---
Explosive Limits
---
Vapor Pressure
230 mbar (20 °C (68°F)) 800 mbar (50 °C (122°F))
Metal Corrosion
---
Freezing Point
---
Relative Density
---
Physical State
liquid
Properties Status
---
Cloud Point
---
Molecular Weight
---
Physical State Data
liquid
Odor
Solvent, Acetone
Upper Explosive Limit
13 %
Auto Ignition Temperature
485 °C (905°F)
Ph
6 - 7
Softening Point
---
Relative Evaporation Rate
---
Colour Intensity
---
Solubility
Miscible Water
Melting Point
Not applicable, Product is a liquid
Crystallisation Point
---
Evaporation Rate
1.9 (Ether = 1)
Solidification Point
---
Dynamic Viscosity
Not available.
Flammability
Flammable liquid
Vapor Density
---
Odor Threshold
Not available.
Form
---
10

Stability and Reactivity

Chemical stability, hazardous reactions, and incompatible materials

Stability

Stable under normal conditions of storage and use.

Reactivity

Not available.

Hazardous reactions

None under normal processing.

Avoid

Elevated temperatures. Heat, flames, sparks and other sources of ignition. Store away from incompatible materials.

Incompatible

Strong oxidizing agents. Reducing agents. Acids. Alkali metals.

Decomposition

Oxides of nitrogen. Oxides of carbon. Irritating organic vapours.

12

Ecological Information

Environmental toxicity, biodegradation, and bioaccumulation data

The data for this section has not been processed yet.

13

Disposal Considerations

Waste treatment methods, disposal recommendations, and waste codes

The data for this section has not been processed yet.

14

Transport Information

UN numbers, shipping names, transport classes, and regulatory requirements

UN Number
1090
Shipping Name
Acetone solution
Transport Class
3
Packing Group
II
15

Regulatory Information

Chemical regulations, safety assessments, and compliance status

The data for this section has not been processed yet.

?

Frequently Asked Questions

Common questions about safety, handling, and properties

What is the hazard signal word for LOCTITE SF 7649 ACTIVATOR known as 7649 100ML BTL X 12 EN/CH/JP?

The signal word is danger.

What is the physical form of LOCTITE SF 7649 ACTIVATOR known as 7649 100ML BTL X 12 EN/CH/JP?

LOCTITE SF 7649 ACTIVATOR known as 7649 100ML BTL X 12 EN/CH/JP is a liquid with green color. It has solvent, acetone odor.

What is the solubility of LOCTITE SF 7649 ACTIVATOR known as 7649 100ML BTL X 12 EN/CH/JP?

Miscible Water

What is LOCTITE SF 7649 ACTIVATOR known as 7649 100ML BTL X 12 EN/CH/JP used for?

activation

What are the hazard statements for LOCTITE SF 7649 ACTIVATOR known as 7649 100ML BTL X 12 EN/CH/JP?

This substance has 4 hazard statements:

  • H225: HIGHLY FLAMMABLE LIQUID AND VAPOUR.
  • H319: CAUSES SERIOUS EYE IRRITATION.
  • H336: MAY CAUSE DROWSINESS OR DIZZINESS.
  • H361: SUSPECTED OF DAMAGING FERTILITY OR THE UNBORN CHILD.

What is the melting point of LOCTITE SF 7649 ACTIVATOR known as 7649 100ML BTL X 12 EN/CH/JP?

The melting point is Not applicable, Product is a liquid and the boiling point is 56 °C (132.8 °F).