NextSDS Logo
Safety Data Sheet EN

BONDERITE C-IC HX-357 MU ACID DEOXIDIZER

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report.

Get Free Audit
01

Identification

Product identifiers, regulatory numbers, and supplier information

Product Information

Product Name
BONDERITE C-IC HX-357 MU ACID DEOXIDIZER
Product Code
598128
Synonyms
DEOXIDIZER HX-357 MAKE UP

Regulatory Identifiers

CAS Number
N/A

Identified Uses

Rust dissolver

Uses advised against

None identified

Manufacturers & Suppliers

Henkel Corporation logo

Henkel Corporation

manufacturer

One Henkel Way, Rocky Hill, Connecticut 06067

+1 (860) 571-5100

www.henkelna.com

Emergency Contacts

Poison Control Center

1-877-671-4608

Poison Control Center

1-303-592-1711

CHEMTREC

1-800-424-9300

CHEMTREC

1-703-527-3887

02

Hazard Identification

GHS classification, signal word, pictograms, and hazard statements

Classified danger

Hazard Classifications

Met. Corr. Cat. 1 H290
Skin Corr. Cat. 1B H314
Eye Dam. Cat. 1 H314
Carc. Cat. 1A H350

GHS Pictograms

GHS05 - Corrosive

GHS05

GHS08 - Serious health hazard

GHS08

Hazard Statements

H290 MAY BE CORROSIVE TO METALS
H314 CAUSES SEVERE SKIN BURNS AND EYE DAMAGE
H350 MAY CAUSE CANCER

Precautionary Statements

P201 Obtain special instructions before use.
P202 Do not handle until all safety precautions have been read and understood.
P234 Keep only in original packaging.
P260 Do not breathe vapors, mist, or spray.
P264 Wash affected area thoroughly after handling.
P280 Wear protective gloves, clothing, eye and face protection.
P301 + P330 + P331 IF SWALLOWED: Rinse mouth. Do NOT induce vomiting.
P303 + P361 + P353 If on skin (or hair): Take off immediately all contaminated clothing.
P304 + P340 + P310 IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing. Immediately call a POISON CENTER or physician.
P305 + P351 + P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
P308 + P313 IF exposed or concerned: Get medical attention.
P363 Wash contaminated clothing before reuse.
P390 Absorb spillage to prevent material damage.
P405 Store locked up.
P501 Dispose of contents and/or container according to Federal, State/Provincial and local governmental regulations.

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report

Free Audit
03

Composition / Information on Ingredients

Chemical components, concentration ranges, and hazardous substance identification

Type mixture
Chemical Name CAS Number Concentration Hazardous
Sulfuric acid 7664-93-9 30 - 60% Yes
Fluorosilicic acid 16961-83-4 0.1 - 1% Yes

Notes

* Exact percentages may vary or are trade secret. Concentration range is provided to assist users in providing appropriate protections.

04

First Aid Measures

Emergency procedures for chemical exposure incidents

Inhalation

If mist or vapor of this product is inhaled, remove person immediately to fresh air. Seek medical attention if symptoms develop or persist.

Skin contact

Remove contaminated clothing and footwear. Rinse with large amounts of running water. GET MEDICAL ATTENTION IMMEDIATELY! If iced 0.13% benzalkonium chloride (Zephiran) solution or 2.5% calcium gluconate gel are available, the rinsing may be limited to 5 minutes, with the soaks or gel applied as soon as the rinsing is stopped. If benzalkonium chloride or calcium gluconate gel is not available, rinsing must continue until medical treatment is provided.

Eye contact

In case of contact with the eyes, rinse immediately with plenty of water for 15 minutes, and seek immediate medical attention.

Ingestion

Seek medical advice. DO NOT induce vomiting unless directed to do so by medical personnel. Give one to two glasses of water or milk. Never give anything by mouth to a victim who is unconscious or is having convulsions.

Immediate Medical Attention

GET MEDICAL ATTENTION IMMEDIATELY! (for skin contact); seek immediate medical attention (for eye contact).

Medical Treatment

If cyanosis is severe, intravenous injection of methylene blue, 1 mg/kg body weight, may be of value. Treatment of hypocalcemia associated with corrosive fluoride compounds exposure may be corrected by intravenous calcium gluconate or calcium chloride. Treatment of hypomagnesemia may be corrected by intravenous magnesium sulfate.

05

Firefighting Measures

Extinguishing media, specific hazards, and firefighter protection

Suitable media

Water spray (fog), foam, dry chemical or carbon dioxide.

Specific hazards

May liberate large quantities of dense, foul-smelling smoke which may contain unidentified toxic gasses.

Instructions

Wear full protective clothing. Wear self-contained breathing apparatus.

Firefighter Protection

Wear full protective clothing. Wear self-contained breathing apparatus.

06

Accidental Release Measures

Spill cleanup procedures, containment, and environmental protection

Emergency procedures

Use personal protection recommended in Section 8, isolate the hazard area and deny entry to unnecessary and unprotected personnel.

Environmental

Prevent further leakage or spillage if safe to do so. Wear appropriate personal protective equipment. Do not allow product to enter sewer or waterways.

Cleanup methods

Absorb spill with inert material. Shovel material into appropriate container for disposal.

Materials: inert material

Related Products

Similar products with comparable safety profiles

07

Handling and Storage

Safe handling precautions, storage conditions, and workplace requirements

Handling

Avoid breathing vapors or mists of this product. Prevent contact with eyes, skin and clothing. Do not breathe vapor and mist. Wash thoroughly after handling. Use caution when combining with water; DO NOT add water to acid, ALWAYS add acid to water while stirring to prevent release of heat, steam and fumes. Wash thoroughly after handling. Do not take internally. For industrial use only.

Storage

Keep container tightly closed and in a cool, well-ventilated place away from incompatible materials. Thaw and mix thoroughly if frozen.

Hygiene

Wash thoroughly after handling.

08

Exposure Controls / PPE

Occupational exposure limits, engineering controls, and protective equipment

09

Physical and Chemical Properties

Appearance, physical state, melting point, boiling point, and material characteristics

Physical State Data
liquid
Solubility In Water
Complete
Flammability
Not applicable
Vapor Pressure
< 100 hPa (20 °C (68°F))
Physical State
Liquid
Softening Point
---
Voc Content
Not applicable
Odor
Acidic
Cloud Point
---
Explosive Limits
---
Decomposition Temperature
Not available.
Form
---
Flash Point
Not applicable
Metal Corrosion
---
Vapor Density
---
Evaporation Rate
Not available.
Molecular Weight
---
Kinematic Viscosity
> 20.5 mm²/s
Appearance
---
Solubility In Fat
---
Auto Ignition Temperature
Not applicable
Partition Coefficient
Not available.
Relative Density
1.31 - 1.35
Properties Status
---
State Under Standard Conditions
---
Density
---
Solubility
---
Relative Evaporation Rate
---
Colour Intensity
---
Upper Explosive Limit
Not available.
Dynamic Viscosity
Not available.
Melting Point
Not applicable, Product is a liquid
Colour
Colourless / Colorless
Boiling Point
> 100 °C (> 212°F) calculated
Ph
< 1
Bulk Density
---
Crystallisation Point
---
Freezing Point
---
Lower Explosive Limit
Not available.
Odor Threshold
Not available.
Solidification Point
---
10

Stability and Reactivity

Chemical stability, hazardous reactions, and incompatible materials

Stability

Stable at normal conditions.

Reactivity

Not available.

Hazardous reactions

Will not occur.

Avoid

Keep away from heat, ignition sources and incompatible materials.

Incompatible

Keep away from organic, alkaline, and oxidizing materials, metallic powders, chromates, chlorates, nitrates, and carbides.

Decomposition

Upon decomposition, this product emits carbon monoxide, carbon dioxide and/or low molecular weight hydrocarbons. Oxides of sulfur.

12

Ecological Information

Environmental toxicity, biodegradation, and bioaccumulation data

The data for this section has not been processed yet.

13

Disposal Considerations

Waste treatment methods, disposal recommendations, and waste codes

The data for this section has not been processed yet.

14

Transport Information

UN numbers, shipping names, transport classes, and regulatory requirements

UN Number
2796
Shipping Name
Sulfuric acid solution
Transport Class
8
Packing Group
II
15

Regulatory Information

Chemical regulations, safety assessments, and compliance status

The data for this section has not been processed yet.

?

Frequently Asked Questions

Common questions about safety, handling, and properties

What other names is BONDERITE C-IC HX-357 MU ACID DEOXIDIZER known by?

BONDERITE C-IC HX-357 MU ACID DEOXIDIZER is also known as: DEOXIDIZER HX-357 MAKE UP

What is the hazard signal word for BONDERITE C-IC HX-357 MU ACID DEOXIDIZER?

The signal word is danger.

What is the physical form of BONDERITE C-IC HX-357 MU ACID DEOXIDIZER?

BONDERITE C-IC HX-357 MU ACID DEOXIDIZER is a liquid with colourless / colorless color. It has acidic odor.

What is BONDERITE C-IC HX-357 MU ACID DEOXIDIZER used for?

Rust dissolver

What are the hazard statements for BONDERITE C-IC HX-357 MU ACID DEOXIDIZER?

This substance has 3 hazard statements:

  • H290: MAY BE CORROSIVE TO METALS
  • H314: CAUSES SEVERE SKIN BURNS AND EYE DAMAGE
  • H350: MAY CAUSE CANCER

What is the melting point of BONDERITE C-IC HX-357 MU ACID DEOXIDIZER?

The melting point is Not applicable, Product is a liquid and the boiling point is > 100 °C (> 212°F) calculated.