NextSDS Logo
Safety Data Sheet EN

TEROSON WX 215 CC AE

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report.

Get Free Audit
01

Identification

Product identifiers, regulatory numbers, and supplier information

Product Information

Product Name
TEROSON WX 215 CC AE
Product Code
01362

Regulatory Identifiers

CAS Number
N/A

Identified Uses

Cavity sealing

Uses advised against

None identified

Manufacturers & Suppliers

Henkel Corporation logo

Henkel Corporation

manufacturer

One Henkel Way, Rocky Hill, Connecticut 06067

+1 (860) 571-5100

www.henkelna.com

Emergency Contacts

Poison Control Center

1-877-671-4608

Poison Control Center

1-303-592-1711

CHEMTREC

1-800-424-9300

CHEMTREC

1-703-527-3887

02

Hazard Identification

GHS classification, signal word, pictograms, and hazard statements

Classified warning

Hazard Classifications

Aerosol Cat. 2
Skin Irrit. Cat. 2
Eye Irrit. Cat. 2A
Skin Sens. Cat. 1
STOT SE Cat. 3

GHS Pictograms

GHS02 - Flammable

GHS02

GHS07 - Health hazard

GHS07

Hazard Statements

H223 FLAMMABLE AEROSOL
H229 PRESSURIZED CONTAINER: MAY BURST IF HEATED
H315 CAUSES SKIN IRRITATION
H317 MAY CAUSE AN ALLERGIC SKIN REACTION
H319 CAUSES SERIOUS EYE IRRITATION
H336 MAY CAUSE DROWSINESS OR DIZZINESS

Precautionary Statements

P210 Keep away from heat, sparks, open flames, hot surfaces - no smoking.
P211 Do not spray on an open flame or other ignition source.
P251 Do not pierce or burn, even after use.
P261 Avoid breathing mist or spray.
P264 Wash affected area thoroughly after handling.
P271 Use only outdoors or in a well-ventilated area.
P272 Contaminated work clothing should not be allowed out of the workplace.
P280 Wear protective gloves, eye protection, and face protection.
P302 + P352 IF ON SKIN: Wash with plenty of water.
P305 + P351 + P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
P333 + P313 If skin irritation or rash occurs: Get medical attention.
P337 + P313 If eye irritation persists: Get medical attention.
P362 + P364 Take off contaminated clothing and wash it before reuse.
P403 + P233 Store in a well-ventilated place. Keep container tightly closed.
P405 Store locked up.
P410 + P412 Protect from sunlight. Do not expose to temperatures exceeding 50°C/122°F.
P501 Dispose of contents and/or container according to Federal, State/Provincial and local governmental regulations.
IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing. Call a POISON CENTER or physician if you feel unwell.

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report

Free Audit
03

Composition / Information on Ingredients

Chemical components, concentration ranges, and hazardous substance identification

Type mixture
Chemical Name CAS Number Concentration Hazardous
Hydrocarbons, C9-C11, n-alkanes, isoalkanes, cyclics, < 2% aromatics 64742-48-9 30 - 60% Yes
butane 106-97-8 10 - 30% Yes
propane 74-98-6 10 - 30% Yes
Petrolatum (petroleum), oxidized 64743-01-7 1 - 5% Yes
Distillates (petroleum), solvent-refined light paraffinic 64741-89-5 1 - 5% Yes
Hydrocarbons, C9-C11, n-alkanes, isoalkanes, cyclics, < 2% aromatics 64742-48-9 1 - 5% Yes
Nonane 111-84-2 1 - 5% Yes
Isobutane 75-28-5 1 - 5% Yes
Sulfonic acids, petroleum, calcium salts 61789-86-4 1 - 5% Yes
Calcium carbonate 471-34-1 1 - 5% Yes

Notes

* Exact percentages may vary or are trade secret. Concentration range is provided to assist users in providing appropriate protections.

04

First Aid Measures

Emergency procedures for chemical exposure incidents

Inhalation

Move to fresh air. If breathing is difficult, give oxygen. If not breathing, give artificial respiration. If symptoms develop and persist, get medical attention.

Skin contact

Wash with soap and water. If symptoms develop and persist, get medical attention.

Eye contact

Rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes. If symptoms develop and persist, get medical attention.

Ingestion

Do not induce vomiting. If symptoms develop and persist, get medical attention.

Immediate Medical Attention

If symptoms develop and persist, get medical attention.

Medical Treatment

Treat symptomatically and supportively.

05

Firefighting Measures

Extinguishing media, specific hazards, and firefighter protection

Suitable media

Water spray (fog), foam, dry chemical or carbon dioxide.

Unsuitable media

Do not use high volume water jet.

Specific hazards

Contents under pressure. Do not handle or store near an open flame, heat or other sources of ignition. Do not puncture or incinerate pressurized containers. Exposure to temperatures above 49°C (120°F) may cause container to burst. Vapors are heavier than air and may travel to ignition sources and flash back.

Instructions

Keep unnecessary personnel away. In case of fire, keep containers cool with water spray.

Firefighter Protection

Wear self-contained breathing apparatus and full protective clothing, such as turn-out gear.

06

Accidental Release Measures

Spill cleanup procedures, containment, and environmental protection

Emergency procedures

Isolate the hazard area and deny entry to unnecessary and unprotected personnel.

Environmental

Do not allow product to enter sewer or waterways.

Cleanup methods

Soak up with inert absorbent material. Scrape up spilled material and place in a closed container for disposal.

Materials: sand, silica gel, acid binder, universal binder, sawdust

Related Products

Similar products with comparable safety profiles

07

Handling and Storage

Safe handling precautions, storage conditions, and workplace requirements

Handling

Prevent contact with eyes, skin and clothing. Do not breathe vapor and mist.

Storage

Store between 5°C (41°F) and 25°C (77°F). Keep in a cool, well ventilated area away from heat, sparks and open flame. Keep container tightly closed until ready for use. Keep container dry. Keep out of direct sunlight.

Hygiene

Wash thoroughly after handling. When using do not eat, drink or smoke.

Fire prevention

Use proper bonding and/or grounding procedures. Keep away from heat, sparks and open flame.

08

Exposure Controls / PPE

Occupational exposure limits, engineering controls, and protective equipment

09

Physical and Chemical Properties

Appearance, physical state, melting point, boiling point, and material characteristics

Solubility In Water
---
State Under Standard Conditions
---
Colour Intensity
---
Flash Point
42 °C (107.6 °F) ASTM D3278 Setaflash Closed Cup
Relative Density
0.706
Melting Point
Not applicable, Product is a liquid
Properties Status
---
Bulk Density
---
Explosive Limits
---
Odor Threshold
Not available.
Ph
Not applicable, Product is non-soluble (in water).
Vapor Pressure
960 Pa (20 °C (68°F)) 4900 Pa (50 °C (122°F))
Crystallisation Point
---
Colour
Brown
Partition Coefficient
Not available.
Kinematic Viscosity
41 mm2/s
Solubility In Fat
---
Relative Evaporation Rate
---
Freezing Point
---
Molecular Weight
---
Evaporation Rate
Not available.
Physical State
Liquid
Solidification Point
---
Form
---
Flammability
Flammable liquid; The substance or mixture is a flammable aerosol with the category 2.
Vapor Density
---
Softening Point
---
Odor
Slightly
Voc Content
73.9 % (calculated)
Boiling Point
170 °C (338°F)
Lower Explosive Limit
1.58 %
Metal Corrosion
---
Upper Explosive Limit
Not available.
Density
---
Cloud Point
---
Appearance
---
Dynamic Viscosity
Not available.
Decomposition Temperature
Not available.
Auto Ignition Temperature
Not available.
Solubility
Not miscible Water
Physical State Data
liquid
10

Stability and Reactivity

Chemical stability, hazardous reactions, and incompatible materials

Stability

Stable under recommended storage conditions.

Reactivity

Not available.

Hazardous reactions

Will not occur

Avoid

Keep away from heat, ignition sources and incompatible materials. Do not puncture, incinerate, or expose to temperatures above 48.9 °C (120 °F). Avoid dust formation.

Incompatible

Strong oxidizing agents. Acids. Chlorine.

Decomposition

Oxides of carbon. Irritating vapors.

12

Ecological Information

Environmental toxicity, biodegradation, and bioaccumulation data

The data for this section has not been processed yet.

13

Disposal Considerations

Waste treatment methods, disposal recommendations, and waste codes

The data for this section has not been processed yet.

14

Transport Information

UN numbers, shipping names, transport classes, and regulatory requirements

UN Number
1950
Shipping Name
Aerosols
Transport Class
2.1
15

Regulatory Information

Chemical regulations, safety assessments, and compliance status

The data for this section has not been processed yet.

?

Frequently Asked Questions

Common questions about safety, handling, and properties

What is the hazard signal word for TEROSON WX 215 CC AE?

The signal word is warning.

What is the physical form of TEROSON WX 215 CC AE?

TEROSON WX 215 CC AE is a liquid with brown color. It has slightly odor.

What is the solubility of TEROSON WX 215 CC AE?

Not miscible Water

What is TEROSON WX 215 CC AE used for?

Cavity sealing

What are the hazard statements for TEROSON WX 215 CC AE?

This substance has 6 hazard statements:

  • H223: FLAMMABLE AEROSOL
  • H229: PRESSURIZED CONTAINER: MAY BURST IF HEATED
  • H315: CAUSES SKIN IRRITATION
  • H317: MAY CAUSE AN ALLERGIC SKIN REACTION
  • H319: CAUSES SERIOUS EYE IRRITATION
  • H336: MAY CAUSE DROWSINESS OR DIZZINESS

What is the melting point of TEROSON WX 215 CC AE?

The melting point is Not applicable, Product is a liquid and the boiling point is 170 °C (338°F).