Scotch 1625 Contact Cleaner

Remove person to fresh air.

Immediately wash with soap and water. Remove contaminated clothing and wash before reuse.

Immediately flush with large amounts of water. Remove contact lenses if easy to do. Continue rinsing.

Rinse mouth.

Use a fire fighting agent suitable for the surrounding fire.

Water may not effectively extinguish fire.

Closed containers exposed to heat from fire may build pressure and explode.

Use water to keep fire-exposed containers and surfaces cool and prevent explosive rupture.

Evacuate area.

For large spill, or spills in confined spaces, provide mechanical ventilation to disperse or exhaust vapours, in accordance with good industrial hygiene practice.

Avoid release to the environment.

Collect as much of the spilled material as possible using non-sparking tools. Place in a metal container approved for transportation by appropriate authorities. Clean up residue with an appropriate solvent selected by a qualified and authorised person.

Materials: non-sparking tools, metal container, appropriate solvent

Do not use in a confined area with minimal air exchange. Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Do not spray on an open flame or other ignition source. Do not pierce or burn, even after use. Do not breathe dust/fume/gas/mist/vapours/spray. Do not get in eyes, on skin, or on clothing. Do not eat, drink or smoke when using this product. Wash thoroughly after handling. Avoid contact with oxidising agents (eg. chlorine, chromic acid etc.) Vapours may travel long distances along the ground or floor to an ignition source and flash back.

Store in a well-ventilated place. Protect from sunlight. Do not expose to temperatures exceeding 50C/122F. Store away from heat.

Do not eat, drink or smoke when using this product. Wash thoroughly after handling.

Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Do not spray on an open flame or other ignition source. Do not pierce or burn, even after use.

Provide ventilated enclosure for heat curing. Curing enclosures must be exhausted to outdoors or to a suitable emission control device. Do not remain in area where available oxygen may be reduced. Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below relevant Exposure Limits and/or control dust/fume/gas/mist/vapours/spray. If ventilation is not adequate, use respiratory protection equipment.

Gloves made from the following material(s) are recommended: Nitrile rubber.

Indirect vented goggles.

In case of inadequate ventilation wear respiratory protection. An exposure assessment may be needed to decide if a respirator is required. If a respirator is needed, use respirators as part of a full respiratory protection program. Based on the results of the exposure assessment, select from the following respirator type(s) to reduce inhalation exposure: Half facepiece or full facepiece air-purifying respirator suitable for organic vapours Half facepiece or full facepiece supplied-air respirator

Select and use gloves and/or protective clothing approved to relevant local standards to prevent skin contact based on the results of an exposure assessment. Selection should be based on use factors such as exposure levels, concentration of the substance or mixture, frequency and duration, physical challenges such as temperature extremes, and other use conditions. Consult with your glove and/or protective clothing manufacturer for selection of appropriate compatible gloves/protective clothing.

Stable.

This material may be reactive with certain agents under certain conditions - see the remaining headings in this section

Hazardous polymerisation will not occur.

Heat. Sparks and/or flames. Temperatures above the boiling point. High shear and high temperature conditions

Explosive when mixed with oxidizing substances. Strong acids.

Hydrocarbons, Carbon monoxide, Carbon dioxide.