Rust Remover

Upon breathing difficulties or irritation of the respiratory tract: Bring the person into fresh air and stay with him/her.

Symptoms: Inhaled vapour or aerosols may produce adverse effects to lungs, irritations and burns in the respiratory organs as well as coughing.

Flush exposed area with water for a long time - at least 30 minutes. It may be necessary to flush for several hours. Use a comfortable water temperature (20-30 °C). Contact Poison Information/doctor/hospital for further advice on follow-up and treatment. Upon irritation: rinse with water. In the event of continued irritation, seek medical assistance.

Symptoms: irritation

If in eyes: Flush eyes with plenty of water or salt water (20-30 °C) for at least 30 minutes and continue until irritation stops. Remove contact lenses. Make sure you flush under the upper and lower eyelids. Seek medical assistance immediately and continue flushing during transport.

Symptoms: irritation

In the case of ingestion, contact a doctor immediately. If the person is conscious, give them water. DO NOT try to induce vomiting unless this is recommended by a doctor. Hold head facing down to prevent vomit from returning to the mouth and throat. Prevent shock by keeping the injured person warm and calm. Initiate immediate resuscitation if breathing stops. If unconscious, roll the injured person into recovery position. Call an ambulance.

Alcohol-resistant foam, carbon dioxide, powder, water mist.

Waterjets should not be used, since they can spread the fire.

Fire will result in dense smoke. Exposure to combustion products may harm your health.

Closed containers, which are exposed to fire, should be cooled with water.

Avoid direct contact with spilled substances.

Avoid discharge to lakes, streams, sewers, etc.

cleaning should be performed with normal cleaning agents. Avoid use of solvents.

Avoid direct contact with the product.

Dry, cool and well ventilated

Smoking, drinking and consumption of food is not allowed in the work area.

The formation of vapours must be kept at a minimum and below current limit values (see above). Installation of a local exhaust system if normal air flow in the work room is not sufficient is recommended. Ensure eyewash and emergency showers are clearly marked. Ensure that eyewash stations and safety showers are located within easy reach.

Material: Nitrile, Glove thickness: 0.4 mm, Breakthrough time: >480 min., Standards: EN374-2, EN374-3, EN388

Type: Wear safety glasses with side shields., Standards: EN166

No special when used as intended.

Wear appropriate protection clothing, e.g. coveralls in polypropylene or working clothes in cotton or polyester.

Keep damming materials near the workplace. If possible, collect spillage during work.

The product is stable under the conditions, noted in section 7 "Handling and storage".

No data available.

None known.

None known.

Strong acids, strong bases, strong oxidizing agents, and strong reducing agents.

Thermal decomposition may produce corrosive vapours.