Identification
Product identifiers, regulatory numbers, and supplier information
Product Information
- Product Name
- N-Cetyl-N,N,N-trimethylammonium bromide GR for analysis
- Product Code
- 102342M
Regulatory Identifiers
- CAS Number
- 57-09-0 Check regulations →
Identified Uses
Reagent for analysis
Manufacturers & Suppliers
Sigma-Aldrich
distributor
Merck Sdn. Bhd.
manufacturer
No. 4, Jalan U1/26, Section U1, 40150 HICOM GLENMARIE INDUSTRIAL PARK, SHAH ALAM, MALAYSIA
+60 (0)3-74943688
Emergency Contacts
CHEMTREC
1-800-815-308
CHEMTREC Intl.
+60 3-9212 5794
Hazard Identification
GHS classification, signal word, pictograms, and hazard statements
Hazard Classifications
GHS Pictograms
GHS05
GHS07
GHS08
GHS09
Hazard Statements
Precautionary Statements
Get a free compliance audit
Upload your SDS inventory and get a detailed compliance report
Composition / Information on Ingredients
Chemical components, concentration ranges, and hazardous substance identification
| Chemical Name | CAS Number | Concentration | Hazardous |
|---|---|---|---|
| N-Cetyl-N'N'N-trimethylammonium bromide EC: 200-311-3 | 57-09-0 | 100% | Yes |
First Aid Measures
Emergency procedures for chemical exposure incidents
After inhalation: fresh air. Call in physician.
Take off immediately all contaminated clothing. Rinse skin with water/ shower.
After eye contact: rinse out with plenty of water. Immediately call in ophthalmologist. Remove contact lenses.
After swallowing: immediately make victim drink water (two glasses at most). Consult a physician.
Firefighting Measures
Extinguishing media, specific hazards, and firefighter protection
Use water spray, alcohol-resistant foam, dry chemical or carbon dioxide.
Combustible. Vapors are heavier than air and may spread along floors. Forms explosive mixtures with air on intense heating. Development of hazardous combustion gases or vapours possible in the event of fire.
Stay in danger area only with self-contained breathing apparatus. Prevent skin contact by keeping a safe distance or by wearing suitable protective clothing.
Firefighter Protection
Stay in danger area only with self-contained breathing apparatus. Prevent skin contact by keeping a safe distance or by wearing suitable protective clothing.
Accidental Release Measures
Spill cleanup procedures, containment, and environmental protection
Avoid inhalation of dusts. Avoid substance contact. Ensure adequate ventilation. Evacuate the danger area, observe emergency procedures, consult an expert.
Do not let product enter drains.
Take up dry. Clean up affected area.
Related Products
Similar products with comparable safety profiles
Hexadecyltrimethylammonium bromide
CAS: 57-09-0
Hexadecyltrimethylammonium bromide
CAS: 57-09-0
Cetyltrimethylammonium Bromide, Molecular Biology Grade
CAS: 57-09-0
Ammonium heptamolybdate tetrahydrate GR for analysis ACS, ISO, Reag. Ph Eur
CAS: 12054-85-2
Tris(hydroxymethyl)aminomethane GR for analysis buffer substance ACS,Reag. Ph Eur
CAS: 77-86-1
Tris(hydroxymethyl)aminomethane GR for analysis buffer substance ACS,Reag. Ph Eur
CAS: 77-86-1
Ammonium monovanadate GR for analysis Reag. Ph Eur
CAS: 7803-55-6
(2-Chloroethyl)trimethylammonium chloride
CAS: 999-81-5
Handling and Storage
Safe handling precautions, storage conditions, and workplace requirements
For precautions see section 2.2.
Tightly closed. Dry. Recommended storage temperature see product label.
Exposure Controls / PPE
Occupational exposure limits, engineering controls, and protective equipment
Material: Nitrile rubber, Minimum layer thickness: 0.11 mm, Break through time: 480 min, Material tested: KCL 741 Dermatril® L. This recommendation applies only to the product stated in the safety data sheet, supplied by us and for the designated use. When dissolving in or mixing with other substances and under conditions deviating from those stated in EN 16523-1 please contact the supplier of CE-approved gloves (e.g. KCL GmbH, D-36124 Eichenzell, Internet: www.kcl.de).
Use equipment for eye protection tested and approved under appropriate government standards such as NIOSH (US) or EN 166(EU). Tightly fitting safety goggles
Where risk assessment shows air-purifying respirators are appropriate use a full-face particle respirator type N100 (US) or type P3 (EN 143) respirator cartridges as a backup to engineering controls. If the respirator is the sole means of protection, use a full-face supplied air respirator. Use respirators and components tested and approved under appropriate government standards such as NIOSH (US) or CEN (EU).
protective clothing
Do not let product enter drains.
Physical and Chemical Properties
Appearance, physical state, melting point, boiling point, and material characteristics
Stability and Reactivity
Chemical stability, hazardous reactions, and incompatible materials
The product is chemically stable under standard ambient conditions (room temperature).
Forms explosive mixtures with air on intense heating. A range from approx. 15 Kelvin below the flash point is to be rated as critical. The following applies in general to flammable organic substances and mixtures: in correspondingly fine distribution, when whirled up a dust explosion potential may generally be assumed.
Violent reactions possible with: Strong oxidizing agents. Caution! In contact with nitrites, nitrates, nitrous acid possible liberation of nitrosamines!
Strong heating.
No data available
In the event of fire: see section 5
Ecological Information
Environmental toxicity, biodegradation, and bioaccumulation data
The data for this section has not been processed yet.
Disposal Considerations
Waste treatment methods, disposal recommendations, and waste codes
The data for this section has not been processed yet.
Transport Information
UN numbers, shipping names, transport classes, and regulatory requirements
- UN Number
- 3077
- Shipping Name
- ENVIRONMENTALLY HAZARDOUS SUBSTANCE, SOLID, N.O.S. (N-Cetyl-N'N'N-trimethylammonium bromide)
- Transport Class
- 9
- Packing Group
- III
Regulatory Information
Chemical regulations, safety assessments, and compliance status
The data for this section has not been processed yet.
Frequently Asked Questions
Common questions about safety, handling, and properties
What is the hazard signal word for N-Cetyl-N,N,N-trimethylammonium bromide GR for analysis?
The signal word is danger.
What is the physical form of N-Cetyl-N,N,N-trimethylammonium bromide GR for analysis?
N-Cetyl-N,N,N-trimethylammonium bromide GR for analysis is a solid with white color. It has weak odor.
What is N-Cetyl-N,N,N-trimethylammonium bromide GR for analysis used for?
Reagent for analysis
What are the hazard statements for N-Cetyl-N,N,N-trimethylammonium bromide GR for analysis?
This substance has 6 hazard statements:
- H302: Harmful if swallowed.
- H315: Causes skin irritation.
- H318: Causes serious eye damage.
- H335: May cause respiratory irritation.
- H373: May cause damage to organs (Gastrointestinal tract) through prolonged or repeated exposure if swallowed.
- H410: Very toxic to aquatic life with long lasting effects.
What is the melting point of N-Cetyl-N,N,N-trimethylammonium bromide GR for analysis?
The melting point is Melting point: 230 °C .