NextSDS Logo
Safety Data Sheet EN

Diamond Shine Ultra High Speed Floor Coating

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report.

Get Free Audit
01

Identification

Product identifiers, regulatory numbers, and supplier information

Product Information

Product Name
Diamond Shine Ultra High Speed Floor Coating
Product Code
104L5

Regulatory Identifiers

CAS Number
N/A

Identified Uses

Floor finish. Product intended for commercial and industrial use only.

Uses advised against

Other than per labelled instructions.

Manufacturers & Suppliers

Amano Pioneer Eclipse Corporation logo

Amano Pioneer Eclipse Corporation

manufacturer

P.O. Box 909, 1 Eclipse Road, Sparta, NC 28675

1-336-372-8080

http://www.pioneereclipse.com

Emergency Contacts

CHEMTREC

1-800-424-9300

CHEMTREC

1-703-527-3887

02

Hazard Identification

GHS classification, signal word, pictograms, and hazard statements

Classified no signal word

Hazard Classifications

Not Classified

GHS Pictograms

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report

Free Audit
03

Composition / Information on Ingredients

Chemical components, concentration ranges, and hazardous substance identification

Type mixture
Chemical Name CAS Number Concentration Hazardous
Tributoxyethylphosphate EC: 201-122-9 78-51-3 1 - 5% Yes
Trimethyl pentanyl diisobutyrate EC: 229-934-9 6846-50-0 1 - 5% Yes
04

First Aid Measures

Emergency procedures for chemical exposure incidents

Inhalation

If breathing is difficult, remove to fresh air. If symptoms persist, seek medical attention.

Symptoms: None expected under normal use.

Skin contact

Wash with plenty of water. If irritation develops and persists, seek medical attention.

Symptoms: None expected under normal use.

Eye contact

Rinse with plenty of water. If irritation develops and persists, seek medical attention.

Symptoms: May cause slight irritation.

Ingestion

If ingested, do not induce vomiting. Seek medical attention.

Symptoms: May cause irritation of the linings of the mouth, throat and gastrointestinal tract.

Immediate Medical Attention

In case of any doubt or when irritation occurs or persists seek medical advice.

05

Firefighting Measures

Extinguishing media, specific hazards, and firefighter protection

Suitable media

dry chemical, water spray, foam, carbon dioxide

Specific hazards

The product itself does not maintain combustion.

Firefighter Protection

As in any fire, wear self contained breathing apparatus and suitable protective clothing including gloves and eye/face protection. Fire-fighters should wear clothing conforming to EN469 for chemical incidents.

06

Accidental Release Measures

Spill cleanup procedures, containment, and environmental protection

Emergency procedures

Material spilled on hard surface can present a serious slipping/falling hazard.

Small spill

Absorb spill on inert material (e.g. sand, earth) and dispose of as waste material in accordance with national and regional provisions.

Large spill

Keep spectators away. Floors may be slippery; use care to avoid falling. Neutralize spill area. Dike and contain spill with inert material (e.g. sand, earth). Transfer liquid to containers for recovery or disposal and solid diking material to separate containers for disposal.

Environmental

Keep spills and cleaning runoff out of sewers and open bodies of water.

Cleanup methods

Absorb spill on inert material; Transfer liquid to containers for recovery or disposal and solid diking material to separate containers for disposal.

Related Products

Similar products with comparable safety profiles

07

Handling and Storage

Safe handling precautions, storage conditions, and workplace requirements

Handling

Avoid contact with eyes and skin. Wash thoroughly after handling. Use in well-ventilated areas.

Storage

Storage temperature (Min. 1°C - Max. 60°C). Keep from freezing. Keep container sealed when not in use. Keep out of reach of children.

Hygiene

Wash thoroughly after handling.

08

Exposure Controls / PPE

Occupational exposure limits, engineering controls, and protective equipment

Engineering

Use only with adequate ventilation. Use local ventilation and other engineering controls to maintain airborne contaminants below established and recommended exposure limits. If this product contains ingredients with exposure limits, monitoring may be required to determine the effectiveness of ventilation and other control measures.

Hands

This product is not classified as dangerous for the skin and therefore no protection gloves are necessary when this product is used. In case of prolonged use or sensitive skin, where irritation is possible, it would be recommended to use gloves. (EN374) Protective gloves should be selected according to the application and duration of use. Workplace selection should take into consideration handling requirements, physical requirements and exposure to other substances.

Eyes

Safety eyewear is recommended, to avoid chemical splashes and mists. Safety glasses or goggles (EN166).

Respiratory

Respiratory protection should be worn when there is a potential of inadequate ventilation. If exposure limits are exceeded or symptoms are experienced, use an approved respirator with multi-purpose combination filter. (E.g. - EN 14387- ABEK)

Environmental

No specific environmental exposure controls known.

09

Physical and Chemical Properties

Appearance, physical state, melting point, boiling point, and material characteristics

Physical State
liquid
Physical State Data
liquid
State Under Standard Conditions
---
Appearance
white liquid
Colour
---
Colour Intensity
---
Form
---
Odor
slight odor characteristic of raw material, no added fragrance
Odor Threshold
No test data available
Ph
9 - 10
Melting Point
---
Boiling Point
± 100 °C
Flash Point
> 90 °C
Freezing Point
± 0 °C
Softening Point
---
Solidification Point
---
Cloud Point
---
Crystallisation Point
---
Relative Evaporation Rate
---
Evaporation Rate
< 1 (butyl acetate = 1)
Vapor Pressure
23.4 hPa
Vapor Density
No test data available
Relative Density
1.03 kg/L @ 20°C
Bulk Density
---
Density
---
Flammability
Not applicable to liquids
Upper Explosive Limit
No test data available
Lower Explosive Limit
No test data available
Explosive Limits
---
Auto Ignition Temperature
No test data available
Decomposition Temperature
No test data available
Solubility
miscible in water
Partition Coefficient
-0.79 (calculated value)
Solubility In Water
---
Solubility In Fat
---
Molecular Weight
---
Voc Content
---
Metal Corrosion
---
Dynamic Viscosity
< 10mPa.s
Kinematic Viscosity
---
Properties Status
---
10

Stability and Reactivity

Chemical stability, hazardous reactions, and incompatible materials

Stability

Stable under normal conditions.

Reactivity

Stable under normal conditions.

Hazardous reactions

None known

Avoid

None known

Incompatible

Do not mix with other chemicals unless stated on the product label.

Decomposition

None known

12

Ecological Information

Environmental toxicity, biodegradation, and bioaccumulation data

The data for this section has not been processed yet.

13

Disposal Considerations

Waste treatment methods, disposal recommendations, and waste codes

The data for this section has not been processed yet.

14

Transport Information

UN numbers, shipping names, transport classes, and regulatory requirements

15

Regulatory Information

Chemical regulations, safety assessments, and compliance status

The data for this section has not been processed yet.

?

Frequently Asked Questions

Common questions about safety, handling, and properties

What is the hazard signal word for Diamond Shine Ultra High Speed Floor Coating?

The signal word is no signal word.

What is the physical form of Diamond Shine Ultra High Speed Floor Coating?

Diamond Shine Ultra High Speed Floor Coating is a liquid appearing as white liquid . It has slight odor characteristic of raw material, no added fragrance odor.

What is the solubility of Diamond Shine Ultra High Speed Floor Coating?

miscible in water

What is Diamond Shine Ultra High Speed Floor Coating used for?

Floor finish. Product intended for commercial and industrial use only.