PARFUM AMBIANCE ODORISANT AMBIANCE

If a large quantity is inhaled, move the patient into the fresh air and keep him/her warm and still.

Remove contaminated clothing and wash the skin thoroughly with soap and water or a recognised cleaner.

Wash thoroughly with soft, clean water for 15 minutes holding the eyelids open. Refer the patient to an ophthalmologist.

Symptoms: redness, pain or visual impairment

In the event of swallowing, if the quantity is small (no more than one mouthful), rinse the mouth with water and consult a doctor. If swallowed accidentally, call a doctor to assess the need for monitoring and subsequent treatment in hospital. Show him the label.

Chemical powders, carbon dioxide and other extinguishing gas are suitable for small fires. Special foams for polar liquids (known as alcohol resistant), powders, carbon dioxide.

Sometimes, and due to the presence of organic material, a fire may produce a thick black smoke. Exposure to decomposition products may be hazardous to health.

Do not breathe in smoke.

Avoid inhaling the vapors. Consult the safety measures listed under headings 7 and 8.

Contain and control the leaks or spills with non-combustible absorbent materials such as sand, earth, vermiculite, diatomaceous earth in drums for waste disposal. Prevent any material from entering drains or waterways.

Clean preferably with a detergent, do not use solvents.

Handle in well-ventilated areas. Prevent the formation of flammable or explosive concentrations in air and avoid vapor concentrations higher than the occupational exposure limits. Avoid inhaling solvent vapors and spray-gun aerosols. Packages which have been opened must be reclosed carefully and stored in an upright position. Avoid inhaling vapors.

Keep the container tightly closed in a dry, well-ventilated place. Keep away from all sources of ignition, heat and direct sunlight.

Smoking, eating and drinking are prohibited in premises where the preparation is used.

Use the product in premises where there are no naked flames or other sources of ignition and have protected electrical equipment. Keep packages tightly closed and away from sources of heat, sparks and naked flames. Do not use tools which may produce sparks. Do not smoke.

Ensure adequate ventilation, if possible with extractor fans at work posts and appropriate general extraction.

If this ventilation is insufficient to maintain the concentration of solvent vapors below the exposure limits, wear breathing apparatus

Any apparatus likely to produce a flame or to have a metallic surface at high temperature (burners, electric arcs, furnaces etc.) must not be allowed on the premises.

carbon monoxide and dioxide, smoke and nitrogen oxide