ALEXIT-Härter / Hardener 455 farblos / transparent

Remove to fresh air, keep patient warm and at rest. Irregular breathing/no breathing: artificial respiration. If unconscious place in recovery position and seek medical advice.

Take off all contaminated clothing immediately. Wash skin thoroughly with soap and water or use recognised skin cleanser. Do NOT use solvents or thinners !

Remove contact lenses, irrigate copiously with clean, fresh water for at least 10 minutes, holding the eyelids apart and seek medical advice.

Do NOT induce vomiting. If accidentally swallowed obtain immediate medical attention. Never give anything by mouth to an unconscious person. Keep at rest.

Alcohol resistant foam, CO2, powders, water spray

High volume water jet

Fire will produce dense black smoke. Exposure to decomposition products may cause a health hazard.

Cool endangered containers with water in case of fire.

Exclude sources of ignition and ventilate the area. Do not inhale vapours.

Do not let product enter drains.

Contain and collect spillage with non-combustible absorbent materials. Clean preferably with a detergent; avoid use of solvents.

Materials: Water 45 Vol.%, Ethanol or Isopropyl Alcohol 50 Vol.%, Ammonia solution (density=0,88) 5 Vol.%. Alternative applicable to that (not flammable): Sodium Carbonate 5 Vol.%, Water 95 Vol.%

Persons with a history of asthma, allergies, chronic or recurrent respiratory disease should not be employed in any process in which this preparation is used ! Prevent the creation of flammable or explosive concentrations of vapour in air and avoid vapour concentrations higher than the occupational exposure limits. Comply with the health and safety at work laws.

Keep container dry in a cool, well-ventilated place. Avoid heating and direct sunlight. Keep container tightly closed. DO NOT KEEP THE CONTAINERS SEALED !!

Smoking, eating and drinking should be prohibited in the application area.

The product should only be used in areas from which all naked lights and other sources of ignition have been excluded.

Provide adequate ventilation. Where reasonably practicable this should be achieved by the use of local exhaust ventilation and good general extraction. If these are not sufficient to maintain concentrations of particulates and below the OEL (= Occupational Exposure Limit), suitable respiratory protection must be worn.

Adhere to the professional organisation rule "Use of protective gloves". Appropriate chemicals resistant glove tested in compliance with EN 374. Recommendation for protection against components generally found in the products: For short-term contact (i.e. splash protection): Appropriate material: nitrile rubber, Neoprene. Material thickness: > 0,4 mm. Breakthrough time: > 480 min. Before use, the protective glove should be tested in any case for its specific work-station suitability (i.e. mechanical resistance, product compatibility and antistatic properties). Adhere to the manufacturer's instructions and information relating to the use, storage, care and replacement of protective gloves. Protective gloves shall be replaced immediately when physically damaged or worn. Preventive hand protection (skin protection cream) recommended. Wash immediately contaminated skin. Design operations thus to avoid permanent use of protective gloves.

Wear safety goggles to protect against solvent splashes.

By spraying: air-fed respirator. By other operations than spraying: in well ventilated areas, air-fed respirators could be replaced by a combination of charcoal filter and particulate filter mask

Personal should wear antistatic clothings made of natural fiber or of high temperature resistant synthetic fiber. All parts of the body should be washed after contact.

Stable under normal conditions.

No decomposition if stored and applied as directed.

No dangerous reaction known under conditions of normal use. There are no data available on the preparation itself.

Stable under recommended storage and handling conditions (See section 7)

oxidizing agents, strongly alkaline and strongly acid materials

In a fire, hazardous decomposition products, such as smoke, carbon monoxide, carbon dioxide, oxides of nitrogen, hydrogen cyanide, monomers of isocyanates, amines and alcohols may be produced.