NextSDS Logo
Safety Data Sheet EN

ALEXIT-Strukturlack/Texture Paint 476-21 RAL 7047 telegrau

Keep this SDS organized and up to date

Add this SDS to your NextSDS library and keep all its safety information in one place.

Add to my SDS library for free
01

Identification

Product identifiers, regulatory numbers, and supplier information

Product Information

Product Name
ALEXIT-Strukturlack/Texture Paint 476-21 RAL 7047 telegrau
Product Code
476D87047G000

Regulatory Identifiers

CAS Number
N/A

Identified Uses

Industrial serial painting

Manufacturers & Suppliers

M

Mankiewicz Coatings L.L.C

manufacturer

1200 Charleston Regional Parkway Charleston, South Carolina 29492 USA

+1 (843) 6547755

Emergency Contacts

CHEMTREC

+1 (800) 4249300

CHEMTREC

+ (703) 5273887

02

Hazard Identification

GHS classification, signal word, pictograms, and hazard statements

Classified warning

Hazard Classifications

Flam. Liq. Cat. 3
Carc. Cat. 2
STOT SE Cat. 3
STOT RE Cat. 2

GHS Pictograms

GHS02 - Flammable

GHS02

GHS07 - Health hazard

GHS07

GHS08 - Serious health hazard

GHS08

Hazard Statements

H226 Flammable liquid and vapor.
H336 May cause drowsiness or dizziness.
H351 Suspected of causing cancer.
H373 May cause damage to organs through prolonged or repeated exposure.

Precautionary Statements

P201 Obtain special instructions before use.
P202 Do not handle until all safety precautions have been read and understood.
P210 Keep away from heat/ sparks/ open flames/ hot surfaces. No smoking.
P233 Keep container tightly closed.
P240 Ground/bond container and receiving equipment.
P241 Use explosion-proof electrical/ ventilating/ lighting/ equipment.
P242 Use only non-sparking tools.
P243 Take precautionary measures against static discharge.
P260 Do not breathe dust/ fume/ gas/ mist/ vapors/ spray.
P271 Use only outdoors or in a well-ventilated area.
P280 Wear protective gloves/ protective clothing/ eye protection/ face protection.
P303 + P361 + P353 IF ON SKIN (or hair): Take off immediately all contaminated clothing. Rinse skin with water/ shower.
P308 + P313 IF exposed or concerned: Get medical advice/ attention.
P370 + P378 In case of fire: Use dry sand, dry chemical or alcohol-resistant foam to extinguish.
P403 + P233 Store in a well-ventilated place. Keep container tightly closed.
P403 + P235 Store in a well-ventilated place. Keep cool.
P405 Store locked up.
P501 Dispose of contents/ container to an approved waste disposal plant.
IF INHALED: Remove person to fresh air and keep comfortable for breathing. Call a POISON CENTER/ doctor if you feel unwell.

Still copying SDS data manually?Free

You don't have to. NextSDS reads this SDS and adds the information to your library automatically.

Let NextSDS do it for me
03

Composition / Information on Ingredients

Chemical components, concentration ranges, and hazardous substance identification

Type mixture

Mixture of synthetic resins, organic solvents and pigments

Chemical Name CAS Number Concentration Hazardous
n-butylacetate 123-86-4 5 - 12.5% No
xylenes 1330-20-7 5 - 12.5% No
2-methoxy-1-methylethyl acetate 108-65-6 1 - 5% No
ethylbenzene 100-41-4 1 - 5% No
These contain:<br>2-methoxypropyl acetate 70657-70-4 0.1% No
Actual concentration is withheld as --- --- No
titaniumdioxide 13463-67-7 20 - 25% No
Hydrocarbons, C9, aromatics 64742-95-6 5 - 12.5% No
04

First Aid Measures

Emergency procedures for chemical exposure incidents

Inhalation

Remove to fresh air, keep patient warm and at rest. Irregular breathing/no breathing: artificial respiration. If unconscious place in recovery position and seek medical advice.

Skin contact

Take off all contaminated clothing immediately. Wash skin thoroughly with soap and water or use recognised skin cleanser. Do NOT use solvents or thinners !

Eye contact

Remove contact lenses, irrigate copiously with clean, fresh water for at least 10 minutes, holding the eyelids apart and seek medical advice.

Ingestion

Do NOT induce vomiting. If accidentally swallowed obtain immediate medical attention. Never give anything by mouth to an unconscious person. Keep at rest.

Immediate Medical Attention

If accidentally swallowed obtain immediate medical attention.

05

Firefighting Measures

Extinguishing media, specific hazards, and firefighter protection

Suitable media

Alcohol resistant foam, CO2, powders

Unsuitable media

High volume water jet

Specific hazards

Fire will produce dense black smoke. Exposure to decomposition products may cause a health hazard.

Instructions

Cool endangered containers with water in case of fire.

Firefighter Protection

As in any fire, wear self-contained breathing apparatus pressure - demand, MSHA / NIOSH (approved or equivalent) and full protective gear.

06

Accidental Release Measures

Spill cleanup procedures, containment, and environmental protection

Emergency procedures

Exclude sources of ignition and ventilate the area. Do not inhale vapors. Refer to protective measures listed in sections 7 and 8. Evacuate personnel to safe areas.

Environmental

Do not let product enter drains. If the product contaminates lakes, rivers or sewage, inform appropriate authorities in accordance with local regulations.

Cleanup methods

Contain and collect spillage with non-combustible absorbent materials. Clean preferably with a detergent; avoid use of solvents.

Materials: non-combustible absorbent materials, e.g. sand, earth, vermiculite, diatomaceous earth

Related Products

Similar products with comparable safety profiles

07

Handling and Storage

Safe handling precautions, storage conditions, and workplace requirements

Handling

Prevent the creation of flammable or explosive concentrations of vapor in air and avoid vapor concentrations higher than the occupational exposure limits. Comply with the health and safety at work laws. Smoking, eating and drinking should be prohibited in the application area. Observe specific national regulations for handling and use of paints.

Storage

Keep container tightly closed. Never use pressure to empty: container is not a pressure vessel. No smoking. Prevent unauthorized access. Containers which are opened must be carefully resealed and kept upright to prevent leakage. Always keep in containers of same material as the original one. See also instructions on the label. Avoid heating and direct sunlight. Keep container dry in a cool, well-ventilated place.

Hygiene

Smoking, eating and drinking should be prohibited in the application area.

Fire prevention

The product should only be used in areas from which all naked lights and other sources of ignition have been excluded. Preparation may charge electrostatically: always use earthing leads when transferring from one container to another. Operators should wear anti-static footwear and clothing. No sparking tools should be used. Vapors are heavier than air and may spread along floors.

08

Exposure Controls / PPE

Occupational exposure limits, engineering controls, and protective equipment

09

Physical and Chemical Properties

Appearance, physical state, melting point, boiling point, and material characteristics

Metal Corrosion
---
Colour Intensity
---
Form
---
Colour
according product name
Boiling Point
ca. 248 °F / 120 °C
Ph
---
Evaporation Rate
---
Kinematic Viscosity
66 s Cross section: 4 mm Method: DIN 53211; 44 s Cross section: 6 mm Method: ISO 2431
Decomposition Temperature
---
Softening Point
---
Relative Density
---
Solubility In Fat
---
Auto Ignition Temperature
> 752 °F / > 400 °C
Partition Coefficient
---
Vapor Density
---
Solubility In Water
insoluble
Bulk Density
---
Dynamic Viscosity
---
Solidification Point
---
Upper Explosive Limit
10 %(V)
Flammability
---
Physical State Data
liquid
Crystallisation Point
---
Odor
characteristic
Odor Threshold
---
Physical State
liquid
Freezing Point
---
Lower Explosive Limit
1 %(V)
Solubility
---
Vapor Pressure
ca. 100 hPa (122 °F / 50 °C)
Molecular Weight
---
Relative Evaporation Rate
---
Appearance
liquid
Flash Point
81 °F / 27 °C Method: ISO 13736
State Under Standard Conditions
---
Voc Content
---
Melting Point
---
Properties Status
---
Explosive Limits
---
Cloud Point
---
Density
ca. 11.7 lb/gal (1.4 g/cm3) (68 °F / 20 °C)
10

Stability and Reactivity

Chemical stability, hazardous reactions, and incompatible materials

Stability

Stable under normal conditions.

Reactivity

No decomposition if stored and applied as directed.

Hazardous reactions

No dangerous reaction known under conditions of normal use. There are no data available on the preparation itself.

Avoid

Stable under recommended storage and handling conditions (See section 7).

Incompatible

Keep away from oxidizing agents, strongly alkaline and strongly acidic materials in order to avoid exothermic reactions.

Decomposition

When exposed to high temperatures may produce hazardous decomposition products such as carbon monoxide and dioxide, smoke, oxides of nitrogen.

12

Ecological Information

Environmental toxicity, biodegradation, and bioaccumulation data

The data for this section has not been processed yet.

13

Disposal Considerations

Waste treatment methods, disposal recommendations, and waste codes

The data for this section has not been processed yet.

14

Transport Information

UN numbers, shipping names, transport classes, and regulatory requirements

UN Number
UN1263
Shipping Name
PAINT
Transport Class
3
Packing Group
III
15

Regulatory Information

Chemical regulations, safety assessments, and compliance status

The data for this section has not been processed yet.

?

Frequently Asked Questions

Common questions about safety, handling, and properties

What is the hazard signal word for ALEXIT-Strukturlack/Texture Paint 476-21 RAL 7047 telegrau?

The signal word is warning.

What is the physical form of ALEXIT-Strukturlack/Texture Paint 476-21 RAL 7047 telegrau?

ALEXIT-Strukturlack/Texture Paint 476-21 RAL 7047 telegrau is a liquid appearing as liquid with according product name color. It has characteristic odor.

What is ALEXIT-Strukturlack/Texture Paint 476-21 RAL 7047 telegrau used for?

Industrial serial painting

What are the hazard statements for ALEXIT-Strukturlack/Texture Paint 476-21 RAL 7047 telegrau?

This substance has 4 hazard statements:

  • H226: Flammable liquid and vapor.
  • H336: May cause drowsiness or dizziness.
  • H351: Suspected of causing cancer.
  • H373: May cause damage to organs through prolonged or repeated exposure.