NextSDS Logo
Safety Data Sheet EN

PROVISIONS READY MATCH Touchup Bright Gold 310120350

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report.

Get Free Audit
01

Identification

Product identifiers, regulatory numbers, and supplier information

Product Information

Product Name
PROVISIONS READY MATCH Touchup Bright Gold 310120350
Product Code
168-0842

Regulatory Identifiers

CAS Number
N/A

Manufacturers & Suppliers

T

THE SHERWIN-WILLIAMS COMPANY

manufacturer

101 Prospect Avenue N.W. Cleveland, OH 44115

(216) 566-2902

Emergency Contacts

THE SHERWIN-WILLIAMS COMPANY

(216) 566-2917

Transportation Emergency

(800) 424-9300

02

Hazard Identification

GHS classification, signal word, pictograms, and hazard statements

Classified danger

Hazard Classifications

Aerosol Cat. 1
GASES UNDER PRESSURE - Compressed gas
Acute Tox. Cat. 4
Eye Irrit. Cat. 2A
Carc. Cat. 2
STOT SE Cat. 3
STOT RE Cat. 2
Asp. Tox. Cat. 1

GHS Pictograms

GHS02 - Flammable

GHS02

GHS04 - Compressed gas

GHS04

GHS07 - Health hazard

GHS07

GHS08 - Serious health hazard

GHS08

Hazard Statements

H222 Extremely flammable aerosol.
H280 Contains gas under pressure; may explode if heated.
H304 May be fatal if swallowed and enters airways.
H319 Causes serious eye irritation.
H332 Harmful if inhaled.
H335 May cause respiratory irritation.
H336 May cause drowsiness and dizziness.
H351 Suspected of causing cancer.
H372 May cause damage to organs through prolonged or repeated exposure.

Precautionary Statements

P201 Obtain special instructions before use.
P202 Do not handle until all safety precautions have been read and understood.
P210 Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.
P211 Do not spray on an open flame or other ignition source.
P251 Pressurized container: Do not pierce or burn, even after use.
P261 Do not breathe vapor.
P264 Wash hands thoroughly after handling.
P271 Use only outdoors or in a well-ventilated area.
P281 Use personal protective equipment as required.
P282 Wear eye or face protection.
P301 + P310 IF SWALLOWED: Immediately call a POISON CENTER or physician.
P304 + P341 IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing.
P305 + P351 + P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
P308 + P313 IF exposed or concerned: Get medical attention.
P312 Call a POISON CENTER or physician if you feel unwell.
P314 Get medical attention if you feel unwell.
P331 Do NOT induce vomiting.
P337 + P313 If eye irritation persists: Get medical attention.
P403 Store in a well-ventilated place.
P405 Store locked up.
P410 + P412 Protect from sunlight. Do not expose to temperatures exceeding 50 °C/122 °F.
P501 Dispose of contents and container in accordance with all local, regional, national and international regulations.

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report

Free Audit
03

Composition / Information on Ingredients

Chemical components, concentration ranges, and hazardous substance identification

Type mixture
Chemical Name CAS Number Concentration Hazardous
Acetone 67-64-1 25.5% No
Propane 74-98-6 15.5% No
Butane 106-97-8 7.5% No
n-Butyl Acetate 123-86-4 3.5% No
Titanium Dioxide 13463-67-7 2% No
Xylene 1330-20-7 1.5% No
Methyl n-Propyl Ketone 107-87-9 1.5% No
Ethylbenzene 100-41-4 0.4% No

Occupational exposure limits, if available, are listed in Section 8.

Notes

There are no additional ingredients present which, within the current knowledge of the supplier and in the concentrations applicable, are classified as hazardous to health or the environment and hence require reporting in this section.

04

First Aid Measures

Emergency procedures for chemical exposure incidents

Inhalation

If it is suspected that fumes are still present, the rescuer should wear an appropriate mask or self-contained breathing apparatus. It may be dangerous to the person providing aid to give mouth-to-mouth resuscitation. Get medical attention. If necessary, call a poison center or physician. In case of inhalation of decomposition products in a fire, symptoms may be delayed. The exposed person may need to be kept under medical surveillance for 48 hours.

Symptoms: Harmful if inhaled. Can cause central nervous system (CNS) depression. May cause drowsiness and dizziness. May cause respiratory irritation. Exposure to decomposition products may cause a health hazard. Serious effects may be delayed following exposure. Adverse symptoms may include the following: respiratory tract irritation, coughing, nausea or vomiting, headache, drowsiness/fatigue, dizziness/vertigo, unconsciousness.

Skin contact

Continue to rinse for at least 10 minutes. Get medical attention.

Symptoms: No known significant effects or critical hazards. No specific data.

Eye contact

Get medical attention.

Symptoms: Causes serious eye irritation. Adverse symptoms may include the following: pain or irritation, watering, redness.

Ingestion

Get medical attention immediately. Call a poison center or physician. Aspiration hazard if swallowed. Can enter lungs and cause damage. Do not induce vomiting.

Symptoms: Can cause central nervous system (CNS) depression. May be fatal if swallowed and enters airways. Irritating to mouth, throat and stomach. Adverse symptoms may include the following: nausea or vomiting.

Immediate Medical Attention

Get medical attention immediately. Call a poison center or physician.

Medical Treatment

No specific treatment.

05

Firefighting Measures

Extinguishing media, specific hazards, and firefighter protection

Suitable media

Use an extinguishing agent suitable for the surrounding fire.

Unsuitable media

None known.

Specific hazards

Extremely flammable aerosol. In a fire or if heated, a pressure increase will occur and the container may burst, with the risk of a subsequent explosion. Gas may accumulate in low or confined areas or travel a considerable distance to a source of ignition and flash back, causing fire or explosion. Bursting aerosol containers may be propelled from a fire at high speed. Runoff to sewer may create fire or explosion hazard.

Instructions

Promptly isolate the scene by removing all persons from the vicinity of the incident if there is a fire. No action shall be taken involving any personal risk or without suitable training. Move containers from fire area if this can be done without risk. Use water spray to keep fire-exposed containers cool.

06

Accidental Release Measures

Spill cleanup procedures, containment, and environmental protection

Emergency procedures

In the case of aerosols being ruptured, care should be taken due to the rapid escape of the pressurized contents and propellant. If a large number of containers are ruptured, treat as a bulk material spillage according to the instructions in the clean-up section. Shut off all ignition sources. No flares, smoking or flames in hazard area.

Small spill

Use spark-proof tools and explosion-proof equipment.

Large spill

Use spark-proof tools and explosion-proof equipment. Note: see Section 1 for emergency contact information and Section 13 for waste disposal.

Environmental

No specific hazard.

Related Products

Similar products with comparable safety profiles

07

Handling and Storage

Safe handling precautions, storage conditions, and workplace requirements

Handling

Pressurized container: protect from sunlight and do not expose to temperatures exceeding 50°C. Do not pierce or burn, even after use. Avoid exposure - obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Do not get in eyes or on skin or clothing. Do not swallow. Use only with adequate ventilation. Wear appropriate respirator when ventilation is inadequate. Store and use away from heat, sparks, open flame or any other ignition source. Use explosion-proof electrical (ventilating, lighting and material handling) equipment. Use only non-sparking tools.

Storage

Store in accordance with local regulations. Protect from sunlight. Store locked up. Eliminate all ignition sources.

Hygiene

Workers should wash hands and face before eating, drinking and smoking. Remove contaminated clothing and protective equipment before entering eating areas.

Fire prevention

Store and use away from heat, sparks, open flame or any other ignition source. Use explosion-proof electrical (ventilating, lighting and material handling) equipment. Use only non-sparking tools.

08

Exposure Controls / PPE

Occupational exposure limits, engineering controls, and protective equipment

09

Physical and Chemical Properties

Appearance, physical state, melting point, boiling point, and material characteristics

Physical State
aerosol
Physical State Data
aerosol
State Under Standard Conditions
---
Appearance
---
Colour
Not available.
Colour Intensity
---
Form
Spray
Odor
Not available.
Odor Threshold
Not available.
Ph
Not available.
Melting Point
Not available.
Boiling Point
Not available.
Flash Point
Closed cup: -29°C (-20.2°F) [Pensky-Martens Closed Cup]
Freezing Point
---
Softening Point
---
Solidification Point
---
Cloud Point
---
Crystallisation Point
---
Relative Evaporation Rate
---
Evaporation Rate
5.6 (butyl acetate = 1)
Vapor Pressure
13.5 kPa (101 mm Hg) [at 20°C]
Vapor Density
1.55 [Air = 1]
Relative Density
0.86
Bulk Density
---
Density
---
Flammability
Not available.
Upper Explosive Limit
Upper: 13.1%
Lower Explosive Limit
Lower: 1%
Explosive Limits
---
Auto Ignition Temperature
Not available.
Decomposition Temperature
Not available.
Solubility
Not available.
Partition Coefficient
Not available.
Solubility In Water
---
Solubility In Fat
---
Molecular Weight
---
Voc Content
---
Metal Corrosion
---
Dynamic Viscosity
---
Kinematic Viscosity
Kinematic (room temperature): <0.205 cm²/s (<20.5 cSt) Kinematic (40°C (104°F)): <0.205 cm²/s (<20.5 cSt)
Properties Status
---
10

Stability and Reactivity

Chemical stability, hazardous reactions, and incompatible materials

Stability

The product is stable.

Reactivity

No specific test data related to reactivity available for this product or its ingredients.

Hazardous reactions

Under normal conditions of storage and use, hazardous reactions will not occur.

Avoid

Avoid all possible sources of ignition (spark or flame).

Incompatible

No specific data.

Decomposition

Under normal conditions of storage and use, hazardous decomposition products should not be produced.

12

Ecological Information

Environmental toxicity, biodegradation, and bioaccumulation data

The data for this section has not been processed yet.

13

Disposal Considerations

Waste treatment methods, disposal recommendations, and waste codes

The data for this section has not been processed yet.

14

Transport Information

UN numbers, shipping names, transport classes, and regulatory requirements

UN Number
UN1950
Shipping Name
AEROSOLS
Transport Class
2.1
15

Regulatory Information

Chemical regulations, safety assessments, and compliance status

The data for this section has not been processed yet.

?

Frequently Asked Questions

Common questions about safety, handling, and properties

What is the hazard signal word for PROVISIONS READY MATCH Touchup Bright Gold 310120350?

The signal word is danger.

What is the physical form of PROVISIONS READY MATCH Touchup Bright Gold 310120350?

PROVISIONS READY MATCH Touchup Bright Gold 310120350 is a aerosol with not available. color. It has not available. odor.

What is the solubility of PROVISIONS READY MATCH Touchup Bright Gold 310120350?

Not available.

What are the hazard statements for PROVISIONS READY MATCH Touchup Bright Gold 310120350?

This substance has 9 hazard statements:

  • H222: Extremely flammable aerosol.
  • H280: Contains gas under pressure; may explode if heated.
  • H304: May be fatal if swallowed and enters airways.
  • H319: Causes serious eye irritation.
  • H332: Harmful if inhaled.
  • H335: May cause respiratory irritation.
  • H336: May cause drowsiness and dizziness.
  • H351: Suspected of causing cancer.
  • H372: May cause damage to organs through prolonged or repeated exposure.

What is the melting point of PROVISIONS READY MATCH Touchup Bright Gold 310120350?

The melting point is Not available. and the boiling point is Not available..