Loctite Super Glue Liquid

Move to fresh air, consult doctor if complaint persists.

Symptoms: Irritation, coughing, shortness of breath, chest tightness.

Do not pull bonded skin apart. It may be gently peeled apart using a blunt object such as a spoon, preferably after soaking in warm soapy water. If lips are accidentally stuck together apply warm water to the lips and encourage maximum wetting and pressure from saliva inside the mouth. Peel or roll lips apart. Do not try to pull the lips apart with direct opposing action. Burns should be treated normally after the adhesive has been removed from the skin.

Symptoms: Cyanoacrylates give off heat on solidification. In rare cases a large drop will generate enough heat to cause a burn.

If the eye is bonded closed, release eyelashes with warm water by covering with wet pad. Keep eye covered until debonding is complete, usually within 1-3 days. Do not force eye open.

Symptoms: Cyanoacrylate will bond to eye protein and will cause periods of weeping which will help to debond the adhesive.

Ensure that breathing passages are not obstructed.

Symptoms: The product will polymerise immediately in the mouth making it almost impossible to swallow. Saliva will slowly separate the solidified product from the mouth (several hours).

carbon dioxide, foam, powder, water spray jet, fine water spray

High pressure waterjet

In the event of a fire, carbon monoxide (CO) and carbon dioxide (CO2) can be released.

Wear protective equipment. Danger of slipping on spilled product. Ensure adequate ventilation. Avoid contact with skin and eyes.

Do not empty into drains / surface water / ground water.

Remove with liquid-absorbing material

Materials: sand, peat, sawdust

Open and handle container with care. Avoid skin and eye contact.

Storage at 2 to 8°C is recommended.

Wash hands before work breaks and after finishing work. Do not eat, drink or smoke while working.

Recommended are gloves made from Nitril rubber ( Material thickness >0,1 mm, Perforation time < 30s).Gloves should be replaced after each short time contact or contamination. Available at laboratory specialized trade or at pharmacies / chemist's shops. In the case of longer contact protective gloves made from nitrile rubber are recommended according to EN 374. material thickness > 0.4 mm Perforation time > 30 minutes In the case of longer and repeated contact please note that in practice the penetration times may be considerably shorter than those determined according to EN 374. The protective gloves must always be checked for their suitability for use at the specific workplace (e.g. mechanical and thermal stress, product compatibility, antistatic effects, etc.). The gloves must be replaced immediately at the first signs of wear and tear. The information provided by the manufacturers and given in the relevant trade association regulations for industrial safety must always be observed. We recommend that a hand care plan is drawn up in cooperation with a glove manufacturer and the trade association in accordance with the local operating conditions.

Goggles which can be tightly sealed. Protective eye equipment should conform to EN166.

Suitable breathing mask when there is inadequate ventilation. Filter type: A (EN 14387) This recommendation should be matched to local conditions.

Suitable protective clothing Protective clothing should conform to EN 14605 for liquid splashes or to EN 13982 for dusts.

Stable under recommended storage conditions.

Rapid exothermic polymerization will occur in the presence of water, amines, alkalis and alcohols.

See section reactivity

None if used for intended purpose.

See section reactivity.

None known.

Not more than 500 ml (each inner package) - Unrestricted