Potassium hexacyanoferrate(II) trihydrate for analysis EMSURE® ACS,ISO,Reag. Ph Eur

After inhalation: fresh air.

In case of skin contact: Take off immediately all contaminated clothing. Rinse skin with water/ shower.

After eye contact: rinse out with plenty of water. Remove contact lenses.

After swallowing: make victim drink water (two glasses at most). Consult doctor if feeling unwell.

Use extinguishing measures that are appropriate to local circumstances and the surrounding environment.

For this substance/mixture no limitations of extinguishing agents are given.

Not combustible. Fire may cause evolution of: Hydrogen cyanide (hydrocyanic acid), nitrous gases. Ambient fire may liberate hazardous vapours.

Suppress (knock down) gases/vapours/mists with a water spray jet.

Avoid inhalation of dusts. Evacuate the danger area, observe emergency procedures, consult an expert.

Do not let product enter drains.

Cover drains. Collect, bind, and pump off spills. Observe possible material restrictions (see sections 7 and 10). Take up dry. Dispose of properly. Clean up affected area.

Change contaminated clothing. Wash hands after working with substance. For precautions see section 2.2.

Protected from light. Tightly closed. Dry.

Change contaminated clothing. Wash hands after working with substance.

Material : Nitrile rubber; Break through time : 480 min; Glove thickness : 0,11 mm; Protective index : Full contact; Manufacturer : KCL 741 Dermatril® L; Material : Nitrile rubber; Break through time : 480 min; Glove thickness : 0,11 mm; Protective index : Splash contact; Manufacturer : KCL 741 Dermatril® L; Remarks : This recommendation applies only to the product stated in the safety data sheet, supplied by us and for the designated use. When dissolving in or mixing with other substances and under conditions deviating from those stated in EN 16523-1 please contact the supplier of CE-approved gloves (e.g. KCL GmbH, D-36124 Eichenzell, Internet: www.kcl.de).

Use equipment for eye protection tested and approved under appropriate government standards such as NIOSH (US) or EN 166(EU). Safety glasses

required when dusts are generated. Our recommendations on filtering respiratory protection are based on the following standards: DIN EN 143, DIN 14387 and other accompanying standards relating to the used respiratory protection system. Recommended Filter type: : Filter type P1. The entrepreneur has to ensure that maintenance, cleaning and testing of respiratory protective devices are carried out according to the instructions of the producer. These measures have to be properly documented.

Do not let product enter drains.

The product is chemically stable under standard ambient conditions (room temperature).

Contact with acids liberates very toxic gas.

A risk of explosion and/or of toxic gas formation exists with the following substances: Strong acids, Oxidizing agents, Hydrogen chloride gas, nitrites

Avoid temperatures above 60°C, direct sunlight and contact with sources of heat. Contact with acids liberates very toxic gas.

acids

In the event of fire: see section 5