Top Coat Grey 5002

Remove to fresh air and keep at rest in a position comfortable for breathing. Get medical attention if symptoms occur.

Symptoms: The product is irritating to mucous membranes and upper respiratory tract. Adverse symptoms may include the following: respiratory tract irritation, coughing. May cause damage to organs through prolonged or repeated exposure.

Wash contaminated skin with soap and water. Get medical attention.

Symptoms: Skin inflammation is characterized by itching, scaling, reddening or, occasionally, blistering.

In case of contact with eyes, rinse immediately with plenty of water. Remove contact lenses, if present and easy to do. Continue rinsing. Continue to rinse for at least 10 minutes. Get medical attention if symptoms occur.

Symptoms: Inflammation of the eye is characterized by redness, watering and itching.

Wash out mouth with water. Get medical attention if symptoms occur.

Symptoms: Adverse symptoms may include the following: burning in throat

Recommended: CO₂, powders, Foam

Do not use water jet.

Flammable liquid and vapor. In a fire or if heated, a pressure increase will occur and the container may burst, with the risk of a subsequent explosion. The vapor/gas is heavier than air and will spread along the ground. Vapors may accumulate in low or confined areas or travel a considerable distance to a source of ignition and flash back. Runoff to sewer may create fire or explosion hazard.

Promptly isolate the scene by removing all persons from the vicinity of the incident if there is a fire. Move containers from fire area if this can be done without risk. Use water spray to keep fire-exposed containers cool.

Shut off all ignition sources. No flares, smoking or flames in hazard area. Avoid breathing vapor or mist. Provide adequate ventilation. Refer to protective measures listed in sections 7 and 8.

Stop leak if without risk. Use spark-proof tools and explosion-proof equipment. Contain and collect spillage with non-combustible, absorbent material e.g. sand, earth, vermiculite or diatomaceous earth and place in container for disposal according to local regulations.

Stop leak if without risk. Move containers from spill area. Use spark-proof tools and explosion-proof equipment. Approach release from upwind. Prevent entry into sewers, water courses, basements or confined areas. Wash spillages into an effluent treatment plant or proceed as follows. Contain and collect spillage with non-combustible, absorbent material e.g. sand, earth, vermiculite or diatomaceous earth and place in container for disposal according to local regulations (see Section 13). Dispose of via a licensed waste disposal contractor. Contaminated absorbent material may pose the same hazard as the spilled product. Note: see Section 1 for emergency contact information and Section 13 for waste disposal.

Avoid dispersal of spilled material and runoff and contact with soil, waterways, drains and sewers.

Contain and collect spillage with non-combustible, absorbent material.

Materials: sand, earth, vermiculite or diatomaceous earth

Keep away from heat, sparks and flame. Keep away from sources of ignition. Use only with adequate ventilation. Wear appropriate respirator when ventilation is inadequate. Put on appropriate personal protective equipment (see Section 8). Do not breathe vapor or mist. Empty containers retain product residue and can be hazardous. Do not reuse container. Avoid contact with eyes, skin and clothing. Do not ingest. Store and use away from heat, sparks, open flame or any other ignition source. Wash thoroughly after handling. Do not eat, drink or smoke when using this product.

Store in a segregated and approved area. Store locked up. Keep container tightly closed. Keep container in a cool, well-ventilated area.

Wash hands, forearms and face thoroughly after handling chemical products, before eating, smoking and using the lavatory and at the end of the working period. Wash contaminated clothing before reuse.

Keep away from heat, sparks and flame. Keep away from sources of ignition. Use explosion-proof electrical (ventilating, lighting and material handling) equipment. To avoid fire or explosion, dissipate static electricity during transfer by grounding and bonding containers and equipment before transferring material. Take precautionary measures against electrostatic discharges. Use only non-sparking tools.

Use only with adequate ventilation. If this product contains ingredients with exposure limits, use process enclosures, local exhaust ventilation or other engineering controls to keep worker exposure below any recommended or statutory limits. Where reasonably practicable, this should be achieved by the use of local exhaust ventilation and good general extraction. If workers are exposed to concentrations above the exposure limit, they must use appropriate, certified respirators. Use explosion-proof ventilation equipment.

For prolonged or repeated handling, use gloves > 8 hours (breakthrough time). Chemically resistant gloves, EN374. Recommended: PE Laminate or polyvinyl alcohol (PVA) >0.3 mm, 240 minutes (breakthrough time). Short term exposure: nitrile rubber gloves < 1 hour (breakthrough time): <10 minutes, >0.12 mm thickness.

Recommended: Use eye protection according to EN 166, designed to protect against liquid splashes. Ensure that eyewash stations and safety showers are close to the workstation location.

Provide adequate ventilation. Recommended: Use a properly fitted, particulate filter respirator complying with an approved standard if a risk assessment indicates this is necessary. Recommended filter combination: A2-P2. Respirator selection must be based on known or anticipated exposure levels, the hazards of the product and the safe working limits of the selected respirator. Provide adequate ventilation.

Personal protective equipment for the body should be selected based on the task being performed and the risks involved and should be approved by a specialist before handling this product. When there is a risk of ignition from static electricity, wear anti-static protective clothing. For the greatest protection from static discharges, clothing should include anti-static overalls, boots and gloves. Recommended: Personal protective equipment for the body should be selected based on the task being performed and the risks involved and should be approved by a specialist before handling this product. When there is a risk of ignition from static electricity, wear anti-static protective clothing. For the greatest protection from static discharges, clothing should include anti-static overalls, boots and gloves. Appropriate footwear and any additional skin protection measures should be selected based on the task being performed and the risks involved and should be approved by a specialist before handling this product. Recommended: Wear protective shoes. Barrier creams may help to protect the exposed areas of the skin but should not be applied once exposure has occurred.

Do not allow to enter drains or watercourses.

Stable under recommended storage and handling conditions (see Section 7).

No specific test data related to reactivity available for this product or its ingredients.

Under normal conditions of storage and use, hazardous reactions will not occur.

Avoid all possible sources of ignition (spark or flame). Do not pressurize, cut, weld, braze, solder, drill, grind or expose containers to heat or sources of ignition. Do not allow vapor to accumulate in low or confined areas.

strong acids, strong alkalis, oxidizing materials

Under normal conditions of storage and use, hazardous decomposition products should not be produced.

Transport within user's premises: always transport in closed containers that are upright and secure. Ensure that persons transporting the product know what to do in the event of an accident or spillage.

Transport within user's premises: always transport in closed containers that are upright and secure. Ensure that persons transporting the product know what to do in the event of an accident or spillage.

Transport within user's premises: always transport in closed containers that are upright and secure. Ensure that persons transporting the product know what to do in the event of an accident or spillage.