BIOSCAN TOTAL ATP SAMPLING PENS

Remove victim to fresh air and keep at rest in a position comfortable for breathing. Call a physician if symptoms develop or persist.

Symptoms: May cause respiratory irritation.

Wash contaminated clothing before reuse. Remove contaminated clothing. Wash with plenty of soap and water. If skin irritation occurs: Get medical advice/attention.

Symptoms: Skin irritation. May cause redness and pain.

Immediately flush eyes with plenty of water for at least 15 minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention.

Symptoms: Severe eye irritation. Symptoms may include stinging, tearing, redness, swelling, and blurred vision.

Do not induce vomiting. Rinse mouth. Get medical attention if symptoms occur.

Water fog. Foam. Dry chemical powder. Carbon dioxide (CO2).

Do not use water jet as an extinguisher, as this will spread the fire.

During fire, gases hazardous to health may be formed.

Use standard firefighting procedures and consider the hazards of other involved materials.

Keep unnecessary personnel away. Keep people away from and upwind of spill/leak. Wear appropriate protective equipment and clothing during clean-up. Do not touch damaged containers or spilled material unless wearing appropriate protective clothing. Ensure adequate ventilation. Local authorities should be advised if significant spillages cannot be contained. Isolate spill or leak in a radius of 50 meters at least, in all directions.

Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual contamination.

Dike the spilled material, where this is possible. Absorb in vermiculite, dry sand or earth and place into containers. Following product recovery, flush area with water.

Avoid release to the environment. Do not flush into surface water or sanitary sewer system.

Wipe up with absorbent material. Clean surface thoroughly. Clean up in accordance with all applicable regulations.

Materials: absorbent material (e.g. cloth, fleece), inert absorbent material

Avoid breathing mist or vapor. Avoid contact with eyes, skin, and clothing. Avoid prolonged exposure. Provide adequate ventilation. Wear appropriate personal protective equipment. Observe good industrial hygiene practices.

Store locked up. Store in original tightly closed container. Store away from incompatible materials (see Section 10 of the SDS).

Observe good industrial hygiene practices.

Good general ventilation (typically 10 air changes per hour) should be used. Ventilation rates should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation, or other engineering controls to maintain airborne levels below recommended exposure limits. If exposure limits have not been established, maintain airborne levels to an acceptable level. Provide eyewash station. Eye wash fountain and emergency showers are recommended.

Neoprene gloves (Protection against unintentional short-term contact) Nitrile gloves (Protection against unintentional short-term contact) Butyl gloves (Protection against unintentional short-term contact) Wash off after each use. Replace as necessary.

Wear safety glasses with side shields (or goggles).

Chemical respirator with organic vapor cartridge and full facepiece.

Wear appropriate chemical resistant clothing. Use of impervious boots is recommended.

Material is stable under normal conditions.

The product is stable and non-reactive under normal conditions of use, storage and transport.

Hazardous polymerization does not occur. Hazardous reactions may occur if this material gets inadvertently in contact with incompatible materials.

Avoid temperatures exceeding the flash point. Contact with incompatible materials.

Strong oxidizing agents.

No hazardous decomposition products are known. Thermal decomposition (destructive fires) yields elemental oxides.

Collect and reclaim or dispose in sealed containers at licensed waste disposal site.

Dispose of in accordance with local regulations. Empty containers or liners may retain some product residues. This material and its container must be disposed of in a safe manner.