Pure Performance® Base Oil 225N, 600N

Move victim away from source of exposure and into fresh air in a position comfortable for breathing.

Symptoms: Breathing difficulties.

Remove contaminated shoes and clothing and cleanse affected area(s) thoroughly by washing with mild soap and water or a waterless hand cleaner.

Symptoms: Irritation or redness.

Flush eyes with clean water.

Symptoms: Irritation or redness.

First aid is not normally required.

Symptoms: Accidental ingestion can result in minor irritation of the digestive tract, nausea and diarrhea.

Dry chemical, carbon dioxide, foam, or water spray is recommended.

Simultaneous use of foam and water on the same surface is to be avoided as water destroys the foam.

This material may burn, but will not ignite readily. If container is not properly cooled, it can rupture in the heat of a fire.

Isolate the hazard area and deny entry to unnecessary and unprotected personnel. Stop spill/release if it can be done safely. Move undamaged containers from immediate hazard area if it can be done safely. Water spray may be useful in minimizing or dispersing vapours and to protect personnel. Avoid spreading burning liquid with water used for cooling purposes. Cool equipment exposed to fire with water, if it can be done safely.

Stay upwind and away from spill/release. Avoid direct contact with material. For large spillages, notify persons down wind of the spill/release, isolate immediate hazard area and keep unauthorised personnel out.

notify persons down wind of the spill/release, isolate immediate hazard area and keep unauthorised personnel out

Stop and contain spill/release if it can be done safely. Prevent spilled material from entering sewers, storm drains, other unauthorised drainage systems, and natural waterways. Use water sparingly to minimize environmental contamination and reduce disposal requirements.

Absorb spill with inert material such as sand or vermiculite, and place in suitable container for disposal.

Materials: sand or vermiculite

Keep away from flames and hot surfaces. Wash thoroughly after handling. Use good personal hygiene practices and wear appropriate personal protective equipment (see section 8). Spills will produce very slippery surfaces. Do not wear contaminated clothing or shoes. Do not enter confined spaces such as tanks or pits without following proper entry procedures.

Keep container(s) tightly closed and properly labeled. Use and store this material in cool, dry, well-ventilated area away from heat and all sources of ignition. Store only in approved containers. Keep away from any incompatible material. Protect container(s) against physical damage. Outdoor or detached storage is preferred. Indoor storage should meet Country or Committee standards and appropriate fire codes.

Wash thoroughly after handling. Use good personal hygiene practices. Do not wear contaminated clothing or shoes.

Keep away from flames and hot surfaces.

If current ventilation practices are not adequate to maintain airborne concentrations below the established exposure limits, additional engineering controls may be required.

The use of skin protection is not normally required; however, good industrial hygiene practise suggests the use of gloves or other appropriate skin protection meeting EN 374 whenever working with chemicals. Suggested protective materials: Nitrile rubber.

The use of eye/face protection is not normally required; however, good industrial hygiene practise suggests the use of eye protection that meets or exceeds EN 166 whenever working with chemicals.

Where there is potential for airborne exposure above the exposure limit an approved air purifying respirator equipped with Type P2 - Medium efficiency particle filters may be used. A respiratory protection programme that follows recommendations for the selection, use, care and maintenance of respiratory protective devices in EN 529:2005 should be followed whenever workplace conditions warrant a respirator's use. Air purifying respirators provide limited protection and cannot be used in atmospheres that exceed the maximum use concentration (as directed by regulation or the manufacturer's instructions), in oxygen deficient (less than 19.5 percent oxygen) situations, or under conditions that are immediately dangerous to life and health.

The use of skin protection is not normally required; however, good industrial hygiene practise suggests the use of gloves or other appropriate skin protection meeting EN 374 whenever working with chemicals.

Refer to Sections 6, 7, 12 and 13.

Stable under normal ambient and anticipated conditions of use.

Not chemically reactive.

Hazardous reactions not anticipated.

Extended exposure to high temperatures can cause decomposition. Avoid all possible sources of ignition.

Avoid contact with strong oxidizing agents and strong reducing agents.

Not anticipated under normal conditions of use.

Whenever possible, Directive 75/439/EEC suggests recycling of 'waste oils' in accordance with current national and regional provisions.

This material, if discarded as produced, would be considered as hazardous waste pursuant to Directive 2008/98/EC on hazardous waste, and subject to the provisions of that Directive unless Article 1(5) of that Directive applies.

If transported in bulk by marine vessel in international waters, product is being carried under the scope of MARPOL Annex I.