PURITY™ 1810 BASE OIL

Move to fresh air. Artificial respiration and/or oxygen may be necessary. Seek medical advice.

In case of contact, immediately flush skin with plenty of water for at least 15 minutes while removing contaminated clothing and shoes. Wash skin thoroughly with soap and water or use recognized skin cleanser. Wash clothing before reuse. Seek medical advice.

Remove contact lenses. Rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes. Obtain medical attention.

Rinse mouth with water. DO NOT induce vomiting unless directed to do so by a physician or poison control center. Never give anything by mouth to an unconscious person. Seek medical advice.

Use extinguishing measures that are appropriate to local circumstances and the surrounding environment. Foam, Water fog, Dry chemical, Dry powder, Carbon dioxide (CO2), Sand

Do NOT use water jet.

Cool closed containers exposed to fire with water spray.

Mark the contaminated area with signs and prevent access to unauthorized personnel.

Do not allow uncontrolled discharge of product into the environment.

Soak up with inert absorbent material.

Materials: inert absorbent material

For personal protection see section 8. Smoking, eating and drinking should be prohibited in the application area. Use only with adequate ventilation. In case of insufficient ventilation, wear suitable respiratory equipment. Avoid contact with skin, eyes and clothing. Do not ingest. Keep away from heat and sources of ignition. Keep container closed when not in use.

Store in original container. Containers which are opened must be carefully resealed and kept upright to prevent leakage. Keep in a dry, cool and well-ventilated place. Keep in properly labelled containers. To maintain product quality, do not store in heat or direct sunlight.

Remove and wash contaminated clothing and gloves, including the inside, before re-use. Wash face, hands and any exposed skin thoroughly after handling.

Keep away from heat and sources of ignition.

No special ventilation requirements. Good general ventilation should be sufficient to control worker exposure to airborne contaminants.

Material : neoprene, nitrile, polyvinyl alcohol (PVA), Viton®. Remarks : Chemical-resistant, impervious gloves complying with an approved standard should be worn at all times when handling chemical products if a risk assessment indicates this is necessary.

Wear face-shield and protective suit for abnormal processing problems.

Use respiratory protection unless adequate local exhaust ventilation is provided or exposure assessment demonstrates that exposures are within recommended exposure guidelines. Respirator selection must be based on known or anticipated exposure levels, the hazards of the product and the safe working limits of the selected respirator. Filter type : organic vapour filter

Choose body protection in relation to its type, to the concentration and amount of dangerous substances, and to the specific work-place.

Stable under normal conditions.

No dangerous reaction known under conditions of normal use.

Hazardous polymerisation does not occur.

No data available

Reactive with oxidising agents.

May release COx, smoke and irritating vapours when heated to decomposition.

Send to a licensed waste management company.

Offer surplus and non-recyclable solutions to a licensed disposal company. Dispose of product residue in accordance with the instructions of the person responsible for waste disposal.