PB2400

If inhaled, remove to fresh air. Perform artificial respiration if stop breathing. Use supplied-oxygen respirator if difficulty in breathing. Call a physician if necessary.

Symptoms: Exposure to aerosols or particulates from heated material may cause adverse lung effects if high concentrations are inhaled.

Heated material : Remove immediately all contaminated clothing, flush the contact part with cool water at least 15 min. Call a physician. Refrigerated material : Flush contaminated part with plenty of water and soap completely. Wash contaminated clothing before reuse. If experiencing symptoms, get medical advice.

Symptoms: May causes irritation slightly if contact with skin. Repeated exposure may cause skin dryness or cracking. Heated material can cause thermal burns.

Heated material : Immediately flush eyes with plenty of water at least 15 min. If on eyes, get medical advice for removing this material. Refrigerated material : Immediately flush eyes with plenty of water or saline solution till remove perfectly. If eye irritation persists, get medical advice.

Do not induce vomiting. Lay the patient down as head would be lower than body for suffocation prevention if occur vomiting. Do not give anything to mouth if patient is unconscious. Rinse the mouth and give 2~4 glasses of milk or water if patient is conscious. If patient be conscious, rinse the mouth. Call a physician if necessary. If large quantities of this material are swallowed, call a physician immediately.

Symptoms: May occur stomach stimulus and diarrhea if ingestion.

Chemical powder, CO2, Water fog, foam. Use normal extinguisher, water spray in conflagration.

indoor or outdoor hydrant facilities, sprinkler, water jet

Irritating and highly toxic gases, carbon oxides such as carbon dioxide, carbon monoxide may be generated by thermal decomposition or combustion. During a fire, thermal depolymerization may produce flammable vapor.

Move container from fire area if it can be done without risk. Do not scatter spilled material with high-pressure water streams. Fire may be spread by water use. Do not inhale the material or its combustion products. Go against the wind and keep out of low areas.

Stop leak if safe to do so.

absorb spilled material with sand or non-combustible material.

dike spilled material or otherwise contain material to ensure runoff dose not reach a waterway.

Avoid dispersal of spilt material and runoff and contact with waterways, drains and sewers.

Place absorbent and other waste in an appropriate container for disposal.

Materials: sand or non-combustible material

Perform in accordance with『See section ８. EXPOSURE CONTROLS/PERSONAL PROTECTION』. Put on appropriate personal protective equipment. Do not breathe vapour or mist when using this material. Avoid prolonged or repeated contact with skin. Avoid contact with eyes. Wash thoroughly after handling. Empty containers may contain harmful, flammable/combustible or explosive residue or vapors.

Keep container tightly closed in a cool, well-ventilated place. Keep container tightly closed before use.

Wash thoroughly after handling.

Keep away from open flames, shut off the production of source of ignition (electricity∙static electricity sparks∙heat∙material of high-temperature). Keep away from heat, sparks, open flames, source of ignition.

A system of local and/or general exhaust is recommended to keep employee exposures above the Exposure Limits. Local exhaust ventilation is generally preferred because it can control the emissions of the contaminant at its source, preventing dispersion of it into the general work area. The use of local exhaust ventilation is recommended to control emissions near the source.

Wear chemical resistant protected gloves if there is hazard potential for direct skin contact. Wear heat resistant protected gloves to withstand the temperature of molten product.

Wear primary eye protection such as splash resistant safety goggles with a secondary protection faceshield.

Use the respirator be given official approval by Occupational Safety and Health Administration. Under conditions of frequent use or heavy exposure, Respiratory protection may be needed. Respiratory protection is ranked in order from minimum to maximum. Consider warning properties before use. ※ When take shelter - Any chemical cartridge respirator with organic vapour cartridge(s). - Any chemical cartridge respirator with a full facepiece and organic vapour cartridge(s). - Any air-purifying respirator with a full facepiece and an organic vapour canister. ※ For Unknown Concentration or Immediately Dangerous to Life or Health - Self-contained breathing apparatus(pressure-demand or other positive-pressure mode in combination), supplied-air respirator with full face piece

Wear chemical resistant protected clothing if there is hazard potential for direct contact.

This material is stable under recommended storage and handling conditions

May not occur under normal temperature and pressure.

Avoid to heat, open flames, sparks and other source of ignition. Avoid to contact with incompatible materials.

Strong oxidizing agent : Hazard of fire and explosion

Combustion may produce carbon oxides such as carbon monoxide, carbon dioxide. During a fire, thermal depolymerization may produce flammable vapour.

The user of this product must disposal by oneself or entrust to waste disposer or person who other’s waste recycle and dispose, person who establish and operate waste disposal facilities.

The user of this product must properly characterize the waste/container generated from the use of this product in accordance with all applicable federal, state and/or local laws and regulations in order to determine the proper disposal of the waste in accordance with all applicable federal, state and/or local laws and regulations.

Local transport follows in accordance with Dangerous goods Safety Management Law. Package and transport follow in accordance with Department of Transportation (DOT) and other regulatory agency requirements.

Local transport follows in accordance with Dangerous goods Safety Management Law. Package and transport follow in accordance with Department of Transportation (DOT) and other regulatory agency requirements.

Local transport follows in accordance with Dangerous goods Safety Management Law. Package and transport follow in accordance with Department of Transportation (DOT) and other regulatory agency requirements.