Monoethanolamine pure

Keep patient calm, remove to fresh air, seek medical attention. Immediately administer a corticosteroid from a controlled/metered dose inhaler.

Immediately wash thoroughly with plenty of water, apply sterile dressings, consult a skin specialist.

Immediately wash affected eyes for at least 15 minutes under running water with eyelids held open, consult an eye specialist.

Immediately rinse mouth and then drink 200-300 ml of water, seek medical attention.

water spray, dry powder, carbon dioxide, alcohol-resistant foam

water jet

nitrogen oxides, carbon oxides. The substances/groups of substances mentioned can be released in case of fire. Under certain conditions in case of fire other hazardous combustion products may be generated.

Avoid inhalation. Avoid contact with the skin, eyes and clothing.

Pick up with suitable absorbent material. Do not use saw-dust or other combustible substances as an absorbant during cleanup.

Pump off product.

Do not discharge into drains/surface waters/groundwater.

Clean contaminated floors and objects thoroughly with water and detergents, observing environmental regulations.

Materials: suitable absorbent material, water and detergents

Handle in accordance with good industrial hygiene and safety practice. When using do not eat, drink or smoke. Hands and/or face should be washed before breaks and at the end of the shift.

Avoid extreme heat. Keep container tightly closed and in a well-ventilated place. Keep away from sources of ignition - No smoking.

When using do not eat, drink or smoke. Hands and/or face should be washed before breaks and at the end of the shift.

The product is combustible. Prevent electrostatic charge - sources of ignition should be kept well clear - fire extinguishers should be kept handy.

Chemical resistant protective gloves (EN 374) Suitable materials also with prolonged, direct contact (Recommended: Protective index 6, corresponding > 480 minutes of permeation time according to EN 374): e.g. nitrile rubber (0.4 mm), chloroprene rubber (0.5 mm), polyvinylchloride (0.7 mm) and other Manufacturer's directions for use should be observed because of great diversity of types. Supplementary note: The specifications are based on tests, literature data and information of glove manufacturers or are derived from similar substances by analogy. Due to many conditions (e.g. temperature) it must be considered, that the practical usage of a chemical-protective glove in practice may be much shorter than the permeation time determined through testing.

Tightly fitting safety goggles (cage goggles) (e.g. EN 166) and face shield.

Respiratory protection in case of vapour/aerosol release. Gas filter for gases/vapours of organic compounds (boiling point >65 °C, e. g. EN 14387 Type A)

Body protection must be chosen depending on activity and possible exposure, e.g. apron, protecting boots, chemical-protection suit (according to EN 14605 in case of splashes or EN ISO 13982 in case of dust).

The product is stable if stored and handled as prescribed/indicated.

No hazardous reactions if stored and handled as prescribed/indicated. Corrosion to metals: Corrosive effect on: copper alloys copper

Reacts with oxidizing agents. The progress of reaction is exothermic. Reacts with acids. Reacts with halogenated compounds. Reacts with acid chlorides.

Avoid extreme temperatures. See MSDS section 7 - Handling and storage.

Incompatible with acid chlorides and acid anhydrides.

carbon oxides, nitrogen oxides, nitrous gases

Incinerate in suitable incineration plant, observing local authority regulations.

Incinerate in suitable incineration plant, observing local authority regulations.

Tunnel code: E