MOBILUX EP 2

Wash contact areas with soap and water.

Symptoms: initial symptoms from high pressure injection may be minimal or absent

Flush thoroughly with water.

Symptoms: irritation

First aid is normally not required. Seek medical attention if discomfort occurs.

Symptoms: discomfort

Use water fog, foam, dry chemical or carbon dioxide (CO2) to extinguish flames.

Straight Streams of Water

Evacuate area. Prevent runoff from fire control or dilution from entering streams, sewers, or drinking water supply. Use water spray to cool fire exposed surfaces and to protect personnel.

Avoid contact with spilled material. See Section 5 for fire fighting information. See the Hazard Identification Section for Significant Hazards. See Section 4 for First Aid Advice. See Section 8 for advice on the minimum requirements for personal protective equipment.

Normal antistatic work clothes are usually adequate.

Full body suit of chemical resistant, antistatic material is recommended.

Prevent entry into waterways, sewers, basements or confined areas.

Allow spilled material to solidify and scrape up with shovels into a suitable container for recycle or disposal.

Materials: shovels

Prevent small spills and leakage to avoid slip hazard.

Do not store in open or unlabelled containers.

No special requirements under ordinary conditions of use and with adequate ventilation.

No protection is ordinarily required under normal conditions of use.

If contact is likely, safety glasses with side shields are recommended.

If engineering controls do not maintain airborne contaminant concentrations at a level which is adequate to protect worker health, an approved respirator may be appropriate. For high airborne concentrations, use an approved supplied-air respirator, operated in positive pressure mode. Supplied air respirators with an escape bottle may be appropriate when oxygen levels are inadequate, gas/vapor warning properties are poor, or if air purifying filter capacity/rating may be exceeded.

No skin protection is ordinarily required under normal conditions of use. In accordance with good industrial hygiene practices, precautions should be taken to avoid skin contact.

Comply with applicable environmental regulations limiting discharge to air, water and soil. Protect the environment by applying appropriate control measures to prevent or limit emissions.

Material is stable under normal conditions.

See sub-sections below.

Hazardous polymerization will not occur.

Excessive heat. High energy sources of ignition.

Strong oxidizers

Material does not decompose at ambient temperatures.

burning in an enclosed controlled burner for fuel value or disposal by supervised incineration at very high temperatures to prevent formation of undesirable combustion products

Product is suitable for burning in an enclosed controlled burner for fuel value or disposal by supervised incineration at very high temperatures to prevent formation of undesirable combustion products.