WACKER® RTV-S 691 A

Provide fresh air.

Wash with plenty of water or water and soap. In the event of a visible skin change or other complaints, seek medical advice (show label or SDS where possible).

Rinse immediately with plenty of water. Seek medical advice in case of continuous irritation.

Give several small portions of water to drink. Do not induce vomiting.

water mist, extinguishing powder, alcohol-resistant foam, carbon dioxide, sand.

water jet.

Risk of hazardous gasses or fumes in the event of fire. Exposure to combustion products may be a health hazard!

Secure the area. Keep unprotected persons away. If material is released indicate risk of slipping. Do not walk through spilled material.

Scoop up large quantities after dusting surfaces with sand or Fuller's earth to prevent sticking.

Prevent material from entering surface waters, drains or sewers and soil. Close leak if possible without risk. Retain contaminated water/extinguishing water. Dispose of in prescribed marked containers.

Sweep or scrape up the spilled material and place in an appropriate chemical waste container. Clean any slippery coating that remains using a detergent / soap solution or another biodegradable cleaner. Apply sand or other inert granular material to improve traction.

Materials: detergent / soap solution or another biodegradable cleaner, sand or other inert granular material

Stir thoroughly before use or catalysing. Observe information in section 8.

Store in a dry and cool place.

Observe the general rules for fire prevention.

Use of protective gloves is recommended when handling the material. Recommended glove types: Protective gloves made of nitrile rubber thickness of the material: > 0,1 mm Breakthrough time: > 480 min Recommended glove types: Protective gloves made of butyl rubber thickness of the material: > 0,3 mm Breakthrough time: > 480 min Please observe the instructions regarding permeability and breakthrough time which are provided by the supplier of the gloves. Also take into consideration the specific local conditions under which the product is used, such as the danger of cuts, abrasion, and the contact time. Note that, due to the numerous external influences (such as temperature), a chemically resistant protective glove in daily use may have a service life that is considerably shorter than the measured break through time.

Recommendation: protective goggles.

No personal respiratory protective equipment normally required.

Prevent material from entering surface waters, drains or sewers and soil.

If stored and handled in accordance with standard industrial practices no hazardous reactions are known.

If stored and handled in accordance with standard industrial practices no hazardous reactions are known.

If stored and handled in accordance with standard industrial practices no hazardous reactions are known.

none known

none known

If stored and handled properly: none known. Measurements have shown the formation of small amounts of formaldehyde at temperatures above about 150 °C (302 °F) through oxidation. Measurements have shown the formation of small amounts of benzene at temperatures above about 180 °C (356 °F).

landfill or incineration

Material that cannot be used, reprocessed or recycled should be disposed of in accordance with Federal, State, and local regulations at an approved facility.