Polyclar™ BREWBRITE beverage clarifier

If breathed in, move person into fresh air. If unconscious, place in recovery position and seek medical advice. If symptoms persist, call a physician.

First aid is not normally required. However, it is recommended that exposed areas be cleaned by washing with soap and water.

Remove contact lenses. Protect unharmed eye.

Do not give milk or alcoholic beverages. Never give anything by mouth to an unconscious person. If symptoms persist, call a physician.

Use extinguishing measures that are appropriate to local circumstances and the surrounding environment. Water spray Foam

Organic dusts at sufficient concentration can form explosive mixtures in air. Do not allow run-off from fire fighting to enter drains or water courses.

Standard procedure for chemical fires.

Persons not wearing protective equipment should be excluded from area of spill until clean-up has been completed. Comply with all applicable federal, state, and local regulations.

Prevent further leakage or spillage if safe to do so.

Pick up and arrange disposal without creating dust. Keep in suitable, closed containers for disposal.

Avoid dust formation. Smoking, eating and drinking should be prohibited in the application area. Maintain good housekeeping. Do not permit dust layers to accumulate, for example, on floors, ledges, and equipment, in order to avoid any potential for dust explosion hazards. Avoid breathing dust.

No smoking. areas and containers

Smoking, eating and drinking should be prohibited in the application area. Avoid breathing dust.

Take measures to prevent the build up of electrostatic charge. Ensure all equipment is electrically grounded and bonded before beginning transfer operations.

Provide appropriate exhaust ventilation at places where dust is formed. General room ventilation should be adequate for normal conditions of use. However, if unusual operating conditions exist, provide sufficient mechanical (general and/or local exhaust) ventilation to maintain exposure below exposure guidelines (if applicable) or below levels that cause known, suspected or apparent adverse effects.

Material : butyl-rubber Break through time : 480 min Glove thickness : > 0,5 mm Remarks : The exact break through time can be obtained from the protective glove producer and this has to be observed. Gloves should be discarded and replaced if there is any indication of degradation or chemical breakthrough. The selected protective gloves have to satisfy the specifications of Regulation (EU) 2016/425 and the standard EN 374 derived from it.

Safety glasses Use eye protection according to EN 166.

In the case of dust or aerosol formation use respirator with an approved filter within the capabilities of the respirator/filter combination. Where concentrations are above recommended limits or are unknown, or a cartridge type respirator is not adequate, wear a positive-pressure supplied-air respirator. Respiratory protection complying with EN 136. Respiratory protection complying with EN 140. Respiratory protection complying with EN 14387.

Wear as appropriate: Safety shoes Protective clothing complying with EN 13688. Safety shoes complying with EN ISO 20345.

Stable under recommended storage conditions.

No decomposition if stored and applied as directed.

Dust may form explosive mixture in air.

Keep away from heat, flame, sparks and other ignition sources.

None known. Strong oxidizing agents, strong reducing agents

Carbon monoxide, Carbon dioxide (CO2), Nitrogen oxides (NOx)