Cutimed PROTECT Spray

Remove affected person from the immediate area. Ensure supply of fresh air.

When in contact with the skin, clean with soap and water.

Separate eyelids, wash the eyes thoroughly with water (15 min.).

Call in a physician immediately and show him the Safety Data Sheet.

Extinguishing powder; Sand; Alcohol-resistant foam; Carbon dioxide

Water

In the event of fire, the following can be released: Carbon monoxide (CO); Carbon dioxide (CO2)

Cool endangered containers with water spray jet. Suppress gases/vapours/mists with water spray jet.

Refer to protective measures listed in sections 7 and 8. Avoid contact with skin, eyes and clothing. Ensure adequate ventilation. Keep away sources of ignition.

Do not discharge into the drains/surface waters/groundwater.

Pick up with absorbent material. Send in suitable containers for recovery or disposal.

Materials: sand, kieselguhr, acid binder, universal binder, sawdust

Provide good ventilation at the work area (local exhaust ventilation, if necessary). If workplace exposure limits are exceeded, respiratory protection approved for this particular job must be worn. Product inherent handling risks must be minimised taking the appropriate measures for protection and preventive actions. The working process should be designed to rule out the release of hazardous substances or skin contact as far it is possible by the state of the art.

Keep container tightly closed and dry in a cool, well-ventilated place. Protect from heat and direct sunlight.

Do not eat, drink or smoke during work time. Keep away from foodstuffs and beverages. Avoid contact with eyes and skin. Remove soiled or soaked clothing immediately. Do not inhale vapours. Wash hands before breaks and after work.

Keep away from sources of heat and ignition.

Sufficient protection is given wearing suitable protective gloves checked according to i.e. EN 374, in the event of risk of skin contact with the product. Before use, the protective gloves should be tested in any case for its specific work-station suitability (i.e. mechanical resistance, product compatibility and antistatic properties). Adhere to the manufacturer's instructions and information relating to the use, storage, care and replacement of protective gloves. Protective gloves shall be replaced immediately when physically damaged or worn. Design operations thus to avoid permanent use of protective gloves.

Safety glasses (EN 166)

If workplace exposure limits are exceeded, a respiration protection approved for this particular job must be worn. In case of aerosol and mist formation, take appropriate measures for breathing protection in the event workplace threshold values are not specified.

Normal chemical work clothing.

Stable under recommended storage and handling conditions (See section 7).

No data available.

Dangerous reactions are not to be expected when handling product according to its intended use.

Heat, naked flames and other ignition sources.

Oxidizing agents; Acids; Bases

None, if handled according to intended use.

Allocation of a waste code number, according to the European Waste Catalogue, should be carried out in agreement with the regional waste disposal company.

Allocation of a waste code number, according to the European Waste Catalogue, should be carried out in agreement with the regional waste disposal company.