Ethanol absolute for analysis EMSURE® ACS, ISO, Reag. Ph Eur

fresh air.

wash off with plenty of water. Remove contaminated clothing.

rinse out with plenty of water with the eyelid held wide open. Call in ophthalmologist if necessary.

immediately make victim drink water (two glasses at most). Consult doctor in the event of any complaints. Never give anything by mouth to an unconscious person.

Carbon dioxide (CO2), Foam, Dry powder, Water

For this substance/mixture no limitations of extinguishing agents are given.

Combustible material, Vapors are heavier than air and may spread along floors. Forms explosive mixtures with air at ambient temperatures. Pay attention to flashback.

Remove container from danger zone and cool with water.

Evacuate the danger area, observe emergency procedures, consult an expert.

Do not empty into drains. Risk of explosion.

Take up with liquid-absorbent material (e.g. Chemizorb®). Clean up affected area.

Materials: liquid-absorbent material (e.g. Chemizorb®)

Observe label precautions.

Keep container tightly closed in a dry and well-ventilated place. Keep away from heat and sources of ignition. Storage temperature: no restrictions.

Keep away from open flames, hot surfaces and sources of ignition.

Technical measures and appropriate working operations should be given priority over the use of personal protective equipment.

Chemical-resistant, impervious gloves complying with an approved standard should be worn at all times when handling chemical products if a risk assessment indicates this is necessary. Recommended: full contact: Glove material: butyl-rubber Glove thickness: 0.7 mm Break through time: > 480 min splash contact: Glove material: Nitrile rubber Glove thickness: 0.40 mm Break through time: > 120 min

Safety glasses

required when vapors/aerosols are generated. Use a properly fitted, air-purifying or air-fed respirator complying with an approved standard if a risk assessment indicates this is necessary. Respirator selection must be based on known or anticipated exposure levels, the hazards of the product and the safe working limits of the selected respirator.

Protective clothing should be selected specifically for the workplace, depending on concentration and quantity of the hazardous substances handled. The chemical resistance of the protective equipment should be inquired at the respective supplier. Other protective equipment: Flame retardant antistatic protective clothing

The product is chemically stable under standard ambient conditions (room temperature).

Vapors may form explosive mixture with air.

Risk of explosion with:, Risk of ignition or formation of inflammable gases or vapors with: chromium(VI) oxide, hydrogen peroxide, uranium hexafluoride, nitrogen dioxide, Nitric acid, Oxides of phosphorus, permanganic acid, perchloric acid, sulfuric acid, potassium permanganate, perchlorates, Fluorine, Ethylene oxide, chromyl chloride, halogen-halogen compounds, Strong oxidizing agents, alkali oxides, Alkaline earth metals, Alkali metals

Warming. A range from approx. 15 Kelvin below the flash point is to be rated as critical.

rubber, various plastics

no information available

The information presented only applies to the material as supplied. The identification based on characteristic(s) or listing may not apply if the material has been used or otherwise contaminated. It is the responsibility of the waste generator to determine the toxicity and physical properties of the material generated to determine the proper waste identification and disposal methods in compliance with applicable regulations.

yes

no