Sika® Permacor®-2230 VHS Part A

Move to fresh air. Consult a physician after significant exposure.

Take off contaminated clothing and shoes immediately. Wash off with soap and plenty of water. If symptoms persist, call a physician.

Symptoms: May cause an allergic skin reaction.

Remove contact lenses. Keep eye wide open while rinsing. If eye irritation persists, consult a specialist.

Do not induce vomiting without medical advice. Rinse mouth with water. Do not give milk or alcoholic beverages. Never give anything by mouth to an unconscious person.

Alcohol-resistant foam, Carbon dioxide (CO2), Dry chemical

Water, High volume water jet

Do not use a solid water stream as it may scatter and spread fire.

Use personal protective equipment. Remove all sources of ignition. Deny access to unprotected persons. Beware of vapours accumulating to form explosive concentrations. Vapours can accumulate in low areas.

Prevent product from entering drains.

collect with non-combustible absorbent material, and place in container for disposal according to local / national regulations (see section 13)

Materials: non-combustible absorbent material (e.g. sand, earth, diatomaceous earth, vermiculite)

Do not breathe vapours or spray mist. Avoid exceeding the given occupational exposure limits. Do not get in eyes, on skin, or on clothing. Persons with a history of skin sensitisation problems or asthma, allergies, chronic or recurrent respiratory disease should not be employed in any process in which this mixture is being used. Smoking, eating and drinking should be prohibited in the application area. Take precautionary measures against static discharge. Open drum carefully as content may be under pressure. Take necessary action to avoid static electricity discharge (which might cause ignition of organic vapours).

Keep container tightly closed in a dry and well-ventilated place. Store in accordance with local regulations.

Handle in accordance with good industrial hygiene and safety practice. When using do not eat or drink. When using do not smoke. Wash hands before breaks and at the end of workday.

Keep away from heat/sparks/open flames/hot surfaces. No smoking. Take precautionary measures against electrostatic discharges.

Ensure adequate ventilation. This can be achieved by local exhaust extraction or by general ventilation. (EN 689 - Methods for determining inhalation exposure). This applies in particular to the mixing / stirring area. In case this is not sufficient to keep the concentrations under the occupational exposure limits then respiration protection measures must be used.

Chemical-resistant, impervious gloves complying with an approved standard must be worn at all times when handling chemical products. Reference number EN 374. Follow manufacturer specifications. Suitable for short time use or protection against splashes: Butyl rubber/nitrile rubber gloves (0,4 mm) Contaminated gloves should be removed. Suitable for permanent exposure: Viton gloves (0.4 mm), breakthrough time >30 min.

Safety glasses with side-shields conforming to EN166 Eye wash bottle with pure water

In case of inadequate ventilation wear respiratory protection. Respirator selection must be based on known or anticipated exposure levels, the hazards of the product and the safe working limits of the selected respirator. organic vapor (Type A) and particulate filter A1: < 1000 ppm; A2: < 5000 ppm; A3: < 10000 ppm P1: Inert material; P2, P3: hazardous substances

Protective clothing (e.g. Safety shoes acc. to EN ISO 20345, long-sleeved working clothing, long trousers). Rubber aprons and protective boots are additionally recommended for mixing and stirring work.

Prevent product from entering drains. If the product contaminates rivers and lakes or drains inform respective authorities.

The product is chemically stable.

No dangerous reaction known under conditions of normal use.

Vapours may form explosive mixture with air.

Heat, flames and sparks.

Oxidizing agents

No decomposition if stored and applied as directed.

In accordance with the EWC Waste Regulation the classification of waste is to be assigned to the jurisdiction of the origin of waste.

It is not possible to assign a particular waste identification number.