NextSDS Logo
Safety Data Sheet EN

STARKE TRIPLE P PRIMER POLISH

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report.

Get Free Audit
01

Identification

Product identifiers, regulatory numbers, and supplier information

Product Information

Product Name
STARKE TRIPLE P PRIMER POLISH
Chemical Name
Mixture
Synonyms
Triple P Primer Polish

Regulatory Identifiers

CAS Number
N/A

Identified Uses

Polish compound

Manufacturers & Suppliers

S

Starke Yacht Surface Technologies

distributor

17000 Alico Commerce Ct., Suite 101, Fort Myers, FL 33912

+1 (800) 203-5315

Emergency Contacts

John Watkins

+1 (239) 851-6030

02

Hazard Identification

GHS classification, signal word, pictograms, and hazard statements

Classified danger

Hazard Classifications

Asp. Tox. Cat. 1 H304
Eye Irrit. Cat. 2A H319

GHS Pictograms

GHS08 - Serious health hazard

GHS08

GHS07 - Health hazard

GHS07

Hazard Statements

H304 May be fatal if swallowed and enters the airways.
H319 Causes serious eye irritation.

Precautionary Statements

P260 Do not breathe dust/fume/gas/mist/vapor spray.
P262 Do not get in eyes, on skin, or on clothing.
P264 Wash thoroughly with soap and water after handling.
P301+P310 IF SWALLOWED: Immediately call a POISOIN CENTER/doctor.
P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
P331 Do NOT induce vomiting.
P337+P313 If eye irritation persists: Get medical advice/attention.
P405 Store locked up.
P501 Dispose of contents/container to a licensed treatment, storage or disposal facility (TSDF).

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report

Free Audit
03

Composition / Information on Ingredients

Chemical components, concentration ranges, and hazardous substance identification

Chemical Name CAS Number Concentration Hazardous
PROPRIETARY --- --- No
DISTILLATES (PETROLEUM), HYDROTREATED LIGHT EC: 265-149-8 64742-47-8 10 - 25% No
ODORLESS MINERAL SPIRIT* EC: 265-150-3 64742-48-9 1 - 5% Yes
UNDECAN-1-OL, ETHOXYLATED EC: 500-084-3 34398-01-1 1 - 5% Yes
CMIT/MIT MIXTURE 55965-84-9 1% Yes
04

First Aid Measures

Emergency procedures for chemical exposure incidents

Inhalation

Remove victim to fresh air at once.

Symptoms: None expected.

Skin contact

rinse thoroughly with lukewarm water, followed by a thorough washing of the affected area with soap and water.

Symptoms: May be irritating to skin. The product can cause allergic skin reactions (e.g., rashes, welts, dermatitis) in some sensitive individuals. Symptoms of skin overexposure may include redness, itching, and irritation of affected areas.

Eye contact

flush with copious amounts of lukewarm water for at least 15 minutes.

Symptoms: Moderately irritating to the eyes. Symptoms of overexposure may include redness, itching, irritation and watering.

Ingestion

If ingested, do not induce vomiting. If product has been swallowed, drink plenty of water or milk IMMEDIATELY. If the patient is vomiting, continue to offer water or milk. Never give water or milk to an unconscious person. Contact the nearest Poison Control Center or local emergency number. Provide an estimate of the time at which the material was ingested and the amount of the substance that was swallowed.

Symptoms: Nausea, intestinal discomfort, vomiting and/or diarrhea.

Immediate Medical Attention

If irritation occurs, contact a physician. If irritation, redness or swelling persists, contact a physician immediately. Contact the nearest Poison Control Center or local emergency number.

05

Firefighting Measures

Extinguishing media, specific hazards, and firefighter protection

The data for this section has not been processed yet.

06

Accidental Release Measures

Spill cleanup procedures, containment, and environmental protection

The data for this section has not been processed yet.

Related Products

Similar products with comparable safety profiles

07

Handling and Storage

Safe handling precautions, storage conditions, and workplace requirements

The data for this section has not been processed yet.

08

Exposure Controls / PPE

Occupational exposure limits, engineering controls, and protective equipment

Engineering

Provide appropriate local exhaust ventilation on open containers. When using keep the product moist at all times. Use in an enclosed process area is recommended. Use in a well-ventilated area. Do not use in a confined area or areas with little or no air movement.

Hands

AVOID SKIN CONTACT . Select and use gloves and/or protective clothing to prevent skin contact based on the results of an exposure assessment. Consult with your glove and/or protective clothing manufacturer for selection of appropriate compatible materials. Gloves made from the following material(s) are recommended: Nitrile Rubber. If necessary, refer to U.S. OSHA 29 CFR 1910.138, the appropriate standards of Canada, of the E.C. member states.

Eyes

AVOID EYE CONTACT . Wear safety glasses. If necessary, refer to U.S. OSHA 29 CFR 1910.133, Canadian standards, or the European Standard EN166.

Respiratory

Avoid breathing of vapors, mists or spray. No special respiratory protection is required under typical circumstances of use or handling. If necessary, use only respiratory protection authorized per U.S. OSHA's requirement in 29 CFR 1910.134, or applicable U.S. state regulations, or the appropriate standards of Canada, its provinces, E.C. member states, or Australia.

Skin/Body

No special body protection is required under typical circumstances of use and handling. If necessary, refer to appropriate standards of Canada, the E.C. member states, or U.S. OSHA.

09

Physical and Chemical Properties

Appearance, physical state, melting point, boiling point, and material characteristics

Solubility In Water
---
Explosive Limits
---
Boiling Point
100C (212 F)
Relative Evaporation Rate
---
Appearance
Light orange viscous liquid
Molecular Weight
---
Partition Coefficient
---
Decomposition Temperature
---
Freezing Point
---
Cloud Point
---
Solubility
---
Bulk Density
---
Relative Density
1.096 @ 25C
Density
---
Softening Point
---
Metal Corrosion
---
Solubility In Fat
---
Flammability
---
State Under Standard Conditions
---
Kinematic Viscosity
---
Form
viscous liquid
Physical State
liquid
Colour Intensity
---
Physical State Data
liquid
Flash Point
81 C (177.8 F) CC
Melting Point
---
Voc Content
---
Upper Explosive Limit
---
Vapor Pressure
31.69 hPa
Dynamic Viscosity
---
Vapor Density
---
Crystallisation Point
---
Odor Threshold
---
Lower Explosive Limit
---
Evaporation Rate
---
Auto Ignition Temperature
343 C (649.4 F)
Colour
Light orange
Properties Status
---
Ph
8-8.6
Odor
Characteristic
Solidification Point
---
10

Stability and Reactivity

Chemical stability, hazardous reactions, and incompatible materials

The data for this section has not been processed yet.

12

Ecological Information

Environmental toxicity, biodegradation, and bioaccumulation data

The data for this section has not been processed yet.

13

Disposal Considerations

Waste treatment methods, disposal recommendations, and waste codes

The data for this section has not been processed yet.

14

Transport Information

UN numbers, shipping names, transport classes, and regulatory requirements

15

Regulatory Information

Chemical regulations, safety assessments, and compliance status

The data for this section has not been processed yet.

?

Frequently Asked Questions

Common questions about safety, handling, and properties

What other names is STARKE TRIPLE P PRIMER POLISH known by?

STARKE TRIPLE P PRIMER POLISH is also known as: Triple P Primer Polish

What is the hazard signal word for STARKE TRIPLE P PRIMER POLISH?

The signal word is danger.

What is the physical form of STARKE TRIPLE P PRIMER POLISH?

STARKE TRIPLE P PRIMER POLISH is a liquid appearing as light orange viscous liquid with light orange color. It has characteristic odor.

What is STARKE TRIPLE P PRIMER POLISH used for?

Polish compound

What are the hazard statements for STARKE TRIPLE P PRIMER POLISH?

This substance has 2 hazard statements:

  • H304: May be fatal if swallowed and enters the airways.
  • H319: Causes serious eye irritation.