BELZONA 1151 - SMOOTHING METAL - BASE

remove the person affected from the exposure area and provide with fresh air. Seek medical attention if the symptoms get worse or persist.

Remove contaminated clothing and footwear, rinse skin or shower the person affected if appropriate with plenty of cold water and neutral soap. In serious cases see a doctor. If the product causes burns or freezing, clothing should not be removed as this could worsen the injury caused if it is stuck to the skin. If blisters form on the skin, these should never be burst as this will increase the risk of infection.

Rinse eyes thoroughly with lukewarm water for at least 15 minutes. Do not allow the person affected to rub or close their eyes. If the injured person uses contact lenses, these should be removed unless they are stuck to the eyes, in which case this could cause further damage. In all cases, after cleaning, a doctor should be consulted as quickly as possible with the SDS of the product.

Do not induce vomiting, but if it does happen keep the head down to avoid aspiration. Keep the person affected at rest. Rinse out the mouth and throat, as they may have been affected during ingestion.

Chemical protective gloves (Material: Nitrile, Breakthrough time: 10 - 30 min, Thickness: 0.12 mm). Replace the gloves at any sign of deterioration. As the product is a mixture of several substances, the resistance of the glove material can not be calculated in advance with total reliability and has therefore to be checked prior to the application.

Panoramic glasses against splash/projections. Clean daily and disinfect periodically according to the manufacturer's instructions. Use if there is a risk of splashing.

Filter mask for gases and vapours (Filter type: ABEK). Replace when there is a taste or smell of the contaminant inside the face mask. If the contaminant comes with warnings it is recommended to use isolation equipment. Continuous flow compressed air line breathing device (Filter type: ABEK). Replace when an increase in resistence to breathing is observed and/or a smell or taste of the contaminant is detected.

Work clothing (Replace before any evidence of deterioration. For periods of prolonged exposure to the product for professional/industrial users CE III is recommended, in accordance with the regulations in EN ISO 6529:2013, EN ISO 6530:2005, EN ISO 13688:2013, EN 464:1994). Disposable clothing for protection against chemical risks (For professional use only. Clean periodically according to the manufacturer's instructions). Safety footwear for protection against chemical risk (Replace boots at any sign of deterioration).

To comply with environmental protection regulations, it is recommended to prevent any spillage of the product and its container.

see section 9

see section 9

see section 9