LOCTITE LB 8008 C5-A

Move to fresh air. If symptoms persist, seek medical advice.

Rinse with running water and soap. Obtain medical attention if irritation persists.

Symptoms: Redness, inflammation.

Rinse immediately with plenty of running water (for 10 minutes), seek medical attention from a specialist.

Symptoms: Irritation, conjunctivitis.

Rinse mouth, drink 1-2 glasses of water, do not induce vomiting, consult a doctor.

Carbon dioxide, foam, powder

None known

In the event of a fire, carbon monoxide (CO), carbon dioxide (CO2) and nitrogen oxides (NOx) can be released.

Avoid skin and eye contact.

wipe up with paper towel and place in container for disposal.

absorb onto inert absorbent material and place in sealed container for disposal.

Do not let product enter drains.

wipe up with paper towel and place in container for disposal (small spills); absorb onto inert absorbent material and place in sealed container for disposal (large spills).

Materials: paper towel, inert absorbent material

Use only in well-ventilated areas. Avoid skin and eye contact. Prolonged or repeated skin contact should be avoided to minimise any risk of sensitisation.

Store in original containers at 8-21°C (46.4-69.8°F) and do not return residual materials to containers as contamination may reduce the shelf life of the bulk product.

Good industrial hygiene practices should be observed. Do not eat, drink or smoke while working. Wash hands before work breaks and after finishing work.

Ensure adequate ventilation.

Chemical-resistant protective gloves (EN 374). Suitable materials for short-term contact or splashes (recommended: at least protection index 2, corresponding to > 30 minutes permeation time as per EN 374): nitrile rubber (NBR; >= 0.4 mm thickness) Suitable materials for longer, direct contact (recommended: protection index 6, corresponding to > 480 minutes permeation time as per EN 374): nitrile rubber (NBR; >= 0.4 mm thickness) This information is based on literature references and on information provided by glove manufacturers, or is derived by analogy with similar substances. Please note that in practice the working life of chemical-resistant protective gloves may be considerably shorter than the permeation time determined in accordance with EN 374 as a result of the many influencing factors (e.g. temperature). If signs of wear and tear are noticed then the gloves should be replaced.

Wear protective glasses.

An approved mask or respirator fitted with an organic vapour cartridge should be worn if the product is used in a poorly ventilated area. Filter type: A

Wear suitable protective clothing.

Stable under recommended storage conditions.

Reaction with strong acids. Reacts with strong oxidants.

See section reactivity

No decomposition if used according to specifications.

See section reactivity

Oxides of carbon. Hydrocarbons

Cured adhesive: Dispose of as water insoluble non-toxic solid chemical in authorised landfill or incinerate under controlled conditions. Dispose of in accordance with local and national regulations. Contribution of this product to waste is very insignificant in comparison to article in which it is used