Disifin med Surface Disinfectant Tablet

Move to fresh air, rest, half upright position, loosen clothing. Oxygen or artificial respiration if there is difficulty in breathing. Seek medical advice after significant exposure.

Remove contaminated clothing. Wash affected area with plenty of soap and water. Always seek medical advice. Launder clothing before re-use.

Rinse immediately with plenty of water for at least 15 minutes. Eyelids should be held away from the eyeball to ensure thorough rinsing. Always seek medical advice.

When conscious, rinse mouth, give plenty of water to drink. DO NOT induce vomiting. Seek medical advice.

Extinguish with dry chemical, foam, water spray, or carbon dioxide.

None known.

Emits toxic fumes under fire conditions (hydrochloric acid (HCl), nitrous gases (NOx), sulphur dioxide (SO2)).

Evacuate personnel to safe areas. Wear respiratory protection. Avoid contact with spilled material. Avoid breathing dust. Avoid breathing vapours or gas.

Do not allow to enter drains, sewers or watercourses.

Adsorb spillages onto sand, earth or any suitable adsorbent material.

Materials: sand, earth or any suitable adsorbent material.

Use product in accordance with good industrial practices for handling and storing of chemicals.

Store in a cool dry well-ventilated area. Keep container tightly closed.

Not established

Chemical resistant gloves are recommended. If contact with forearms is likely, wear gauntlet –style gloves. CEN standards EN 420 and EN 374 provide general requirements and list of glove types. Any specific glove information provided is based on published literature and glove-manufacturer data. Contact the glove manufacturer for glove selection and breakthrough times for your use conditions. Inspect and replace worn or damaged gloves.

Wear chemical safety glasses with side shields, or splash-proof goggles

If engineering controls do not maintain airborne contaminant concentrations at a level, which is adequate to protect worker health, an approved respirator may be appropriate. Respirator selection, use, and maintenance must be in accordance with regulatory requirements. Types of respirator to be considered for this mixture include: dust mask (respirator with filter P2); half-face filter respirator; Type A filter material CEN standards EN136, EN140 and EN 405 provide respirator masks and EN 149 and EN 143 provide filter recommendations

If contact with forearms is likely, wear gauntlet –style gloves.

See sections 6,7,12,13

Stable under recommended storage conditions. (see section 7).

See 10.4

See 10.4

Unstable in contact with water vapour. Contact with acids liberates toxic gas.

Water vapour, acids.

Chlorine.

Handle in accordance with good industrial hygiene and safety practice. Refer to protective measures listed in sections 7 and 8. Dispose of in accordance with the European Directives on waste and hazardous waste.

Waste must be classified and labelled prior to recycling or disposal. According to the European Waste Catalogue, Waste Codes are not product specific, but application specific. Waste codes should be assigned by the user based on the application for which the product was used.

Not applicable

Not applicable

Not applicable