CleanSEQ®

If product is inhaled, move exposed individual to fresh air. If individual is not breathing, begin artificial respiration immediately and obtain medical attention.

In case of skin contact, flush with copious amounts of water for at least 15 minutes. If pain or irritation occur, obtain medical attention.

If product enters eyes, wash eyes gently under running water for 15 minutes or longer, making sure that the eyelids are held open. If pain or irritation occur, obtain medical attention.

If ingested, wash mouth out with water. If irritation or discomfort occurs, seek medical attention.

For large fires use extinguishing media suitable for surrounding fire. In case of fire use carbon dioxide (CO2), dry chemical, water spray or foam.

No special hazards determined.

No special precautions are necessary. Use good laboratory procedures.

Contain spill to prevent migration. Do not allow the undiluted product to enter sewers/surface or ground water.

Absorb spilled material with an appropriate inert, non-flammable absorbent and dispose according to local regulations.

Materials: appropriate inert, non-flammable absorbent

No special precautions are necessary; use good laboratory procedures.

To maintain product quality, store according to the instructions in the product labeling.

No special engineering controls are required. Use with good general ventilation.

Impervious gloves, such as Nitrile or equivalent, should be worn to prevent skin contact. Refer U.S. OSHA 29 CFR 1910.138, European Standard EN374 or appropriate government standards.

Safety glasses or chemical goggles should be worn to prevent eye contact. Refer U.S. OSHA 29 CFR 1910.133, European Standard EN166 or appropriate government standards.

Under normal conditions, the use of this product should not require respiratory protection.

Impervious gloves, such as Nitrile or equivalent, should be worn to prevent skin contact. Refer U.S. OSHA 29 CFR 1910.138, European Standard EN374 or appropriate government standards.

The product is stable in accordance with recommended storage conditions.

No further relevant information available.

This product contains concentrations of azide below the hazardous level which with repeated contact with lead and copper commonly found in plumbing drains may result in the build up of shock sensitive compounds. Sodium azide forms explosive compounds with heavy metals.

Avoid contact with incompatible materials. Avoid exposure to heat and direct sunlight.

Metals and metallic compounds

No decomposition products posing significant hazards would be expected from this product.

Chemical residues and remains should be routinely handled as special waste. This must be disposed of in compliance with anti-pollution and other laws of the country concerned.

Dispose of waste product, unused product and contaminated packaging in compliance with federal, state and local regulations. If unsure of the applicable requirements, contact the authorities for information.