Identification
Product identifiers, regulatory numbers, and supplier information
Product Information
- Product Name
- ROUNDUP POWERMAX
- Product Code
- 62290410
Regulatory Identifiers
- CAS Number
- N/A
- UFI Code
- JAW1-W0QC-800Y-WSQY
Identified Uses
Herbicide
Uses advised against
See product label for restrictions.
Manufacturers & Suppliers
Bayer CropScience Ltd
national supplier
1st Floor, The Grange Offices, The Grange, Brewery Road, Stillorgan, A94 H2K7 Co. Dublin, Ireland
+353 1 216 3300
Emergency Contacts
Emergency Contact
00800 1020 3333
24 hr
Dublin NPIS
01 809 2166
Hazard Identification
GHS classification, signal word, pictograms, and hazard statements
Hazard Classifications
GHS Pictograms
GHS09
Hazard Statements
Precautionary Statements
Get a free compliance audit
Upload your SDS inventory and get a detailed compliance report
Composition / Information on Ingredients
Chemical components, concentration ranges, and hazardous substance identification
Water soluble granules (SG)
| Chemical Name | CAS Number | Concentration | Hazardous |
|---|---|---|---|
| Glyphosate ammonium salt | 40465-66-5 | 72% | Yes |
| Ethoxylated fatty amidoamine | 1189172-06-2 | 3 - 10% | Yes |
| Alcohols, C16-18, ethoxylated EC: 500-212-8 | 68439-49-6 | 3 - 10% | Yes |
| Sodium sulphite EC: 231-821-4 | 7757-83-7 | 1% | No |
Further information For the full text of the H-Statements mentioned in this Section, see Section 16. Particle characteristics This substance/ mixture does not contain nanoforms
First Aid Measures
Emergency procedures for chemical exposure incidents
Move to fresh air. Keep patient warm and at rest. Call a physician or poison control center immediately.
Wash off immediately with plenty of water for at least 15 minutes. Take off contaminated clothing and shoes immediately. Call a physician or poison control center immediately.
Symptoms: Product dust may be irritating to skin. Hypersensitivity to sulphiting agents., A very small percentage of particularly sensitive people may suffer skin reactions.
Rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes. Remove contact lenses, if present, after the first 5 minutes, then continue rinsing eye. Call a physician or poison control center immediately.
Symptoms: Product dust may be irritating to eyes.
Do NOT induce vomiting. Rinse mouth. Call a physician or poison control center immediately.
Immediate Medical Attention
Call a physician or poison control center immediately.
Medical Treatment
Appropriate supportive and symptomatic treatment as indicated by the patient's condition is recommended.
Firefighting Measures
Extinguishing media, specific hazards, and firefighter protection
Use water spray, alcohol-resistant foam, dry chemical or carbon dioxide.
High volume water jet
In the event of fire the following may be released: Carbon monoxide (CO), Carbon dioxide (CO2), Nitrogen oxides (NOx), Oxides of phosphorus
Keep out of smoke. Fight fire from upwind position. Cool closed containers exposed to fire with water spray.
Firefighter Protection
In the event of fire and/or explosion do not breathe fumes. In the event of fire, wear self-contained breathing apparatus.
Accidental Release Measures
Spill cleanup procedures, containment, and environmental protection
Keep unauthorized people away.
Do not allow to get into surface water, drains and ground water.
Use mechanical handling equipment.
Related Products
Similar products with comparable safety profiles
Handling and Storage
Safe handling precautions, storage conditions, and workplace requirements
Avoid dust formation. Avoid contact with skin, eyes and clothing. Use only in area provided with appropriate exhaust ventilation.
Store in original container. Keep containers tightly closed in a dry, cool and well-ventilated place. Store in a place accessible by authorized persons only. Keep away from direct sunlight. Protect from freezing.
Avoid contact with skin, eyes and clothing. Keep working clothes separately. Wash hands immediately after work, if necessary take a shower. Remove soiled clothing immediately and clean thoroughly before using again. Garments that cannot be cleaned must be destroyed (burnt).
Exposure Controls / PPE
Occupational exposure limits, engineering controls, and protective equipment
Respiratory protection should only be used to control residual risk of short duration activities, when all reasonably practicable steps have been taken to reduce exposure at source e.g. containment and/or local extract ventilation.
Material: Nitrile rubber; Rate of permeability: > 480 min; Glove thickness: > 0.4 mm; Directive: Protective gloves complying with EN 374.
Wear goggles (conforming to EN166, Field of Use = 5 or equivalent).
Wear respirator with a particle filter mask (protection factor 4) conforming to European norm EN149FFP1 or equivalent.
Wear standard coveralls and Category 3 Type 5 suit. Wear two layers of clothing wherever possible. Polyester/cotton or cotton overalls should be worn under chemical protection suit and should be professionally laundered frequently.
Physical and Chemical Properties
Appearance, physical state, melting point, boiling point, and material characteristics
Stability and Reactivity
Chemical stability, hazardous reactions, and incompatible materials
Stable under recommended storage conditions.
Stable under normal conditions.
Reacts with galvanised steel or unlined mild steel to produce hydrogen, a highly flammable gas that could explode.
Extremes of temperature and direct sunlight.
Galvanised steel, Unlined mild steel Store only in the original container.
No decomposition products expected under normal conditions of use. Hazardous products of combustion: see section 5.
Ecological Information
Environmental toxicity, biodegradation, and bioaccumulation data
The data for this section has not been processed yet.
Disposal Considerations
Waste treatment methods, disposal recommendations, and waste codes
In accordance with current regulations and, if necessary, after consultation with the site operator and/or with the responsible authority, the product may be taken to a waste disposal site or incineration plant.
In accordance with current regulations and, if necessary, after consultation with the site operator and/or with the responsible authority, the product may be taken to a waste disposal site or incineration plant.
Waste Codes
Transport Information
UN numbers, shipping names, transport classes, and regulatory requirements
- UN Number
- 3077
- Shipping Name
- ENVIRONMENTALLY HAZARDOUS SUBSTANCE, SOLID, N.O.S. (GLYPHOSATE, AMMONIUM SALT MIXTURE)
- Transport Class
- 9
- Packing Group
- III
See sections 6 to 8 of this Safety Data Sheet.
See sections 6 to 8 of this Safety Data Sheet.
Regulatory Information
Chemical regulations, safety assessments, and compliance status
This material may be subject to some or all of the following regulations (and any subsequent amendments). Users must ensure that any uses and restrictions as indicated on the label and/or leaflet are followed.
Frequently Asked Questions
Common questions about safety, handling, and properties
What is the hazard signal word for ROUNDUP POWERMAX?
The signal word is no signal word.
What is the physical form of ROUNDUP POWERMAX?
ROUNDUP POWERMAX is a granules, free-flowing, free from foreign matter with light brown color. It has chemical odor.
What is the solubility of ROUNDUP POWERMAX?
soluble
What is ROUNDUP POWERMAX used for?
Herbicide
What are the hazard statements for ROUNDUP POWERMAX?
This substance has 1 hazard statement:
- H411: Toxic to aquatic life with long lasting effects.
What is the melting point of ROUNDUP POWERMAX?
The melting point is No data available and the boiling point is Not applicable.