STEPAN-MILD LSB/MB

Move to fresh air. Call a physician if symptoms develop or persist.

Wash off with soap and water. Get medical attention if irritation develops and persists.

Immediately flush eyes with plenty of water for at least 15 minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Get medical attention immediately.

Symptoms: Severe eye irritation. Symptoms may include stinging, tearing, redness, swelling, and blurred vision. Permanent eye damage including blindness could result.

Rinse mouth carefully. Get medical attention immediately.

Water fog. Dry chemical powder. Carbon dioxide (CO2). Large Fires: Extinguish with water fog.

Do not use water jet.

Fire may produce irritating, corrosive and/or toxic gases.

Move containers from fire area if you can do so without risk. Use standard firefighting procedures and consider the hazards of other involved materials.

For non-emergency personnel: Wear appropriate personal protective equipment. For emergency responders: Keep unnecessary personnel away.

Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual contamination.

Stop the flow of material, if this is without risk. Dike the spilled material, where this is possible. Absorb in vermiculite, dry sand or earth and place into containers. Following product recovery, flush area with water.

Avoid discharge into drains, water courses or onto the ground.

Following product recovery, flush area with water. Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual contamination.

Materials: vermiculite, dry sand or earth, absorbent material (e.g. cloth, fleece)

Do not get this material in contact with eyes. Avoid prolonged exposure. Provide adequate ventilation. Wear appropriate personal protective equipment. Observe good industrial hygiene practices.

Store in tightly closed original container in a dry, cool and well-ventilated place.

Observe good industrial hygiene practices.

Good general ventilation should be used. Ventilation rates should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation, or other engineering controls to maintain airborne levels below recommended exposure limits. If exposure limits have not been established, maintain airborne levels to an acceptable level. Provide eyewash station.

Wear appropriate chemical resistant gloves. PVC gloves are recommended.

Wear safety glasses with side shields (or goggles) and a face shield.

In case of insufficient ventilation, wear suitable respiratory equipment.

Wear suitable protective clothing.

Environmental manager must be informed of all major releases.

Material is stable under normal conditions.

The product is stable and non-reactive under normal conditions of use, storage and transport.

No dangerous reaction known under conditions of normal use.

Contact with incompatible materials. To avoid thermal decomposition, do not overheat.

Avoid contact with acids and alkalies. Oxidizing agents.

Sulphur Oxides (SOx). Carbon oxides. (COx)