PeCeFlux 2454 L/54% N.D.

Keep patient calm, remove to fresh air. If symptoms persist, seek medical advice.

After contact with skin, wash immediately with plenty of water and soap. Under no circumstances should organic solvent be used. If irritation develops, seek medical attention.

Wash affected eyes for at least 15 minutes under running water with eyelids held open, consult an eye specialist.

Immediately rinse mouth and then drink 200-300 ml of water, seek medical attention. Do not induce vomiting unless told to by a poison control center or doctor.

Foam, Water spray, Dry powder, Carbon dioxide (CO2)

water jet

If exposed to fire, keep containers cool by spraying with water.

Avoid breathing dust/ fume/ gas/ mist/ vapors/ spray. Handle in accordance with good building materials hygiene and safety practice.

Contain contaminated water/firefighting water. Do not discharge into drains/surface waters/groundwater.

Pick up with suitable appliance and dispose of.

Smoking, eating and drinking should be prohibited in the application area. For personal protection see section 8.

Keep only in the original container in a cool, dry, well-ventilated place away from ignition sources, heat or flame. Protect from direct sunlight.

When using, do not eat, drink or smoke. Hands and/or face should be washed before breaks and at the end of the shift. At the end of the shift the skin should be cleaned and skin-care agents applied. Gloves must be inspected regularly and prior to each use. Replace if necessary (e.g. pinhole leaks).

Normal measures for preventive fire protection.

The selected protective gloves have to satisfy the specifications of Regulation (EU) 2016/425 and the standard EN 374 derived from it. The break through time depends amongst other things from the material, the thickness and the type of glove and therefore has to be measured for each case. Suitable materials also with prolonged, direct contact (Recommended: Protective index 6, corresponding > 480 minutes of permeation time according to EN 374): butyl rubber (butyl) - 0.7 mm coating thickness nitrile rubber (NBR) - 0.4 mm coating thickness chloroprene rubber (CR) - 0.5 mm coating thickness Manufacturer's directions for use should be observed because of great diversity of types.

Safety glasses with side-shields (frame goggles) (e.g. EN 166)

Wear respiratory protection if ventilation is inadequate. Combination filter for gases/vapours of organic, inorganic, acid inorganic and alkaline compounds (e.g. EN 14387 Type ABEK).

Body protection must be chosen based on level of activity and exposure.

No decomposition if stored and applied as directed.

No decomposition if stored and applied as directed.

Stable under recommended storage conditions. No hazards to be specially mentioned.

See SDS section 7 - Handling and storage.

Strong acids, Strong bases, Strong oxidizing agents, Strong reducing agents

No hazardous decomposition products if stored and handled as prescribed/indicated.

Observe national and local legal requirements. Residues should be disposed of in the same manner as the substance/product.

Residues should be disposed of in the same manner as the substance/product.