PFINDER AP 759

Supply fresh air. If required, provide artificial respiration. Keep patient warm. Consult doctor if symptoms persist. In case of unconsciousness place patient stably in side position for transportation. In case of inhalation of aerosols remove the casualty into fresh air and seek medical advice.

Immediately wash with water and soap and rinse thoroughly. If skin irritation continues, consult a doctor.

Rinse opened eye for several minutes under running water.

Do not induce vomiting; call for medical help immediately.

Symptoms: If swallowed or in the event of vomiting may cause aspiration into the lungs which can be fatal.

Foam, dry powder, carbon dioxide, water spray jet

Water with full jet

Fire gas of organic material has to be classed invariably as respiratory poison. Vapours are heavier than air and spread on ground. Product possibly swims up on surface and reinflames.

Cool endangered receptacles with water spray.

Wear protective equipment. Keep unprotected persons away.

Do not allow to enter sewers/ surface or ground water. Do not allow to penetrate the ground/soil.

Absorb with liquid-binding material

Materials: sand, diatomite, acid binders, universal binders, sawdust

Ensure good ventilation/exhaustion at the workplace. Prevent formation of aerosols. Use solvent-proof equipment. Use only in well ventilated areas. Ensure good interior ventilation, especially at floor level. (Fumes are heavier than air). Tightly reclose container after each use. Keep away from sources of ignition - No smoking. Avoid contact with eyes and skin.

Store in a cool location. Store in cool, dry conditions in well sealed receptacles. Store receptacle in a well ventilated area.

Avoid contact with eyes and skin.

Keep ignition sources away - Do not smoke. Protect against electrostatic charges.

The glove material has to be impermeable and resistant to the product/ the substance/ the preparation. Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation. Solvent resistant gloves. Material of gloves: The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the application. Recommended thickness of the material: >= 0,7 mm. Permeation time >= 480 minutes. Nitrile rubber, NBR. Penetration time of glove material: The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed.

Tightly sealed goggles

Use suitable respiratory protective device in case of insufficient ventilation. Breathing apparatus in the event of aerosol or mist formation. In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure use self-contained respiratory protective device. Gas filter type A (organic gases and vapours).

Protective work clothing

No dangerous reactions known.

Flames, sparks, heat.

Strong oxidizing agents

No dangerous decomposition products known.